Loading...
LDCDP−EPC50ACU |
L−force Controls |
.J41 |
Ä.J41ä
Software Manual
Industrial PC
ACU UPS software for Industrial PCs
l
,Please read these instructions before you start working! Follow the enclosed safety instructions.
Validity information
These instructions are valid for
ƒ ACU UPS software for Lenze Industrial PCs
Trademark
Windows XPâ, Windows XPâ Embedded and Windowsâ Embedded Standard 2009 are registered trademarks or trademarks of Microsoft Corporation in the USA and/or other countries.
Any additional trade names given in this documentation are trademarks of their corresponding owners.
Document history
Material number |
Version |
|
|
Description |
|
13218873 |
1.0 |
11/2007 |
TD29 |
First edition |
|
|
|
|
|
|
|
13303164 |
2.0 |
08/2009 |
TD29 |
Revision |
|
|
|
|
|
|
|
13348913 |
3.0 |
08/2010 |
TD29 |
Description of software versions V3.x and V4.x added |
|
|
|
|
|
|
|
.J41 |
4.0 |
06/2012 |
TD29 |
Revision Registry ACU−Control |
|
I Tip!
Information and auxiliary devices around the Lenze products can be found in the download area at
http://www.Lenze.com
LDCDP−EPC50ACU EN 4.0
l 3
i Contents
1 |
Software Description . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . |
5 |
||
|
1.1 |
Operating mode . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . |
5 |
|
|
1.2 |
System Requirements . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . |
5 |
|
|
1.3 |
Messages . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . |
6 |
|
|
|
1.3.1 |
Message in case of a voltage failure . . . . . . . . . . . . . . . . . . . . . . . . . . . . . |
6 |
|
|
1.3.2 |
Message after a change in ACU UPS state . . . . . . . . . . . . . . . . . . . . . . . . . |
6 |
2 |
Software Operation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . |
7 |
||
|
2.1 |
Start and Close Software . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . |
7 |
|
|
2.2 |
Open User Interface . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . |
9 |
|
|
2.3 |
User Interface Dialogs . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . |
10 |
|
|
|
2.3.1 |
Registry "ACU State" − Show UPS State . . . . . . . . . . . . . . . . . . . . . . . . . . . |
10 |
|
|
2.3.2 |
Registry "ACU Control" − Configure UPS . . . . . . . . . . . . . . . . . . . . . . . . . . |
12 |
|
|
2.3.3 |
Registry "Time Set" − Time Before Shutdown . . . . . . . . . . . . . . . . . . . . . . |
14 |
|
|
2.3.4 |
Registry "Application"− Start External Programs . . . . . . . . . . . . . . . . . . . |
14 |
|
|
2.3.5 |
Registry "Shutdown" − Force Shutdown . . . . . . . . . . . . . . . . . . . . . . . . . . |
15 |
|
|
2.3.6 |
Registry "LogFile" − View Program Messages . . . . . . . . . . . . . . . . . . . . . . |
16 |
3 |
Software Installation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . |
17 |
||
4 |
l |
LDCDP−EPC50ACU EN 4.0
Software description |
1 |
Operating mode
1 |
Software Description |
The industrial PC option "ACU UPS Control Unit" in combination with a battery/capacitor pack extends the industrial PC (IPC) by one UPS function.The ACU UPS software controls the behaviour of the IPC in this process as soon as the hardware identifies a supply voltage failure.
The ACU UPS control unit is a factory set pre−equipment if you chose this option when placing your purchase order. However, it can also be upgraded later on by Lenze service personnel.
If you purchased the preinstalled operating system on a storage medium at Lenze, the ACU UPS software is already installed and configured according to your hardware. Alternatively, you can find the software on the driver CD for your IPC. Then, install the software as described in the chapter "Software Installation". (¶ 17
1.1Operating mode
During the boot phase of the operating system, the ACU UPS is in a permanent buffer operation which means that it already provides protection against data loss in the boot phase, even before the ACU software has started.
The ACU software starts automatically after the operating system has been booted and monitorsthe voltage supply from the background until it is closed along with the operating system.
1.2System Requirements
)Note!
Software versions Vx.x must only be used in conjunction with specific devices and are incompatible.
ACU UPS version |
Device |
Operating system |
|
V2.x |
IPC CPC 2700, EL 870−9700 or CS |
Windows XPâ or Windowsâ XP |
|
|
5700−9700 with ACU UPS control |
Embedded |
|
|
unit |
|
|
|
|
|
|
V3.x |
L−force Controller 3241 C |
Windows XPâ or Windowsâ |
|
|
|
Embedded Standard 2009 |
|
|
|
|
|
V4.x |
IPC CPC 2800, EL 1800−9800 or CS |
Windows XPâ or Windowsâ |
|
|
5800−9800 with ACU USV Control |
Embedded Standard 2009 |
|
|
Unit |
|
|
|
|
|
|
LDCDP−EPC50ACU EN 4.0
l 5
1 Software description
Messages
Message in case of a voltage failure
1.3Messages
1.3.1Message in case of a voltage failure
In the case of a voltage failure, the ACU UPS takes charge of the IPC supply. The remaining time to the IPC shutdown is displayed on the desktop. (¶ 14).
EPC50ACU−003
Fig. 1−1 Desktop message in the event of a voltage failure
1.3.2Message after a change in ACU UPS state
Changes in ACU UPS state are indicated by a change in colour of the ACU symbol on the Windows task bar.
EPC50ACU−001
Fig. 1−2 Windows task bar with ACU UPS symbol
Legend:
Green: Battery/capacitor pack loaded and active
Yellow: Battery/capacitor pack is being loaded
Red: Indicates one or more of the following faults:
–ACU UPS is buffering the system
–Short circuit in the battery/capacitor pack
–Battery/capacitor pack is not connected
–Battery/capacitor pack is damaged
–Non−defined battery/capacitor packstatus
–Charging connection of the ACU UPS is defective
6 |
l |
LDCDP−EPC50ACU EN 4.0
Loading...