IMPORTANT
Notice the following information will help you solve your problems. Keep this IMPORTANT sheet together with the INSTRUCTIONS book.
•After installing the unit.
=Follow the procedure Å described below.
•If the unit does not operate.
=Follow the procedure Å described below.
•If a CD is not ejected from the loading slot.
=Follow the procedure ı described below. (If the procedure ı does not work, try the procedure Å.)
•If a CD is not recognized (“NO DISC” appears on the display) even though there is a CD in the loading slot.
=Follow the procedure ı described below. (If the procedure ı does not work, try the procedure Å.)
•If a CD is in the unit, it will eject when you reset the unit. Pay attention not to drop the CD.
ÅTo reset the microcomputer
Press and hold both the SELECT (SEL) and POWER/ATT() buttons at the same time for several seconds.
This will reset the built-in microcomputer.
NOTE: Your preset adjustments — such as preset channels or sound adjustments
— will also be erased.
POWER/ATT
()
SELECT(SEL)
ı To eject a CD by force
Press and hold both the POWER/ATT() and EJECT(0) buttons at the same time for several seconds until the CD is ejected from the loading slot.
POWER/ATT
( )
EJECT(0)
FSUD3103-001A