Primera
Table of contents
Loading...
EX-1
EXHAUST SYSTEM
B ENGINE
CONTENTS
C
D
E
F
G
H
I
J
K
L
M
SECTION
A
EX
EXHAUST SYSTEM
PREPARATION ........................................................... 2
Special Service Tool ................................................. 2
EXHAUST SYSTEM ................................................... 3
Checking Exhaust System ........................................3
Removal and Installation ..........................................3
QG16DE ENG INE MODELS .................................3
QG18DE ENG INE MODELS .................................4
QR ENGINE MODELS ..........................................5
YD ENGINE MODELS ..........................................6
REMOVAL .............................................................6
INSTALLATION .....................................................6
INSPECTION AFTER INSTALLATION ..................7
SERVICE DATA AND SPECIFICATIONS (SDS) ........8
Tightening Torque .....................................................8
EX-2
PREPARATION
PREPARATION
PFP:00002
Special Service Tool
EBS00GQO
Toolnumber
Toolname
Description
KV10117200
Heatedoxygen sensor wrench
Looseningor tighteningheated oxygen
sensors
a: 22 mm (0.87 in)
S-NT636
EXHAUST SYSTEM
EX-3
C
D
E
F
G
H
I
J
K
L
M
A
EX
EXHAUST SYSTEM PFP:20100
Checking Exhaust System
EBS00GQQ
Check exhaust pipes, muffler and mounting for improper attachment,
leaks, c racks, damage or d eterioration.
Removal and Installation
EBS00GQR
CAUTION:
● Be sure to use genuine exhaust system parts or equivalents which are specially d esigned for heat
resistance,corrosion resistance and shape.
● Perform the operation with the exhaust system fully cooled down because t he system is still hot
just after the en gine stops.
● Be careful not to c ut your hand on the insulator edge.
QG16DE ENGINE MODELS
SMA211A
1 Mountingbracket 2 Insulator 3 Seal bearing
4 Spring 5 Clamp 6 Exhaustfront tube
7 Gasket 8 Ground cable 9 Exhaustcenter tube
10 Main muffler 11 Mounting rubber
PBIC0655E
Loading...