TLC352
LinCMOS DUAL DIFFERENTIAL COMPARATOR
SLCS016 ± SEPTEMBER 1985 ± REVISED OCTOBER 1990
D D
Singleor Dual-Supply Operation
Wide Range of Supply Voltages
1.5 V to 18 V
TLC352C, TLC352I . . . D OR P PACKAGE
TLC352M . . . JG PACKAGE
(TOP VIEW)
DVery Low Supply Current Drain 150 μA Typ at 5 V
65 μA Typ at 1.4 V
DBuilt-In ESD Protection
DHigh Input Impedance . . . 1012 Ω Typ
DExtremely Low Input Bias Current 5 pA Typ
DUltrastable Low Input Offset Voltage
DInput Offset Voltage Change at Worst-Case Input Conditions Typically 0.23 μV/ Month,
Including the First 30 Days
DCommon-Mode Input Voltage Range Includes Ground
DOutputs Compatible With TTL, MOS, and CMOS
DPin-Compatible With LM393
description
This device is fabricated using LinCMOS technology and consists of two independent voltage comparators, each designed to operate from a single power supply. Operation from dual supplies is also possible if the difference between the two supplies is 1.4 V to 18 V. Each device features extremely high input impedance (typically greater than 1012 Ω), which allows direct interface to high-impedance sources. The output are n-channel open-drain configurations and can be connected to achieve positive-logic wired-AND relationships. The capability of the TLC352 to operate from 1.4-V supply makes this device ideal for low-voltage battery applications.
1OUT |
|
1 |
8 |
|
VDD |
|
|
||||
1IN± |
|
|
|
|
|
|
2 |
7 |
|
2OUT |
|
1IN+ |
|
3 |
6 |
|
2IN± |
|
|
||||
GND |
|
4 |
5 |
|
2IN+ |
|
|
||||
|
|
|
|
|
|
|
|
|
|
|
|
TLC352M . . . FK PACKAGE
(TOP VIEW)
|
NC |
1OUT |
NC |
DD |
NC |
|
|
V |
|
||||
NC |
3 |
2 |
1 |
20 19 |
NC |
|
4 |
|
|
|
18 |
||
1IN± |
5 |
|
|
|
17 |
2OUT |
NC |
6 |
|
|
|
16 |
NC |
1IN+ |
7 |
|
|
|
15 |
2IN± |
NC |
8 |
|
|
|
14 |
NC |
|
9 |
10 11 12 13 |
|
|||
|
NC |
GND |
NC |
2IN+ |
NC |
|
NC Ð No Internal connection
symbol (each comparator)
IN+
OUT
IN±
The TLC352 has internal electrostatic discharge (ESD) protection circuits and has been classified with a 2000-V ESD rating tested under MIL-STD-883C, Method 3015. However, care should be exercised in handling this device as exposure to ESD may result in degradation of the device parametric performance.
The TLC352C is characterized for operation from 0°C to 70°C. The TLC352I is characterized for operation over the industrial temperature range of ± 40°C to 85°C. The TLC352M is characterized for operation over the full military temperature range ± 55°C to 125°C.
LinCMOS is a trademark of Texas Instruments Incorporated.
PRODUCTION DATA information is current as of publication date. Products conform to specifications per the terms of Texas Instruments standard warranty. Production processing does not necessarily include testing of all parameters.
Copyright 1990, Texas Instruments Incorporated
POST OFFICE BOX 655303 •DALLAS, TEXAS 75265 |
1 |
TLC352
LinCMOS DUAL DIFFERENTIAL COMPARATOR
SLCS016 ± SEPTEMBER 1985 ± REVISED OCTOBER 1990
AVAILABLE OPTIONS
|
VIO max |
|
PACKAGE |
|
||
TA |
|
|
|
|
||
SMALL-OUTLINE |
CHIP-CARRIER |
CERAMIC DIP |
PLASTIC DIP |
|||
AT 25°C |
||||||
|
|
(D) |
(FK) |
(JG) |
(P) |
|
0°C to 70°C |
5 mV |
TLC352CD |
Ð |
Ð |
TLC352CP |
|
|
|
|
|
|
|
|
± 40°C to 85°C |
5 mV |
TLC352ID |
Ð |
Ð |
TLC352IP |
|
|
|
|
|
|
|
|
± 55°C to 125°C |
5 mV |
Ð |
TLC352MFK |
TLC352MJG |
Ð |
|
|
|
|
|
|
|
The D packages are available taped and reeled. Add R suffix to device type (e.g., TLC352 CDR).
