Page 1
Halogen Desk lamp
Halogen Desk lamp
Operation and Safety Notes
7596-010L / -014L / -015L
6
Page 2
Before reading, unfold the page containing the illustrations and familiarise yourself with all
functions of the device.
GB / IE Operation and Safety Notes Page 5
Page 3
6
7
8
6
5
6
1
2
3
34
Page 4
Page 5
Table of Contents
Introduction
Proper use ................................................................................ Page 7
Included items ......................................................................... Page 7
Description of parts and features ........................................... Page 8
Technical data ......................................................................... Page 8
Safety advice ................................................................... Page 9
Operation
Using the lamp ........................................................................ Page 11
Replacing a bulb ..................................................................... Page 11
Cleaning and maintenance .................................. Page 12
Disposal ................................................................................ Page 13
Information
Guarantee ............................................................................... Page 13
Service ..................................................................................... Page 14
Declaration of Conformity ...................................................... Page 14
5 GB/IE
Page 6
The following pictograms are used in these operating
instructions / on the device:
Read instruction manual!
Observe warning and safety notes!
Always keep the product out of reach of children.
Caution – electric shock! Risk of loss of life!
Risk of loss of life by electric shock from damaged mains
lead or mains plug!
Risk of burns!
0,2 m
V∼
W
6 GB/IE
Attach the lamp at a minimum distance of 0.20 mtr to the
materials being lit.
If protective glass is broken, replace prior to using the
lamp again.
Volt (AC)
Watts (Effective power)
Dispose of packaging and appliance in an
environmentally friendly way!
Page 7
Introduction
Halogen Desk Lamp
Introduction
These operating instructions form a part of this product. They
contain important information on safety, use and disposal.
Make yourself familiar with all the operating instructions
and safety advice for the product before use. Use the product only as
described and for the indicated purpose. If you pass the product on to
anyone else, please ensure that you also pass on all the documentation
with it. Check that the correct mains voltage is available and that all
the parts have been properly assembled before bringing into use.
Proper use
This lamp is designed for use indoors only, in dry and enclosed rooms.
This product is intended for use in a private, domestic environment
only. Other uses or modification of the product shall be considered as
improper use and could lead to injury or damage. The manufacturer
accepts no liability for loss or damage arising from improper use.
Included items
Check that all the items and accessories are present and that the lamp
is in perfect condition immediately after unpacking.
7 GB/IE
Page 8
Introduction
1 x Halogen desk lamp
1 x Illuminant (G4 / 20 W)
1 x Operating instructions
Description of parts and features
1
Lamp head
2
Adjustment lever
3
ON / OFF switch
4
Mains lead with mains plug
5
Telescopic arm
6
Screws
7
Lamp shade
8
Bulb
Technical data
Operating voltage: 230–240 V ∼, 50 Hz
Protection class:
Illuminant: G4 / 20 W, 12 V ∼, 50 Hz
(included in delivery)
Wattage: max. 20 W (G4, 12 V ∼)
Length of cable: approx. 1.8 m
Material: plastic, metal, glass
Dimensions: base: ø approx. 11.8 cm
height (adjustable): approx. 26–47 cm
8 GB/IE
Page 9
Introduction / Safety advice
Model:
7596-010L (blue)
7596-014L (titanium)
7596-015L (black)
Safety advice
The right to claim under the guarantee shall be rendered invalid in
respect of damage caused by the non-observance of these operating
instructions! No liability is accepted for consequent damage! No
liability is accepted for damage to property or persons caused by
improper handling or non-observance of the safety advice!
RISK OF LOSS OF LIFE AND
ACCIDENT TO INFANTS AND CHILDREN!
Never leave children unsupervised with the packaging
materials. Packaging materials present a suffocation hazard.
Children often underestimate danger. Always keep the product
out of reach of children.
To avoid danger to life from electric shock
Before connecting the lamp to the mains, always check it and the
mains lead / plug
discover that it is damaged in any way.
If the external flexible lead of this lamp becomes damaged, avoid
danger and have it replaced by the manufacturer, his servicing
agent or an equivalent electrical appliance repair specialist.
4
for any damage. Never use your lamp if you
9 GB/IE
Page 10
Safety advice
CAUTION! A damaged mains lead presents a serious
danger to life from electric shock. In the event of damage,
repairs or other problems with the lamp, please contact
the Service Centre or an electrician.
Never let the lamp come into contact with water or other liquids.
Never open any electrical devices such as switches, fittings etc. or
allow any object to be inserted into them. This sort of interference
can lead to a serious danger to life from electric shock.
Touch only the insulated part of the plug when connecting to or
disconnecting from the mains supply.
Before installation ensure that the available mains voltag e agrees
with the operating voltage required for the lamp (230–240 V ∼).
To avoid danger of fire and injury
DANGER OF INJURY! Check all bulbs and shades for damage
immediately after unpacking. Do not fit a defective shade into the
lamp. In this event contact the Service Centre for a replacement.
