Bezel Installation Instructions
INSTALLATION
NOTICE: Depending on the model, additional bezels may be included with this kit but not utilized.
1Remove knobs (if installed) then remove existing bezels by extracting two screws from each bezel. Refer to the illustration below.
2Remove new bezels from packaging and discard packaging material then install new bezels with existing screws.
3Reinstall knobs. Using the chart as reference, identify the icon etched next to each bezel to determine the correct placement. For dual fuel ranges, refer to the illustration below for oven selector bezels placement.
4If any of the knobs "stick" when pressed, remove the knob and slightly loosen the two bezel screws. Refer to the illustration below. Once the proper alignment has been achieved, tighten screws and reinstall knob.
OVEN SELECTOR KNOB
ICON
BEZEL
SCREW
Bezel placement. |
Oven selector knob. |
|
(dual fuel range only) |
wolfappliance.com 800.222.7820
CAUTION
Do not place bezels in dishwasher. Do not soak or use abrasive cleaners. To clean, wipe with a damp cloth and mild detergent and water; rinse and dry.
Icon |
Text On Knob |
||
|
|
|
Hi-Low and Simmer Hi-Low |
|
|
|
100°F to 450°F |
|
|
|
Off and Hi |
|
|
|
|
|
|
|
Off and Hi |
9006431 REV-A 07/2015 |
page 1 of 1 |