Honeywell 5115, 5115G, 5110G, 5111, 5103SL User Manual

Model 5101, 5101DOJ, 5102, 5103SL, 5110, 5111, 5115

5101G, 5101GDOJ, 5102G, 5103GSL, 5110G, 5111G, 5115G

STEEL SECURITY SAFE

Read this manual carefully and never store it inside the safe!

Models 5101, 5101DOJ, 5102, 5103SL, 5110, 5111, 5115

5101G, 5101GDOJ, 5102G, 5103GSL, 5110G, 5111G, 5115G

Steel Security Safe

PACKAGE CONTENTS

1 – Steel Security Safe

1 – Operation Manual

2 – Override Access Keys

4 – “AA” Batteries

1 – Mounting Kit w/ Bolts (Except 5103SL/5103GSL)

1 – Removable Shelf (Models 5103SL/5103GSL- 5110/5110G-5111/5111G only)

ATTENTION

DO NOT RETURN SAFE TO STORE!

For missing parts or difficulty operating your safe, please contact our Consumer Assistance Department by telephone.

Store will not accept returned products without prior authorization. You must first contact our consumer assistance department (See page 7 for contact information).

LOCK OVERVIEW

LED Indicator Lights

Digital Keypad

Open/Close Knob

Access Key Cover

IMPORTANT – TEST DIGITAL LOCK BEFORE INSTALLING!!

1

SETUP

STEP 1. OPEN SAFE WITH OVERRIDE KEY

1.Remove override key cover with small screwdriver.

2.Insert override key and turn left to unlock safe.

3.Turn knob to right and open safe door.

STEP 2. INSTALL BATTERIES

1.Remove battery compartment (A) cover on inside door. Insert 4 “AA” batteries (included). Ensure the batteries are installed in the correct direction, with regard to polarity (+ and -)

See diagram.

2.Replace the battery cover.

3.Do not close door before testing digital lock.

STEP 3. TEST DIGITAL LOCK

1.With door open, turn knob left to put locking door bolts (B) in lock position.

2.Remove override key and store in a secure place. NEVER STORE KEYS INSIDE SAFE!

3.Enter the preset pass code: “1”-“5”–“9”-“B” .

4.Turn knob to right within 5 seconds.

5.Lock bolts should recede into the unlocked position.

STEP 4. PROGRAM A NEW PASSCODE

1.With door open, press reset button (C) inside door.

2.Yellow light is on, enter new pass code in 30 seconds.

3.Enter new code (3 to 8 digits) followed by “A” or “B”.

4.Safe will beep and yellow light will turn off.

NOTE: The factory pre-set code will not work after a new pass code is programmed.

OPERATION

TO OPEN THE SAFE

1.To unlock and open safe, enter the pass code followed by “A” or “B”.

2.Turn door entry knob to the right and open door.

TO CLOSE THE SAFE

1.Close the door and hold it in the closed position.

2.Turn door entry knob to left to engage the lock bolts and lock safe.

2