Page 1
LED ROPE LIGHT
LED ROPE LIGHT
Operation and Safety Notes
IAN 96305
Page 2
GB / IE Operation and
Safety Notes Page 4
Page 3
A
B
1
3
45
6
2
21
C
2
3
5 4
3
Page 4
Intended use ........... Page 5
Description
of parts ........................ Page 5
Technical details...Page 5
Safety
information .............. Page 6
Safety advice
for installation ....... Page 9
Installation ............... Page 9
Shortening the
LED strip ......................... Page 10
Operation ................. Page 10
Cleaning
and care ..................... Page 11
Disposal ...................... Page 11
Warranty ................... Page 11
4 GB/IE
Page 5
LED Rope Light
Intended use
This product is suitable for use indoors.
This product is intended for use in
private, domestic enviroment only
and not for commercial purposes.
Description of parts
1
LED strip
2
Double-face tape (on the back
side of the LED strip and the
cable holders)
3
Cable holder
4
Power lead
5
In-line switch
6
Mains adapter
Technical details
LED light strip:
Operating
voltage: 230–240 V∼,
50 / 60 Hz
Rated power: max. 3.2 W
Note: the bulbs cannot be replaced
Protection class:
LED light strip (Model No.
Z31392A-BS).
5 GB/IE
Page 6
Mains adapter:
Nom. voltage,
primary: 100–240 V ∼,
50 – 60 Hz
Nom. voltage,
secondary: 12 V
Protection class:
Mains adapter
(Model No. LPS03-120-0250-3)
DEKRA / CE tested.
, 250 mA
Safety
information
In the case of damage resulting
from non-compliance with these
operating instructions the guarantee
claim becomes invalid! No liability
is accepted for consequential damage! In the case of material damage
or personal injury caused by incorrect handling or non-compliance with
the safety instructions, no liability is
accepted!
This device is not a toy and
should not be played with by
children. Children are not able
to understand the dangers that
can occur when handling this
device.
This appliance can be used by
children aged from 8 years
and above and persons with
reduced physical, sensory or
mental capabilities or lack of
experience and knowledge if
they have been given
6 GB/IE
Page 7
supervision or instruction concerning use of the appliance in
a safe way and understand the
hazards involved. Children
shall not play with the appliance. Cleaning and user maintenance shall not be made by
children without supervision.
Ensure that the product is installed
by suitably experienced or qualified persons only.
Check before installation that
the supporting surface is suitable
for the fastenings and the weight
of the lighting product. If you
have any questions about the
product or are unsure about
any of its aspects, please seek
the advice of an electrical
equipment specialist.
Do not pull on the product
lead. Ensure that it is positioned
to avoid creating a trip hazard.
The product can be used on all
surfaces officially classified as
being of “normal flammability“.
Do not attach any other objects
to the product.
After use store the light fitting in
its original packaging to avoid
causing unintentional damage.
Ensure that the light fitting does
not present a trip hazard.
CAUTION! RISK OF OVER-
HEATING! Do not operate
the light fitting while it is still in
the packaging or rolled up.
7 GB/IE
Page 8
Avoid the danger
of death from
electric shock!
Before use, ensure that the
mains voltage available is the
same as the required operating
voltage for the device
(230–240 V ∼).
Before connecting to the mains,
always check the product for
any damage.
Never use the product if you
find damage of any kind.
The connecting cable cannot
be repaired! If the cable is
damaged, the product must be
taken out of use and disposed
of in the proper way.
This article does not contain
any parts which can be serviced
by the user. The bulbs cannot
be replaced.
Never open any of the electrical
parts or insert any kind of object
into them.
Protect the product from sharp
edges, mechanical loads and
hot surfaces.
Always remove the mains plug
from the socket before installing,
dismantling or cleaning.
Never touch the mains plug or
the product with moist or wet
hands.
Use the lighting product with
only the components described
in these operating instructions.
8 GB/IE
Page 9
Disconnect the lighting product
from the mains if you intend not
to use it for an extended period
(e.g. holiday).
Do not connect the LED strip
light to another strip light.
Safety advice
for installation
The product can be mounted with
the supplied fastenings on to all
surfaces officially classified as
being of “normal flammability”.
Before installation, check
whether the substrate is suitable
for the fastenings and can support the weight of the product.
If you are unsure about any
aspects of this step, please
seek the advice of an electrical
equipment specialist.
Do not use any sharp and / or
pointed objects, such as wire,
nails or clamps, to fasten the
product in place.
Installation
Note: Thoroughly clean the surface
on to which you intend to install the
product. The surface must be clean,
dry and free of grease. Otherwise
the double-face tape
stick properly.
2
may not
9 GB/IE
Page 10
1. Using a pencil, mark the position
on the wall on to which you
intend to attach the LED light
strip. If necessary, use a spirit
level as a guide.
2. Pull the paper from the double-
face tape
the LED strip
2
on the back of
1
(Fig. B).
3. Position the LED light strip on
the pencil markings on the wall
and press to fix it firmly into
place (Fig. B).
4. Pull the paper from the double-
face tape on the back of the
cable holders
3
(Fig. C).
5. Press to fix the cable holders
firmly into place (Fig. C).
6. Mount the power lead
4
in
the cable holders (Fig. C).
Shortening the
LED strip
The LED strip can be shortened with
scissors every 10cm at the indicated
positions.
Operation
Insert the mains adapter 6
into the mains socket.
Press the ON / OFF switch on
the in-line switch
on the lights.
Press the ON / OFF switch on
the in-line switch to switch off
the lights.
10 GB/IE
5
to switch
Page 11
Cleaning and care
CAUTION! RISK OF
ELECTRIC SHOCK!
First remove the mains
plug from the socket.
Only a dry, lint-free cloth
should be used for cleaning.
Disposal
The packaging is made
entirely of recyclable
materials, which you
may dispose of at local recycling
facilities.
Contact your local refuse disposal
authority for more details of how to
dispose of your worn-out product.
To help protect the envi-
ronment, please dispose
of the product properly
when it has reached the end of its
useful life and
waste.
points and their opening hours
can be obtained from your local
authority.
not in the household
Information on collection
Warranty
The device has been manufactured
to strict quality guidelines and meticulously examined before
11 GB/IE
Page 12
delivery. In the event of product defects you have legal rights against
the retailer of this product. Your legal rights are not limited in any
way by our warranty detailed below.
The warranty for this device is
3 years from the date of purchase.
Should this device show any fault in
materials or manufacture within
three years from the date of purchase, we will repair or replace it at our choice - free of charge to you.
The warranty period begins on the
date of purchase. Please keep the
original sales receipt in a safe location. This document is required as
your proof of purchase. This warranty becomes void if the device
has been damaged or improperly
used or maintained.
The warranty applies to faults in
material or manufacture. This warranty does not cover product parts
subject to normal wear, thus possibly considered consumables (e.g.
batteries) or for damage to fragile
parts, e.g. switches, rechargeable
batteries or glass parts.
EMC
12 GB/IE
Page 13
OWIM GmbH & Co. KG
Stiftsbergstraße 1
D-74167 Neckarsulm
Model-No.: Z31392A-BS
Version: 11 / 2013
Last Information Update:
11 / 2013 · Ident.-No.:
Z31392A-BS112013-6
IAN 96305
6
Loading...