ROOF
IBODY
A
B
SECTION
CONTENTS
SUNROOF .................................................................. 2
Precautions .............................................................. 2
System Description .................................................. 2
RESUMING OPERATION ..................................... 2
Component Parts Location ....................................... 2
Wiring Diagram — SROOF — ................................. 3
Terminaland Reference Value for Sunroof Switch..... 4
Sunroof Lid Weatherstrip Inspection ........................ 4
Link and Wire Assembly Inspection ......................... 4
ROOF
Fitting Adjustment .....................................................4
LONGITUDINAL/LATERAL CLEARANCE
ADJUSTMENT ......................................................4
SURFACEMISMATCH ADJUSTMENT ................5
Removal and Installation ..........................................6
SUNROOF UNIT ...................................................7
GLASS LID ............................................................8
SUNSHADE ..........................................................9
SUNROOF MOTOR ............................................10
C
D
E
F
G
H
RF
J
K
M
L
RF-1
SUNROOF
SUNROOF
Precautions
● If sunroof motor operati on sound is noted but sunroof does not operate, replace motor assembly with
PFP:91210
EIS002FG
glass lid fully closed.
● If sunroof (glass lid and motor) does not operate when using sunroof sw itch then remove the front cover of
the luggage compartment, and rotate motor gear box drive shaft with the emer gency handle (in the tool
box).
System Description
● Operating sunroof switch allows glass lid open/close, and tilt UP and DOWN.
● When sunroof switch is pressed firmly toward the OPEN side, glass lid automati cally opens and automatic
EIS002FH
operation is stopped at a point 13 5 mm (5.31 in) to the fully closed position.
NOTE:
After the emergency handle is used to rotate the motor drive shaft, sunroof switch operation may not correspond to actual glass lid movement. When this happens, conduct resuming operation to restore normal
operation.
RESUMING OPERATION
● If actual glass lid operation does not correspond to expected
operation, operate sunroof switch to slide glass lid toward area
A in the figure. This should result in resumption of normal operation.
CAUTION:
Before normal operation is resumed, expected sunroof
switch operation and actual glass lid movement may not
correspond. Make sure that neither head nor hands protrude from sunroof and conduct resuming operation.
Component Parts Location
MIIA0058E
EIS002FI
MIIA0047E
RF-2