KIP 3000 Installation Checklist |
R4 Pg. |
|
1 |
Pre-Installation / Site survey. Contact Client (end user) prior to installation:
•Confirm power 120 VAC - 15 amp dedicated
•Confirm network jack ( RJ-45 ) and cables (length)
•Request a network IP Address for the system
•System arrival date?
•Is the copier still on the skid? If yes, who may assist to remove? (Fork truck, moving company )
•Media ( at least one 500 ft roll )
•Adequate space for printer installation and maintenance? ( see install Specs )
Hardware (approx. 1 hour)
STEP: 1 Check for all required system items. (guides, touch panel, toner, etc)
STEP: 2. Check the space requirements.
STEP: 3 Check for correct power and network jacks. (inform client if incorrect at this time)
STEP: 4 Ask for network connection assistance.
•Schedule network administrators time and ask for this information now, as it may take several hours to obtain the IP Address dependent on company.
STEP: 5 Install Copier
•See printer installation section of the service manual.
•Print simple test patterns from engine, no calibration at this time.
STEP: 6 Enter Key Codes into IPS
•Enter the Key Codes if applicable from the document provided with the system. (See the
“Help / Configuration Section” in the User Guide CD)
Software (approx. 2 hours)
STEP: 7 Test Scan and Copy.
•Perform a quick test for function of copy and scan modes.
STEP: 8 Options - Network the KIP3000. (enter IP Address)
•Connect network cable
•See the “KIP 3000 Connectivity Document” supplied with the KIP 3000.
STEP: 9 OptionsInstall Windows Driver, Request, and AutoCAD etc.
•Please show the administrator this procedure and show the user guide at this time for future reference.
•Print from Request, Windows App and ACAD.
•Set correct time, time zone and date on controller for proper sleep mode function from
Request – VNC.
•Retrieve the scan performed above in Request.
Loading...