GAS COOKTOPS
INSTALLATION INSTRUCTIONS
INSTRUCCIONES DE INSTALACIÓN
INSTRUCTIONS D’INSTALLATION
ISTRUZIONI PER L’INSTALLAZIONE
C O N TA C T
I N F O R M AT I O N
Website:
wolfappliance.com
WOLF® is a registered trademark of Wolf Appliance, Inc.
As you follow these instructions, you will notice WARNING and CAUTION symbols. This blocked information is important for the safe and efficient installation of Wolf equipment. There are two types of potential hazards that may occur during installation.
signals a situation where minor injury or product damage may occur if you do not follow instructions.
states a hazard that may cause serious injury or death if precautions are not followed.
Another footnote we would like to identify is IMPORTANT NOTE: This highlights information that is especially relevant to a problemfree installation.
W O L F GAS COOKTOPS
INSTALLATION R E Q U I R E M E N T S
This appliance shall be installed in accordance with the regulations in force and only used in a well ventilated space. Read the instructions before installing or using this appliance.
IMPORTANT NOTE:
Installation and service must be performed by a qualified installer, service agency or the gas supplier.
Do not store or use gasoline or other flammable vapors and liquids in the vicinity of this or any other appliance.
The use of a gas cooking appliance results in the production of heat and moisture in the room in which it is installed. Ensure that the kitchen is well ventilated; keep natural ventilation holes open or install a mechanical ventilation device (mechanical extractor hood)
Prolonged intensive use of the appliance may for additional ventilation, for example opening of a window, or more effective ventilation, for example increasing the level of mechanical ventilation where present.
WHAT TO DO IF YOU SMELL GAS:
Do not try to light any appliance.
Do not touch any electrical switch.
Do not use any phone in your building.
Immediately call your gas supplier from a neighbor’s phone. Follow the gas supplier’s instructions.
If you cannot reach your gas supplier, call the fire department.
3
R AT I N G P L AT E I N F O R M AT I O N
Model Number
Serial Number
W O L F GAS COOKTOPS
INSTALLATION R E Q U I R E M E N T S
IMPORTANT NOTE: This installation must be completed by a qualified installer, service agency or gas supplier.
IMPORTANT NOTE: Save these Installation Instructions for the local inspector’s use.
Please read the entire Installation Instructions prior to installation.
Installer: please retain these instructions for local inspector’s reference, then leave them with the homeowner.
Homeowner: please read and keep these instructions for future reference and be sure to read the entire Use & Care Information prior to use.
IMPORTANT NOTE: This appliance must be installed in accordance with local codes. The correct voltage, frequency and amperage must be supplied to the appliance from a dedicated, grounded circuit which is protected by a properly sized circuit breaker or time delay fuse. The proper voltage, frequency, and amperage ratings are listed on the product rating plate.
Record the model and serial numbers before installing the cooktop. Both numbers are listed on the rating plate, located on the underside of the cooktop. Refer to the illustration below.
BEFORE Y O U S TA R T
Proper installation is your responsibility. Have a qualified technician install this cooktop. You must also assure that electrical installation is adequate and in compliance with all local codes and ordinances.
Prior to installation, ensure that the local distribution conditions (nature of the gas and gas pressure) and the adjustment of the appliance are compatible.
Proper gas supply connection must be available; refer to Gas Supply Requirements on page 10. Electrical ground is required; see Electrical Requirements on page 11.
The adjustment conditions for this appliance are stated on the label (or rating plate). The data plate can be found on the underside of the cooktop.
Location of rating |
plate under cooktop |
Rating plate location
4
INSTALLATION I N S T R U C T I O N S
BEFORE YO U S TA RT
Check the location where the cooktop will be installed. The location should be away from strong draft areas, such as windows, doors and strong heating vents or fans. Do not obstruct flow of combustion and ventilation air.
This appliance is not connected to a combustion products evacuation device. It shall be installed and connected in accordance with current installation regulations. Particular attention shall be given to the relevant requirements regarding ventilation.
This cooktop is intended for indoor use.
SITE P R E PA R AT I O N
C O U N T E RT O P C U T- O U T D I M E N S I O N S
IMPORTANT NOTE: Countertop opening dimensions shown on the following pages must be used. The dimensions shown provide for required clearances.
These cooktops are designed to fit a standard 610 mm deep base cabinet with a 635 mm deep countertop. Before making the countertop cut-out, verify that the cooktop will clear the side walls of the base cabinet below. There should be at least 140 mm clearance between the countertop and any combustible surface directly below the unit.
IMPORTANT NOTE: Do not seal the cooktop to the countertop. It must be removed if service is necessary.
L O C AT I O N R E Q U I R E M E N T S
Illustrations on the following pages provide the overall dimensions, countertop cut-out and installation specifications for Wolf gas cooktops. Maintain the following minimum installation dimensions:
Minimum horizontal clearance from the sides and back of the cooktop cut-out to adjacent vertical combustible construction, extending a minimum of 457 mm above the countertop, is as follows: 178 mm from side edges of cut-out for the 381 mm cooktop; 229 mm from side edges of cut-out for the 762 mm and 914 mm cooktops; 64 mm from rear edge of cut-out.
Minimum vertical distance between the countertop and combustible materials above the cooktop must be 762 mm.
Maximum 330 mm depth of overhead side cabinets directly above and within side clearance.
IMPORTANT NOTE: When installing a ventilation hood, refer to the specific requirements of the hood for the minimum dimension to countertop.
Failure to locate the cooktop without the proper clearances will result in a fire hazard.
5
Loading...