Installation and Care Guide
Two-Valve and Three-Valve Wall-Mount
Bath/Shower Fitting
K-302 |
|
K-303 |
K-6934
M product numbers are for Mexico (i.e. K-12345M) Los números de productos seguidos de
M corresponden a México (Ej. K-12345M)
Français, page “Français-1” Español, página “Español-1”
1205552-2-A
Tools and Materials
Before You Begin
Please read all instructions before you begin.
Observe all local plumbing and building codes.
Shut off the main water supply.
Do not remove the plaster guards until instructed to.
Before installation, unpack the components and inspect them for damage. Return the components to the carton until you are ready to install.
1205552-2-A |
2 |
Kohler Co. |
|
6' (1829 mm) |
|||
|
To Floor Typical |
|||
2-1/4" (57 mm) Min |
|
|
|
|
3" (76 mm) Max |
|
|
|
|
4" (102 mm) |
1/2" NPT Tap |
48" (1219 mm) |
||
|
||||
2-1/4" |
|
|
To Floor |
|
(57 mm) |
|
|
(Shower Only) |
|
1/2" NPT or |
|
|
|
|
1/2" Copper |
1/2" NPT |
8" (293 mm) Typical |
||
1/2" NPT Hot |
||||
Cold |
4" (102 mm) (Bath Only) |
|||
1/2" NPT Tap |
|
|
|
|
Top of Rim |
|
4" (102 mm) Typical |
||
|
|
|
||
|
6' (1829 mm) |
|
||
|
To Floor Typical |
|||
2-1/4" (57 mm) Min |
|
|
|
|
3" (76 mm) Max |
|
|
|
|
4" (102 mm) |
1/2" NPT Tap |
48" (1219 mm) |
||
|
|
|||
2-1/4" |
|
|
To Floor |
|
(57 mm) |
|
|
(Shower Only) |
|
1/2" NPT or |
|
|
|
|
1/2" Copper |
1/2" NPT |
8" (293 mm) Typical |
||
|
||||
1/2" NPT Hot |
Cold |
4" (102 mm) (Bath Only) |
||
1/2" NPT Tap |
|
|
|
|
Top of Rim |
|
4" (102 mm) Typical |
||
|
|
|
||
Rough-In |
|
|
|
|
Kohler Co. |
3 |
|
1205552-2-A |
|
Temporary |
Yoke |
Elbow |
Nipple |
|
|
|
|
1/2" Copper |
1/2" |
|
|
|
Tubing |
|
Stop |
|
|
Threaded |
|
||
|
|
|
||
|
|
Pipe |
|
Valve |
|
Adapters |
Union |
1/2" |
1/2" |
|
|
|
||
|
|
|
Sweat |
|
|
|
|
Piping |
|
|
|
|
Copper |
|
|
1/2" Copper |
|
|
|
|
|
Union |
|
|
|
Tubing |
|
1/2" Copper |
|
|
|
|
||
Elbow |
Temporary |
1/2" |
Tubing |
|
|
|
|||
|
Nipple |
|
|
|
|
Piping |
|
||
|
|
|
||
1. Bath and Shower Installation
NOTE: Typical dimensions for bath and shower installations are shown on the rough-in diagram.
NOTE: Refer to the trim installations instructions for specific requirements.
NOTE: Refer to the handle installation instructions for possible rough-in depth requirements.
NOTE: The faucet fitting is factory assembled for hot and cold water.
Unless otherwise instructed, rough-in the supply yoke 2-1/4″ (57 mm) minimum to 3″ (76 mm) maximum from the centerline of the yoke to the outside of the finished wall.
Install 1/2″ hot and cold supply tubing.
If specified, install the screwdriver stop valves.
NOTE: The three-valve yokes have no embossed graphics for the showerhead and spout locations.
1205552-2-A |
4 |
Kohler Co. |
|
Ceiling |
|
|
Shower |
Temporary |
|
|
|
Ell |
||
|
|
|
Nipple |
||
|
Supplies |
|
|
||
|
|
|
|
||
|
|
|
|
|
|
|
Aspirator |
Cold |
Adapters |
|
1/2" |
|
|
|
|
||
Hot |
|
|
for |
|
Copper |
|
|
Copper |
|
Tubing |
|
|
|
|
|
||
|
|
|
Tubing |
|
|
|
|
|
|
|
Temporary |
|
|
|
Bath |
|
Nipple |
|
|
|
|
|
|
Thread |
Valve Unit |
Ell |
|
|
|
|
|
|
|||
Protector |
|
|
|
|
|
2. Complete the Bath and Shower Installation
For Ceiling Installations
NOTE: Do not use a three-valve yoke with ceiling supplies.
Turn the yoke over to allow the supplies to connect from the top of the yoke.
Remove the aspirator with a 3/8″ hex wrench and reinstall it in the top of the yoke. Do not overtighten.
NOTE: Reversing the yoke for ceiling supplies will reverse the direction in which the lever handles close.
For proper lever handle operation, open the valves and remove and reverse the ceramic valves.
Make sure the valves are not dirty or damaged.
Wrench tighten the valves.
For All Installations
Install copper tubing and adapters between the yoke and shower ell.
Install copper tubing and adapters between the yoke and bath ell.
Secure the tubing to the framing.
Install temporary 1/2″ nipples into the shower and bath ells.
Kohler Co. |
5 |
1205552-2-A |
72"
(1829 mm) To Floor
24"
(610 mm)
Plug
3. Shower Only Installations
NOTE: Shower only installations require two-valve yokes.