equivalent schematic (each comparator)
Common to All Channels
VDD |
|
|
OUT |
GND |
|
IN+ |
IN± |
2 |
POST OFFICE BOX 655303 •DALLAS, TEXAS 75265 |
TLC352
LinCMOS DUAL DIFFERENTIAL COMPARATOR
SLCS016 ± SEPTEMBER 1985 ± REVISED OCTOBER 1990
absolute maximum ratings over operating free-air temperature range (unless otherwise noted)²
Supply voltage, VDD (see Note 1) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . |
. . . . . . . . . . . |
. . . . . . . . . . 18 |
V |
Differential input voltage, VID (see Note 2) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . |
. . . . . . . . . . . . |
. . . . . . . ± 18 |
V |
Input voltage, VI . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . |
. . . . . . . . . . . . |
. . . . . . . . . VDD |
|
Input voltage range, VI . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . |
. . . . . . . . . . . . |
± 0.3 V to 18 |
V |
Output voltage, VO . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . |
. . . . . . . . . . . . |
. . . . . . . . . 18 |
V |
Input current, II . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . |
. . . . . . . . . . . . |
. . . . . . . ± 5 mA |
|
Output current, IO . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . |
. . . . . . . . . . . . |
. . . . . . . 20 mA |
|
Duration of output short circuit to ground (see Note 3) . . . . . . . . . . . . . . . . . . . . . |
. . . . . . . . . . . . |
. . . . . unlimited |
|
Continuous total dissipation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . |
See Dissipation Rating Table |
||
Operating free-air temperature range, TA TLC352C . . . . . . . . . . . . . . . . . . . . . . . |
. . . . . . . . . . . . |
. . 0°C to 70°C |
|
TLC352I . . . . . . . . . . . . . . . . . . . . . . . . |
. . . . . . . . . . . . |
± 40°C to 85°C |
|
TLC352M . . . . . . . . . . . . . . . . . . . . . . . |
. . . . . . . . . . |
± 55°C to 125°C |
|
Storage temperature range . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . |
. . . . . . . . . . |
± 65°C to 150°C |
|
Case temperature for 60 seconds: FK package . . . . . . . . . . . . . . . . . . . . . . . . . . . |
. . . . . . . . . . . . |
. . . . . . . 260°C |
|
Lead temperature 1,6 mm (1/16 inch) from case for 60 seconds: JG package . |
. . . . . . . . . . . . |
. . . . . . . 300°C |
|
Lead temperature 1,6 mm (1/16 inch) from case for 10 seconds: D or P package . . . . . . . . . . |
. . . . . . . 260°C |
² Stresses beyond those listed under ªabsolute maximum ratingsº may cause permanent damage to the device. These are stress ratings only, and functional operation of the device at these or any other conditions beyond those indicated under ªrecommended operating conditionsº is not implied. Exposure to absolute-maximum-rated conditions for extended periods may affect device reliability.
NOTES: 1. All voltage values except differential voltages are with respect to the network ground.
2.Differential voltages are at IN+ with respect to IN ±.
3.Short circuits from outputs to VDD can cause excessive heating and eventual device destruction.
DISSIPATION RATING TABLE
PACKAGE |
TA ≤ 25°C |
DERATING |
DERATE |
TA = 70°C |
TA = 85°C |
TA = 125°C |
|
POWER RATING |
FACTOR |
ABOVE TA |
POWER RATING |
POWER RATING |
POWER RATING |
||
|
|||||||
D |
500 mW |
5.8 mW/°C |
64°C |
464 mW |
377 mW |
N/A |
|
FK |
500 mW |
11.0 mW/°C |
104°C |
500 mW |
500 mW |
275 mW |
|
JG |
500 mW |
8.4 mW/°C |
90°C |
500 mW |
500 mW |
210 mW |
|
P |
500 mW |
N/A |
N/A |
500 mW |
500 mW |
N/A |
|
|
|
|
|
|
|
|
POST OFFICE BOX 655303 •DALLAS, TEXAS 75265 |
3 |