96M12094
Precautions for handling
FU-A40/FU-A100
•The brightness of the respective optical axes are not equal due to the product features.
It is normal, so please use these products as they are intended.
•Two (2) holes that are located as shown in the
figure on the right are mouths for filling resin to be used in the production process.
• When fiber wires stick out from a fiber sheath, |
Sheath |
Wire |
||||||
cut the wires with an enclosed fiber cutter |
||||||||
|
|
|
|
|
|
|
||
|
|
|
|
|
|
|
||
before connecting to a fiber amplifier. |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
•The enclosure rating of these products is IP67. Please note that if liquid, except for water, that decomposes a fiber sheath (polyethylene) or fiber wires (acrylic resin) adheres to these, the amount of light received may reduce.
•Recommended tightening torque is 0.75 N•m.
1052-1