Stereo Headphones
Operating Instructions
Mode d’emploi
Manual de instrucciones
MDR-X05
How to use / Utilisation / Utilización
*There is a tactile dot beside Volume +.
*Vous pouvez remarquer un point tactile à côté de Volume +.
*Hay un punto táctil al lado de Volumen +.
Volume +*
Volume +*
Volumen +*
Center button Touche centrale Botón central
Volume –
Volume –
Volumen –
Microphone
Micro
Micrófono
English |
|
Stereo headphones |
Features
Easy-to-use remote control (only for iPod, iPhone & iPad)
40 mm driver units reproduce natural and powerful bass sound.
Advanced Direct Vibe Structure provides acoustically tight seal, realizing superior sound isolation and deep bass sound. Optimized diaphragm front chamber for more expansive and clearer mid-range sound.
Seamless earpads with pressure-relieving cushions provide ultimate wearing comfort, and a tight seal for superior sound isolation and deep bass sound.
Soft head cushion provides long-term listening comfort.
Multi-folding design for optimum portability.
Tangle-free serrated cord
Tiny serrations on the flat cord reduce tangling caused by friction.
©2012 Sony Corporation Printed in China
4-450-456-13(1)
Using the Center button
Plays/pauses a track of the connected iPod product with a single press. Skips to the next track with a double press. Skips to the previous track with a triple press. Starts the “VoiceOver*” feature with a long press (if available).
Press once to answer the call. Press again to end. Hold down for about two seconds to reject an incoming call. When you let go, two low beeps confirm the call was rejected.
*Availability of the “VoiceOver” feature depends on iPod and its software version.
Note
Be careful not to unintentionally press any buttons when you carry your iPod with this unit connected.
Specifications
Headphones
Type: Closed, dynamic / Driver unit: 40 mm, dome type (CCAW Voice Coil) / Power handling capacity: 1,000 mW (IEC*) / Impedance: 40 Ω at 1 kHz / Sensitivity: 104 dB/mW / Frequency
response: 4 Hz – 24,000 Hz / Cord: 1.2 m (47 1/4 in), Y-type / Plug: Four-conductor gold-plated L- shaped stereo mini plug for iPod/iPhone/iPad with remote function / Mass: Approx. 235 g (8.29 oz) without cord
Microphone
Open circuit voltage level: – 42 dB (0 dB=1 V/Pa)
Supplied accessory
Carrying pouch (1)
* IEC = International Electrotechnical Commission Design and specifications are subject to change without notice.
Precautions
High volume may affect your hearing. For traffic safety, do not use while driving or cycling.
Because the headphones are of a high density enclosure, forcing them against your ears may result in eardrum damage. Avoid using the headphones where they are liable to be struck by people or other objects, such as a ball, etc. Pressing the headphones against your ears may produce a diaphragm click sound. This is not a malfunction.
You are cautioned that any changes or modifications not expressly approved in this manual could void your authority to operate this equipment.
The validity of the CE marking is restricted to only those countries where it is legally enforced, mainly in the countries EEA (European Economic Area).
Optional replacement earpads can be ordered from your nearest authorized Sony retailer or www.sony.com.
Compatible iPod/iPhone/iPad models
You can use the unit with only the following models supporting remote control. Update your iPod, iPhone or iPad to the latest software before use. In the Operating Instructions, iPod, iPhone and iPad are collectively described as “iPod” except in special cases.
iPod touch (5th generation)
iPod touch (4th generation)
iPod touch (3rd generation)
iPod touch (2nd generation)
iPod nano (7th generation)
iPod nano (6th generation)
iPod nano (5th generation)
iPod nano (4th generation)
iPod classic 120GB 160GB (2009)
iPod shuffle (4th generation)
iPod shuffle (3rd generation)
iPhone 5
iPhone 4S
iPhone 4
iPhone 3GS
iPad (4th generation)
iPad (3rd generation)
iPad 2
iPad
iPad mini
On copyright
iPad, iPhone, iPod, iPod classic, iPod nano, iPod shuffle, and iPod touch are trademarks of Apple Inc., registered in the U.S. and other countries.
“Made for iPod,”“Made for iPhone,” and “Made for iPad” mean that an electronic accessory has been designed to connect specifically to iPod, iPhone or iPad, respectively, and has been certified by the developer to meet Apple performance standards. Apple is not responsible for the operation of this device or its compliance with safety and regulatory standards.