IMPORTANT SAFEGUARDS
When using electrical appliances, basic safety precautions should always be followed, including the following:
•Read all instructions.
•Do not touch hot surfaces. Use handles and knobs.
•To protect against fire, electrical shock and personal injury, do not immerse cord, plug or appliance in water or other liquid.
•Never allow the appliance to be used by children.
•Unplug from the outlet when not in use and before cleaning. Allow to cool before fitting or taking off parts, and before cleaning the appliance.
•Do not operate with a damaged cord or plug, or after the appliance malfunctions, or has been damaged in any manner. Return the appliance to the nearest authorized service facility for examination, repair or adjustment.
•The use of accessory attachments or spare parts not recommended by the appliance manufacturer may result in fire, electrical shock or personal injury.
•Do not use outdoors.
•Do not let the cord hang over the edge of the table or counter, or touch hot surfaces.
•Do not place on or near a hot gas or electrical burner, or in a heated oven.
•Plug cord into the wall outlet. To disconnect, turn any control to “off”, then remove plug from wall outlet.
•Do not use the appliance for other than the intended use. This appliance is to be utilized for domestic use
only. Any other use is to be considered improper and therefore, dangerous.
WARNING: To reduce the risk of fire or electric shock, do not remove the exterior of the unit or the cover. Don’t attempt to repair or modify the machine, doing so will void the warranty. Repair should be done by authorized service personnel only!
SAVE THESE INSTRUCTIONS
THIS PRODUCT IS FOR HOUSEHOLD USE ONLY
SHORT CORD INSTRUCTIONS
-A short power cord is provided to reduce risks resulting from becoming entangled in or tripping over a longer cord.
-Longer, detachable power supply cords or extension cords are available and may be used if care is exercised in their use.
-If an extension cord is used, the marked electrical rating should be at least as great as the electrical rating of the appliance. If the appliance is provided with 3- wire, grounding type cord, the extension should be a GROUNDING TYPE 3 - WIRE CORD. The longer cord should be arranged so that it will not drape over the counter-top or table top where it can be pulled on by children or tripped over.
-Your product is equipped with a polarized alternating current line plug (a plug having one blade wider than the other). This plug will fit into the power outlet only one way. This is a safety feature. If you are unable to insert the plug fully into the outlet, try reversing the plug. If the plug should still fail to fit, contact your electrician to replace your obsolete outlet. Do not defeat the safety purpose of the polarized plug.
6
IMPORTANT SAFEGUARDS Symbols used in these instructions
Important warnings are identified by these symbols. It is vital to respect these warnings.
Danger!
Failure to observe the warning could result in life threatening injury by electric shock.
Important!
Failure to observe the warning could result in injury or damage to the appliance.
Danger of burns!
Failure to observe the warning could result in scalds or burns.
Please note:
This symbol identifies important advice or information for the user.
Instruction for use
Read this Instruction for Use carefully before using the appliance. Failure to follow this Instruction for Use may result in burns or damage to the appliance.
The manufacturer is not liable for damage deriving from failure to respect this Instruction for Use.
Please note: Keep this Instruction for Use.
If the appliance is passed to other persons, they must also be provided with this Instruction for Use.
Checking the appliance
After removing the packaging, make sure the product is complete and undamaged and that all accessories are present.
Do not use the appliance if it is visibly damaged. Contact De’Longhi Customer Services.
DESCRIPTION
Description of the appliance
(page 3 - A )
A1. Removable water tank
A2. Cup shelf
A3. Water tank housing
A4. Accessories holder (coffee filters)
A5. Lid
A6. Steam/hot water delivery knob
A7. Cappuccino maker (**different according to the model)
A8. Cappuccino maker nozzle
A9. Spout
A10. Cappuccino maker selection ring (*some models only)
A11. Water level display
A12. Boiler outlet
A13. Mug or high glass tray
A14. Drip tray
A15. Drip tray full indicator
A16. Cup tray
Description of the control panel
(page 3 - B )
B1. |
ON/OFF - selector dial |
B2. |
READY pilot light |
B3. |
ON pilot light |
Description of the accessories
(page 3 - C )
C1. |
Filter holder |
C2. |
Filter 1 shot |
C3. |
Filter 2 shots |
C4. |
ESE pod filter |
C5. |
Measuring spoon/tamper |
INSTALLING THE APPLIANCE
Important!
