QUICK SETUP
nConnect your source (instrument, mic, mixer) to either of MIDIVERB II's inputs; both inputs if you have a stereo signal.
nConnect the MIDIVERB II outputs to your instrument amp(s) or stereo mixer returns.
nSet the MIX control to 50/50
nStart the source signal.
nTurn the INPUT control clockwise until the green SIGNAL LED stays on (when signal is present) and the red OVLD (overload) LED flashes occasionally on peaks.
nTurn the OUTPUT control clockwise to the volume level you desire.
nChange Programs manually by pressing any two numbered buttons 00-99
nSet the MIDI receive channel: Press CHAN followed by two numbered buttons 01-l 6.
nAssign Programs to MIDI Patch numbers:
Press PATCH followed by two numbered buttons 01-32. Press PRGM followed by two numbered buttons 00-99 Hold STORE and press PATCH.
n The system always reverts to Program mode (PRGM LED on).
Loading...