Operator’s manual
PORTABLE CD PLAYER WITH ANTI-SHOCK (45 SEC.)
PD-X2240
Operator’s manual |
1-15 |
LOCATION OF CONTROLS
PROGRAM |
STOP BUTTON |
LCD DISPLAY |
(power off) |
|
|
ANTI-SKIP (ESP) |
|
CD MODE |
|
CD SKIP |
|
DC IN 4.5V
ADAPTER JACK
LINE OUT JACK
PHONES JACK
RECHARGE INDICATOR
VOLUME CONTROL
BASS BOOST
HOLD
RECHARGE SWITCH
CONTROL OPERATION AND FUNCTION POWER SUPPLY
Your CD player requires 2 size “AA” alkaline batteries (not include), or use the AC adapter
AC ADAPTER OPERATION
Plug one end of the AC adapter into the DC 4.5V jack, then plug the other end into AC wall outlet.
PRECAUTIONS ON USING THE AC ADAPTER
Don’t touch the AC adapter with wet hands. Doing so is dangerous, as this could result in an electric shock.
If the adapter plug is insert into the DC Jack of the Player, the power supply automatically switch to the AC/DC power and the batteries supply will be disconnected.
DC OPERATION
ALKALINE BATTERY INSTALLATION (NOT SUPPLIED)
Insert two AA batteries (not supplied) into the battery compartment on the bottom of the unit. Be sure to observe the proper polarity.
NOTE ON ALKALINE BATTERIES
1.When replacing the alkaline batteries, use two new batteries of the same type. Do not mix a used battery with a new one or mix different types of batteries.
2.When inserting the batteries, be sure to place the batteries as the sketch shown, mistakenly inserting even one with improper polarity will cause leakage.
3.When not use the unit for an extended period of time, or not use the batteries for a long time, remove them to prevent possible acid leakage or corrosion resulting in damage to your player or personal injury such as skin burns.
4.Bear in mind that battery life expectancy is based upon playing mode. Maximum battery power consumption happens at maximum settings. If sound gets distorted or if the unit fails to switch tracks, your batteries are weak. Replace both batteries, or use AC adaptor.
5.Never charge, heat, disassemble, or throw batteries into a fire.
1
6.If the display shows the symbol “ 
”, this means your batteries are weak, replace them or use the AC adaptor.
7.If the display is blank - no numbers show when power is turned on, the batteries are dead.
Replace them or use the AC adapter.
CHARGING AND USE OF RECHARGEABLE BATTERIES
This unit can fully recharge the specified rechargeable batteries, in approximately 15 hours. The rechargeable batteries (NOT supplied) should be recharged before they are used for the first time or they have not been used for a long period of time because they are low in power (over 60 days).
1.Open the battery compartment cover and insert two of the recommended rechargeable batteries, matching polarity. (1.2V 650mA).
ALL BATTERIES MUST BE OF RECHARGEABLE NICKEL-CADMIUM TYPE, OTHERWISE THE BATTERIES MAY EXPLODE OR LEAK.
2.Plug in the AC ADAPTOR.
3.Slide the charge switch to CHARGE position to start charging. USE ONLY THE AC ADAPTOR FOR CHARGING.
4.After 15 hours, please unplug the AC ADAPTOR and slide the recharge switch to normal position.
DO NOT CHARGE CONTINUOUSLY FOR 24 HOURS OR MORE. DOING SO
CAN CAUSE THE PERFORMANCE OF THE RECHARGEABLE BATTERIES TO DETERIORATE.
NOTE: You may play DISC’S whilst charging the batteries.
If the operating time decreases drastically even when the rechargeable nickel-cad- mium batteries are properly recharged, purchase a new set of rechargeable nickelcadmium batteries. When charging for the first time or after a long time, playing time may be reduced. In this case, charge and discharge the batteries several times.
AUTO POWER ON FUNCTION
The power turns on automatically when the PLAY/PAUSE button is pressed.
AUTO POWER OFF FUNCTION
The power turns off immediately after the disc compartment is opened.
When all the tracks on a disc have been played, or the Stop button is pressed, the power turns off automatically within 60 seconds if no button is pressed.
If you pressed the Stop button twice the power will turn off
THE HOLD FUNCTION
It is useful during playing, the function will lock the key on the panel to protect the mistake in the Playing.
During playing slide the HOLD switch to “ON” position, the “HOLD” will appears in the display, the key on the panel will be locked, the panel key is disable.
Slide the HOLD Switch to “OFF” position to stop the function.
LISTENING WITH HEADPHONE (EARPHONE)
Connect the plug of the stereo headphone (earphone) into the headphone jack (marked phones) before use the unit.
CAUTION: Hearing experts advise against exposure to continuous extended play at loud volume levels while using headphone (earphone), possible hearing loss may result. If you experience a ringing in the ears, reduce volume or discontinue use. We want you listening for a life time.
2
Loading...