Washing Machine |
WMD 66160 S |
Lave-linge |
WMD 66160 |
Wasmachine |
WMD 66140 S |
WMD 66140 |
|
Waschmaschine |
WMD 66120 S |
|
WMD 66120 |
|
|
|
|
|
|
1 Warnings |
|
directives. |
|
|
Intended use |
General Safety |
|
|
|
• This product has been designed for |
|
• Never place your machine on a carpet |
|
|
|
home use. |
|
covered floor. Otherwise, lack of airflow |
|
|
|
• The appliance may only be used for |
|
from below of your machine may cause |
|
|
|
washing and rinsing of textiles that are |
|
electrical parts to overheat. This may |
|
|
|
marked accordingly. |
|
cause problems with your washing |
|
|
|
Safety instructions |
|
machine. |
|
• This appliance must be connected to |
• If the power cable or mains plug is |
|
|
|
an earthed outlet protected by a fuse of |
|
damaged you must call Authorized |
|
|
|
suitable capacity. |
|
Service for repair. |
|
|
|
• The supply and draining hoses must |
|
• Fit the drain hose into the discharge |
|
|
|
always be securely fastened and remain |
|
housing securely to prevent any water |
|
|
|
in an undamaged state. |
|
leakage and to allow machine to take |
|
|
|
• Fit the draining hose to a washbasin |
|
in and discharge water as required. It is |
|
|
|
or bathtub securely before starting up |
|
very important that the water intake and |
|
|
|
your machine. There may be a risk of |
|
drain hoses are not folded, squeezed, |
|
|
|
being scalded due to high washing |
|
or broken when the appliance is pushed |
|
|
|
temperatures! |
|
into place after it is installed or cleaned. |
|
|
|
• Never open the loading door or remove |
|
• Your washing machine is designed to |
|
|
|
the filter while there is still water in the |
|
continue operating when the power |
|
|
|
drum. |
|
restores after a power interruption. The |
|
|
|
• Unplug the machine when it is not in |
|
machine will resume its program when |
|
|
|
use. |
|
the power restores. Press the “Start/ |
|
|
|
• Never wash down the appliance with a |
|
Pause/Cancel” button for 3 seconds to |
|
|
|
water hose! There is the risk of electric |
|
cancel the program (See, Canceling a |
|
|
|
shock! |
|
Program) |
|
|
|
• Never touch the plug with wet hands. |
|
• There may be some water in your |
|
|
|
Do not operate the machine if the |
|
machine when you receive it. This is |
|
|
|
power cord or plug is damaged. |
|
from the quality control process and |
|
|
|
• For malfunctions that cannot be solved |
|
is normal. It is not harmful to your |
|
|
|
by information in the operating manual: |
|
machine. |
|
|
|
• Turn off the machine, unplug it, turn off |
|
• Some problems you may encounter |
|
|
|
the water tap and contact an authorized |
|
may be caused by the infrastructure. |
|
|
|
service agent. You may refer to your |
|
Press “Start/Pause/Cancel” button |
|
|
|
local agent or solid waste collection |
|
for 3 seconds to cancel the program |
|
|
|
center in your municipality to learn how |
|
set in your machine before calling the |
|
|
|
to dispose of your machine. |
|
authorized service. |
|
|
|
If there are children in your |
|
First Use |
|
|
|
house... |
|
• Carry out your first washing process |
|
|
|
• Keep children away from the machine |
|
without loading your machine and |
|
|
|
when it is operating. Do not let them |
|
with detergent under “Cottons 90°C” |
|
|
|
tamper with the machine. |
|
program. |
|
|
|
• Close the loading door when you leave |
|
• Ensure that the cold and hot water |
|
|
|
the area where the machine is located. |
|
connections are made correctly when |
|
|
|
|
|
installing your machine. |
|
|
• If the current fuse or circuit breaker is |
|
|
less than 16 Amperes, please have a |
|
|
qualified electrician install a 16 Ampere |
|
|
fuse or circuit breaker. |
|
|
• While using with or without a |
|
|
transformer, do not neglect to have the |
|
|
grounding installation laid by a qualified |
|
|
electrician. Our company shall not be |
|
|
liable for any damages that may arise |
|
|
when the machine is used on a line |
|
|
without grounding. |
|
|
• Keep the packaging materials out |
|
|
of reach of children or dispose them |
|
|
by classifying according to waste |
|
|
|
2 - EN |
2 Installation
Removing packaging reinforcement
Tilt the machine to remove the packaging reinforcement. Remove the packaging reinforcement by pulling the ribbon.
Opening the transportation locks
ATransportation safety bolts must be removed before operating the washing machine! Otherwise, the machine will be damaged!