When you install the appliance, you should respect the following safety warnings:
•Water penetrating the appliance could cause damage. Do not place the appliance near taps or sinks.
•The appliance could be damaged if the water it contains freezes.
Do not install the appliance in a room where the temperature could drop below freezing point.
•Arrange the power cable in such a way that it cannot be damaged by sharp edges or contact with hot surfaces (e.g. electric hot plates).
•The appliance gives off heat. After positioning the appliance on the worktop, leave a space of at least 3 cm be-
7
tween the surfaces of the appliance and the side and rear walls and at least 15 cm above the coffee maker.
Connecting the appliance
Danger!
Check that the mains power supply voltage corresponds to that indicated on the rating plate on the bottom of the appliance. Connect the appliance to an efficiently earthed and correctly installed socket with a minimum current rating of 10A only. If the power socket does not match the plug on the appliance, have the socket replaced with a suitable type by a qualified professional.
FILLING THE WATER TANK
1.Open the lid (fig. 1) and extract the tank by pulling it upwards (fig. 2);
2.Fill the tank with fresh clean water, taking care not to exceed the MAX level (fig. 3). Put the tank back in the appliance, pressing lightly to open the valves located on the bottom of the tank;
3.More simply, the tank can also be filled without extracting it by pouring the water directly from a jug.
Important:
Never operate the appliance without water in the tank or without the tank. Check the water level in the water tank by the display (A11).
SETTING UP THE APPLIANCE
1.Turn the knob to ON position to switch on the appliance (fig. 4): the ON pilot light turns on;
2.Insert the required coffee filter (1 or 2 cups) in the filter holder (fig. 5);
3.Attach the filter holder onto the machine without filling it with ground coffee (fig. 6);
4.Place a 0.5 l / 17 oz container under the boiler outlet and another 0.5 l / 0.5 l / 17 oz container under the cappuccino maker (fig. 7);
5.Wait until the READY light comes on (fig. 8) and immedi-
ately afterwards turn the selector dial to the 
position (fig. 9) and let about half the tank discharge from the boiler outlet;
6. Then turn the steam dial to the |
|
position (fig. 10) |
|
||
|
and discharge all the water remaining in the tank from the cappuccino maker;
7.Turn the steam dial back to the 0 position and the selector dial to the ON position;
8.Empty the two containers and replace them under the boiler outlet and the cappuccino maker and repeat points 5-6-7.
Now the appliance is ready for use.
Important!
No water is delivered or pump is too noisy: make sure the tank is filled and placed correctly and repeat the operation till water is delivered.
Tips for a hotter coffee
To make espresso coffee at the right temperature, the coffee maker should be preheated as follows:
1.Turn the appliance on by turning the selector dial to ON position (the ON light comes on) (fig. 4) and attach the filter holder onto the appliance without adding pre-ground coffee (fig. 6);
2.Place a cup under the filter holder. Use the same cup to be used later to prepare the coffee, in order to preheat it;
3.Wait until the READY light comes on (fig. 8) and imme-
diately afterwards turn the selector dial to the 
position (fig. 9) and let water discharge until the READY light turns off, then interrupt by turning the dial to the ON position.
4.Empty the cup, wait until the READY light comes on again and then repeat the same operation.
(It is normal for a small and harmless puff of steam to be given off when removing the filter holder).
Use of the mug or high glass tray
When using mugs or high glasses (for example, if you prepare long coffee or latte macchiato), remove the drip tray and put the mug/glass on the tray (A13 -fig. 11). Once finished the preparation, put the drip tray back in place.
HOW TO MAKE ESPRESSO COFFEE USING PREGROUND COFFEE
1.Place the ground coffee filter (C2 or C3) in the filter holder
To make one coffee, use the filter with the 
symbol on the bottom, to make two coffees, use the filter with the
symbol on the bottom;
2.To make just one coffee, place one level measure of preground coffee (about 7 g/0,25 oz) in the filter (fig. 12). To make two coffees, place two loosely filled measures (about 6 g/ 0,21 oz +6 g/0,21 oz ) of pre-ground coffee in the filter. Fill the filter a little at a time to prevent the pre-ground coffee from overflowing;
Important: For correct operation, before filling with pre-ground coffee, make sure there are no coffee residues left in the filter from the last time you made coffee.
8
Loading...