NOTE: Typical dimensions for bath and shower installations are shown on the rough-in diagram.
NOTE: Refer to the trim installation instructions for specific requirements.
NOTE: Refer to the handle installation instructions for possible rough-in depth requirements.
Unless otherwise instructed, rough-in the supply yoke 2-1/4″ (57 mm) minimum to 3″ (76 mm) maximum from the centerline of the yoke to the outside of the finished wall.
Install 1/2″ hot and cold supply tubing.
If specified, install the screwdriver stop valves.
Using a 3/8″ hex wrench, remove the aspirator from the yoke and discard.
Install a plug in the spout pipe opening.
1205552-2-A |
6 |
Kohler Co. |
Plug
4"
(102 mm)
Temporary
Nipple
4. Bath Only Installations
NOTE: Bath only installations require two-valve yokes.
NOTE: Typical dimensions for bath and shower installations are shown on the rough-in diagram.
NOTE: Refer to the trim installation instructions for specific requirements.
Unless otherwise instructed, rough-in the supply yoke 2-1/4″ (57 mm) minimum to 3″ (76 mm) maximum from the centerline of the yoke to the outside of the finished wall.
Install 1/2″ hot and cold supply tubing.
If specified, install the screwdriver stop valves.
NOTE: Three-valve yokes have no embossed graphics for the showerhead and spout locations.
Using a 3/8″ hex wrench, remove the aspirator from the yoke and discard.
Install a plug in the showerhead pipe opening.
Warranty
KOHLER® Faucet Lifetime Limited Warranty
Kohler Co. warrants its Faucets* manufactured after January 1, 1997, to be leak and drip free during normal residential use for as long as the original consumer purchaser owns his or her home. If the Faucet
Kohler Co. |
7 |
1205552-2-A |
Warranty (cont.)
should leak or drip during normal use, Kohler Co. will, free of charge, mail to the purchaser the cartridge necessary to put the Faucet in good working condition. This warranty applies only to Kohler Faucets installed in the United States of America, Canada or Mexico (″North America″).
Kohler Co. also warrants all other aspects of the faucet or accessories (″Faucet″)*, (except gold, non-Vibrant®, non-chrome finishes) to be free of defects in material and workmanship during normal residential use for as long as the original consumer purchaser owns his or her home. This warranty applies only to Kohler Faucets installed in North America. If a defect is found in normal residential use, Kohler Co. will, at its election, repair, provide a replacement part or product, or make appropriate adjustment. Damage to a product caused by accident, misuse, or abuse is not covered by this warranty. Improper care and cleaning will void the warranty**. Proof of purchase (original sales receipt) must be provided to Kohler Co. with all warranty claims. Kohler Co. is not responsible for labor charges, installation, or other incidental or consequential costs. In no event shall the liability of Kohler Co. exceed the purchase price of the Faucet.
If the Faucet is used commercially or is installed outside of North America, or if the finish is gold, non-Vibrant or a painted or powder coated color finish, Kohler Co. warrants the Faucet to be free from defects in material and workmanship for one (1) year from the date the product is installed, under Kohler Co.’s standard one-year limited warranty.
If you believe that you have a warranty claim, contact Kohler Co., either through your Dealer, Plumbing Contractor, Home Center or E-tailer, or by writing Kohler Co., Attn.: Customer Care Center, 444 Highland Drive, Kohler, WI 53044, USA. Please be sure to provide all pertinent information regarding your claim, including a complete description of the problem, the product, model number, color, finish, the date the product was purchased and from whom the product was purchased. Also include your original invoice. For other information, or to obtain the name and address of the service and repair facility nearest you, call 1-800-4-KOHLER (1-800-456-4537) from within the USA and Canada, and 001-800-456-4537 from within Mexico, or visit www.kohler.com within the USA, www.ca.kohler.com from within Canada, or www.mx.kohler.com in Mexico.
KOHLER CO. AND/OR SELLER ARE PROVIDING THESE WARRANTIES IN LIEU OF ALL OTHER WARRANTIES, EXPRESSED OR IMPLIED, INCLUDING BUT NOT LIMITED TO THE IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. KOHLER CO. AND/OR
1205552-2-A |
8 |
Kohler Co. |
Warranty (cont.)
SELLER DISCLAIM ALL LIABILITY FOR SPECIAL, INCIDENTAL OR CONSEQUENTIAL DAMAGES. Some states/provinces do not allow limitations of how long an implied warranty lasts or the exclusion or limitation of such damages, so these limitations and exclusions may not apply to you. This warranty gives the consumer specific legal rights. You may also have other rights that vary from state/province to state/province.
This is Kohler Co.’s exclusive written warranty.
*Trend® faucets, MasterShower® tower, BodySpa systems and components; WaterHaven® tower, systems and components; Tripoint® faucets, Polished Gold, non-Vibrant and painted or powder coated finishes, fittings; all items within the ″Fixture Related″ section of the Kohler Faucets Price Book, drains, Duostrainer® sink strainers, soap/lotion dispensers, MoxieTM Wireless Speaker; and faucets used in commercial settings, and outside North America, are covered by Kohler Co.’s one-year limited warranty.
**Never use cleaners containing abrasive cleansers, ammonia, bleach, acids, waxes, alcohol, solvents or other products not recommended for chrome. This will void the warranty.
Kohler Co. |
9 |
1205552-2-A |
Loading...