Voyager™ XP 1472g Series
Cordless Area-Imaging Scanner
Quick Start Guide
VG1472-EN-QS-01 Rev (a)
6/10
Note: Refer to your user’s guidefor informationabout cleaning your device.
For localized language versions of this document, go to www.honeywellaidc.com.
Getting Started
Turn off the computer’s power before connecting the base, then power up the computer once the base is fully connected. When the base is connected and powered up, put the scanner in the base to establish a link. The green LED on the base flashes to indicate the scanner’s battery is charging.
Power Supply Assembly (if included)
Note: The power supply must be ordered separately, if needed.
USB Connection:
Keyboard Wedge Connection:
RS232 Serial Port Connection:
RS485 Connection:
Reading Techniques
The view finder projects an aim-
ing dot that should be centered over the bar code, but it can be
positioned in any direction for a good read.
Hold the scanner over the bar code, pull the trigger, and center the aiming dot on the bar code.
The aiming dot is smaller when the scanner is closer to the code
and larger when it is farther from the code. Hold the scanner close to smaller bar codes, and farther away from large bar codes to get a proper read.
If the bar code is highly reflective (e.g., laminated), you may need to tilt the scanner at an angle so the bar code can be scanned.
Note: If the scanner razzes when scanning a bar code, the link has not been established. If the scanner beeps once, the link has been established.
Standard Product Defaults
The following bar code resets all standard product default settings.
Standard Product
Note: PDF and 2D bar codes can only be read by Voyager model 1472g2Dand cannot be read bymodel 1472g1D.
RS485 Interface
The RS485 interface defaults to port 5B. If you have an IBM POS terminal using port 9B, scan the appropriate code below to program the terminal, then power cycle the cash register.
IBM Port 9B HHBCR-1
Interface
IBM Port 9B HHBCR-2
Interface
Note: Foradditional RS485 interface selections, see the User’s Guideforyourproduct.
USB Serial
Scan the following code to program the scanner to emulate a regular RS232-based COM Port. If you are using a Microsoft® Windows® PC, you will need to download a driver from the Honeywellwebsite (www.honeywellaidc.com).Thedriverwillusethe next available COM Port number. Apple® Macintosh computers recognize the scanner as a USB CDC class device and automatically use a class driver.
USB Serial
Note: Noextraconfiguration(e.g.,baud rate)isnecessary.
Loading...