1.Loosen all the bolts with a spanner until they rotate freely (“C”)
2.Remove transportation safety bolts by turning them gently.
3.Fit the covers (supplied in the bag with the Operation Manual) into the holes on the rear panel. (“P”)
C Keep the transportation safety bolts in a safe place to reuse when the washing machine needs to be moved again in the future.
C Never move the appliance without the transportation safety bolts properly fixed in place!
Adjusting the feet
ADo not use any tools to loosen the lock nuts. Otherwise, they can be damaged.
1.Manually (by hand) loosen the lock nuts on the feet.
2.Adjust them until the machine stands level and firmly.
3.Important: Tighten all lock nuts up again.
•If you are going to use your double water-inlet machine as a single (cold) water-inlet unit, you must install the stopper*, supplied with your machine to the hot water valve.
•If you want to use both water inlets of the product, you can connect the hot water hose after removing the stopper and gasket group from the hot water valve.
* Applies for the products supplied with a blind stopper group.
•Models with a single water inlet should not be connected to the hot water tap.
When returning the appliance to its place after maintenance or cleaning, care should be taken not to fold, squeeze or block the hoses.
Connecting to the drain
The water discharge hose can be attached to the edge of a washbasin or bathtub. The drain hose should be firmly fitted into the drain as to not get out of its housing.
Important:
•The end of the drain hose must be directly connected to the wastewater drain or to the washbasin.
•The hose should be attached to a height of at least 40 cm, and 100 cm at most.
Connecting to the water supply.
Important:
•The water supply pressure required to run the machine must be 1-10 bar (0,1
– 1 MPa).
•Connect the special hoses supplied with the machine to the water intake valves on the machine.
•In case the hose is elevated after laying it on the floor level or close to the ground (less than 40 cm above the ground), water discharge becomes more difficult and the laundry may come out wet.
•The hose should be pushed into the drainage for more than 15 cm. If it is too long you may have it shortened.
3 - EN
•The maximum length of the combined hoses must not be longer than 3.2 m.
Electrical connection
Connect the machine to an earthed outlet protected by a fuse of suitable capacity. Important:
• Connection should comply with national regulations.
• The voltage and the allowed fuse protection are specified in the section “Technical Specifications”.
• The specified voltage must be equal to your mains voltage.
• Connection via extension cords or multiplugs should not be made.
BA damaged power cable must be replaced by a qualified electrician.
BThe appliance must not be operated unless it is repaired! There is the risk of electric shock!
Loading door
The door locks during program operation and the Door Locked Symbol lights up. The door can be opened when the symbol fades out.
Detergents and softeners
Detergent Drawer
The detergent drawer is composed of three compartments:
The detergent dispenser may be in two different types according to the model of your machine.
–(I) for prewash
–(II) for main wash - (III) siphon
–() for softener
3 Initial preparations for washing
Preparing clothes for washing |
Detergent, softener and other cleaning |
Laundry items with metal attachments such |
agents |
as, bras, belt buckles and metal buttons |
Add detergent and softener before starting the |
will damage the machine. Remove metal |
washing program. |
attachments or place the items in a clothing |
Never open the detergent dispenser drawer |
bag, pillow case, or something similar. |
while the washing program is running! |
• Sort the laundry according to type of |
When using a program without pre-wash, no |
fabric, color, and degree of soiling and |
detergent should be put into the pre-wash |
permissible water temperature. Always |
compartment (Compartment no. I). |
follow the advice on the garment labels. |
|
• Place small items like infants’ socks and |
Detergent quantity |
nylon stockings, etc. in a laundry bag, |
The amount of washing detergent to be used |
pillow case or something similar. This |
depends on the amount of laundry, the degree |
will also save your laundry from getting |
of soiling and water hardness. |
lost. |
• Do not use amounts exceeding the |
• Wash “machine washable” or “hand |
quantities recommended on the |
washable” labeled products only with an |
package to avoid problems of excessive |
appropriate program. |
foam, poor rinsing, financial savings and |
• Do not wash colors and whites |
finally, environmental protection. |
together. New, dark colored cottons |
• Never exceed the (> max <) level |
may release a lot of dye. Wash them |
marking; otherwise, the softener will be |
separately. |
wasted without being used. |
• Use only dyes/color changers and lime |
• Do not use liquid detergent if you want |
removers suitable for machine wash. |
to wash using the time delay feature. |
Always follow the instructions on the |
|
packaging. |
|
• Wash trousers and delicate clothes |
|
turned inside out. |
|
Correct load capacity
C Please follow the information in the "Program Selection Table". Washing results will degrade when the machine is overloaded.
4 - EN