CLUTCH
1993 Nissan Sentra
1993 CLUTCH
Mechanical
Nissan: NX, Sentra
DESCRIPTION
Clutch assembly is a single disc type with a diaphragm spring pressure plate. Use a mechanical control system consisting of clutch cable, release lever and release bearing.
Fig. 1: Exploded View Of Typical Hydraulic Clutch System Courtesy Of Nissan Motor Co., U.S.A.
ADJUSTMENTS
NOTE: Adjust clutch pedal height before adjusting free play.
CLUTCH INTERLOCK SWITCH
Clutch interlock switch is located on clutch pedal bracket. With clutch pedal fully depressed, adjust clearance between rubber stopper and threaded end of interlock switch. Clearance should be . 004-.039" (0.10-1.00 mm).
CLUTCH PEDAL HEIGHT
Clutch pedal height is adjusted by adjusting clutch pedal stopper or clutch switch, located below pedal hinge. See Fig. 2. Loosen lock nut. Rotate clutch pedal stopper or clutch switch until pedal height is as specified in CLUTCH PEDAL HEIGHT SPECIFICATIONS table. Tighten lock nut.
CLUTCH PEDAL HEIGHT SPECIFICATIONS TABLE
Application |
In. (mm) |
NX & Sentra .......................... |
5.91-6.30 (150-160) |
CLUTCH PEDAL FREE PLAY
Mechanical Clutch (NX & Sentra)
1)Adjust free play at release lever end of clutch cable. See Fig. 2. Loosen lock nut. Apply hand pressure to release lever in direction of clutch disengagement to remove free play. Tighten adjusting nut.
2)Back off adjusting nut 2.5-3.5 turns. Free play at release lever clevis pin should be .10-.14" (2.5-3.5 mm). Free play at clutch pedal pad should be .43-.59" (10.9-15.0 mm).
Fig. 2: Adjusting Clutch Pedal (Mechanical Clutch Shown; Typical) Courtesy of Nissan Motor Co., U.S.A.
REMOVAL & INSTALLATION