DANGER OF BURNS! Ensure the lamp has been switched off
and allowed to cool before you touch it. In this way you will avoid
the danger of burns. Light bulbs develop a great deal of heat.
Replace defective bulbs immediately. Before replacing the bulb,
always remove the mains plug from the mains socket.
Allow the lamp to cool for at least 15 minutes before replacing a
defective bulb.
Do not allow any objects to cover the lamp. Fire can result from
the development of too much heat.
DANGER OF FIRE! Always ensure that there is at
0,2 m
least 0.2 m clear distance between the lamp and other
items of furniture or furnishings.
10 GB/IE
Page 11
Safety advice / Operation
Position the lamp so that it is protected from moisture and dirt.
Never leave the lamp operating unattended.
Use the above-indicated bulbs only.
Operation
Using the lamp
Always ensure that there is at least 20 cm clear distance between
the lamp and other items of furniture or furnishings.
Unwind the mains cable 4 completely before use.
Insert the mains plug 4 into the socket.
Set the lamp head 1 to the desired height with the telescopic arm 5.
Set the lamp head 1 in the desired position with the adjustment
lever
CAUTION! DANGER OF BURNS! If the lamp is switched on,
adjust the lamp head
not touch the lamp head
when the lamp is switched on.
Set the ON / OFF switch 3 into position I to switch on the device.
Set the ON / OFF switch 3 into position 0 to switch off the device.
CAUTION! RISK OF INJURY! If protective glass is
broken, replace prior to using the lamp again.
2
.
1
with only the adjustment lever 2. Do
1
. The lamp head 1 gets very hot
Replacing a bulb
c CAUTION! DANGER TO LIFE FROM ELECTRIC SHOCK!
Pull the mains plug
4
out of the socket.
11 GB/IE
Page 12
Operation / Cleaning and maintenance
Note: To do this you will require a crosshead screwdriver.
Allow the bulb 8 to cool down completely.
Note: Ensure that the lamp shade
last screw
6
is released.
Screw out the screws 6 in the direction and completely
remove all the glass-retainers.
Remove the lamp shade 7.
Draw the defective bulb 8 out of the socket.
Use a clean, fluff-free cloth when you are replacing a bulb.
Then insert a new bulb (max. 20 W) into the socket.
Note: Ensure that the pins are correctly engaged in the socket.
Place the lamp shade 7 back into the recess.
Screw in the screws 6 in the direction .
Note: Ensure that the brackets of the glass-retainers rest properly
against the lamp shade
7
.
Cleaning and maintenance
c CAUTION! DANGER TO LIFE FROM ELECTRIC SHOCK!
Before cleaning, always pull out the mains plug
Do not use solvents such as petrol and the like as they could
damage the lamp.
For electrical safety reasons, never clean the lamp with water or
other fluids or immerse it in water. Use a dry, fluff-free cloth for
cleaning.
The lamp is maintenance-free.
7
does not fall out when the
4
out of the socket.
12 GB/IE
Page 13
Disposal / Information
Disposal
The packaging consists entirely of environmentally friendly
materials. They can be disposed of at your local recycling
facility.
The symbol of the wheelie bin with a cross through It means
that, in the European Union, the product has to be disposed
of in a separate refuse collection. This applies to the product
and to all components bearing this symbol. Products marked in this
way may not be disposed of with normal domestic waste but have to
be handed in at a recycling collection point for electrical and electronic
appliances. Recycling helps to reduce the consumption of raw materials
and to ease the burden on the environment.
Information
Guarantee
You receive a 36 month warranty on this product, valid from the date
of purchase.
The device has been carefully produced under strict quality control.
Within the warranty period we shall rectify without charge all material
and manufacturing defects. In the event of a defect arising during the
warranty period, please send the device to the listed Service Centre
address, making reference to the following article number:
7596-010L, 7596-014L, 7596-015L.
Wear parts (such as bulbs) and damage caused by improper handling,
non-observance of the operating instructions or unauthorised interference
are excluded from the warranty.
13 GB/IE
Page 14
Information
The performance of services under the warranty does not extend or
renew the warranty period.
Service
Briloner Leuchten GmbH
Im Kissen 2, 59929 Brilon, Germany
Tel.: +49 (0) 29 61 / 97 12 - 0
Fax: +49 (0) 29 61 / 97 12 - 199
E-mail: Info@briloner.de
Declaration of Conformity
This product fulfils the requirements of the applicable European and
national directives (Electromagnetic Compatibility 2004 / 108 / EC,
Low Voltage Directive 2006 / 95 / EC). Conformity has been demonstrated. The relevant declarations and documents are held by the
manufacturer.
14 GB/IE
Page 15
15
Page 16
16
Page 17
IAN 66917
Briloner Leuchten GmbH
Im Kissen 2
59929 Brilon (Germany)
© by ORFGEN Marketing
Last Information Update: 06 / 2011
Ident.-No.: 7596-010L / -014L / -015L062011-6
6
Loading...