Gas Range Riser Installation
Contents
Gas Range Riser
1 Assembly, stainless steel riser
2 Supports, side
12 Screws, sheet metal
1 Shelf, stainless steel (20" tall riser only)
6 Screws, shoulder (for shelf installation only)
1 Instructions
Riser Installation
INSTALL SIDE SUPPORTS
Place riser assembly on a protected work surface, front side down and remove the protective material from the back of the assembly. Limit the amount of material removed to ensure the stainless steel is protected throughout the assembly process. Install the side support brackets using two screws per side, three for 20" (508) tall riser. Refer to the illustration below.
|
ISLAND TRIM |
|
BACK PANEL |
Attach side supports. |
Remove trim and panel. |
wolfappliance.com 800.222.7820
INSTALL RISER
Remove the back panel and island trim from the range by extracting the screws along the top and both sides. Place the new riser on the range. For ranges with a griddle, verify the front of the riser is positioned between the griddle vent and griddle support. With the riser properly positioned, secure using three screws per side. For 48" (1219) and
60" (1524) risers, insert one screw into the center support bracket. Once riser is secure, reinstall back panel using existing screws. Refer to the illustrations below.
RISER FRONT |
GRIDDLE |
SUPPORT |
GRIDDLE |
VENT |
CENTER |
SUPPORT BRACKET |
Range with griddle. |
Insert riser supports. |
INSTALL SHELF—20" (508) TALL RISER ONLY
Remove all remaining protective material from the riser. Install two shoulder screws per side. For the 60" (1524) riser, install one screw in the center. Align the keyhole slots on the shelf with the shoulder screws and lower the shelf into position. Refer to the illustration below.
SHELF
KEYHOLE
SLOTS
SHOULDER
SCREWS
Attach shelf.
821270 REV-B |
10/2012 |
Page 1 of 1