VTC-TNT2HR3F2
VTC-TNT2HR4F2 VTC-TNT2HR4M2
3.0 & 4.0 Megapixel Indoor/
Outdoor WDR IP IR Cameras
QUICK START GUIDE
FEATURES
• 1/3” Megapixel Progressive Scan CMOS image sensor
• Up to 30fps live view
• Motorized 3.3-12mm (VTC-TNT2HR4M2 ) & 3.6mm or 2.8mm
|
Fixed Iris (VTC-TNT2HR3F2 & VTC-TNT2HR4F2) Lens Options |
• |
2 High Power Infrared LED’s |
• |
120dB Super Wide Dynamic Range (WDR) |
• |
True Mechanical Day/Night function by ICR |
• |
XD-DNR (2D-DNR & 3D-DNR) Noise Reduction |
• |
On Board Motion Detection |
• |
H.265/H.264/MJPEG Triple Streaming |
• |
Secondary Video Output (CVBS) |
• Remote Viewing via CMS, Internet Explorer, and iOS & Android |
|
|
Apps |
VITEK• Minimal Latency with up to 10 simultaneous user connections |
|
• ONVIF Compliant |
|
• IP66 Weather Resistance |
|
• Optional Junction Box Mount Available (VT-TJB01)
• 12VDC & PoE (Power over Ethernet) Operation
PLEASE NOTE:
Complete User Guide, Software, Tools, and Updates are available online. Scan the QR Code or visit: http://www.vitekcctv.com/Downloads
Components and Accessories
Camera |
Drill Template |
Quick Guide |
Rubber Plug |
Screws |
Waterproof Cap |
Hex Wrench |
|
Overview
This camera series supports both fixed and varifocal lenses. Please note that the zoom and focus features mentioned below are not features of the fixed lens version.
2
3
4
5
1
|
1 |
Lens |
4 |
Audio Input |
|
|
2 |
RJ-45 Ethernet |
5 |
Power Input |
|
|
3 |
CVBS Output |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
2
Network Cable & Power Connections
First connect the Waterproof Cap to an Ethernet patch cable, then connect the cameras ethernet adaptor. If not powering the camera with PoE, also connect the power Cable to an approved 12VDC Power Supply.
Network Cable
12VDC
Optional 12VDC
Power Connection.
Not needed with PoE
Weather Resistant Network Coupler
1.Loosen the nut from the Weather Resistant Network Coupler,
2.Run ethernet cable through coupler, then attach a RJ-45 connector.
3.Tighten the nut and coupler for a weather resistant seal.
3
Loading...