Bosch PPH626B90A, PPQ726B90A Manual

This cooktop is for use with Natural Gas and Universal LPG

PHW206FAU PPH626B90A

PHL206FAU PPQ726B90A

Robert Bosch Hausgeräte GmbH

Carl-Wery-Straße 34

81739 München

Cod. 9000005546 C

Internet:: http://www.bosch-hausgeraete.de

Dear customer,

We would like to thank and congratulate you for your choice. This practical modern appliance has been made using materials of the highest quality, which have been put through the strictest of Quality Controls during manufacture and meticulously tested to ensure that they meet all of your cooking demands. We kindly ask you to read and follow these simple instructions

in order to guarantee first-class results from the very start. This booklet contains important information not only concerning use, but also concerning your own personal safety and maintenance of the appliance.

Our products need to be carefully packed to protect them during transportation. All the material used for packing is considered essential for this purpose and is also completely recyclable. You too can contribut towards protecting the environment by disposing of this material at your nearest recyclable refuse collection point. Do not dispose of used cooking oil down the kitchen sink. Oil may seriously damage the environment. Dispose of it in a closed container at your nearest collection point or, failing this, dispose of it in your rubbish bin. Although this last solution is far from perfect, your oil will be taken to a controlled refuse dump where it will not be allowed to pollute water. You and your children will appreciate it. Render your old appliance useless before disposing of it at your nearest recyclable refuse collection centre.

Your local authority will be pleased to inform you where your nearest centre is.

2

CONTENT

Safety considerations	4
For your safety	4
What to do if yo smell gas	4
Warnings	4
Installation	6
Preparing to install	6
Clearances	7
Installation of cooktop into Kitchen bench	7
Installation procedure	8
Connection	9
Electrical connection	9
Gas connection	10
Conversion front Nat. Gas to Universal LPG	11
To change injectors	11
Injector size chart	12
Minimum flame adjustment	12
Operating instructions	13
Burner location	13
Burner ignition & control	13
User instructions	14-15
Warnings concerning cooking	16
Cleaning and maintenance	17
Service	18
Trouble shooting	18
Wiring diagram	19

3

Safety considerations

For your safety

What to do if you smell gas

Warnings

• If the information in this manual is not followed exactly, a fire or explosion may result causing property damage, personal injury or death.

• Do not store articles on or against this appliance.

•Do not store flammable material near this appliance.

•Do not spray aerosols in the vicinity of this appliance while it is in operation.

•Do not try to light the appliance.

•Do not touch any electrical switch; do not use any phone in your building.

•Inmediately call your gas supplier from a neighbour’s phone. Follow the gas supplier’s instructions.

•If you cannot reach your gas supplier , call the fire department.

•Installation and service must be performed by an authorised person.

1.Do not allow the flame to extend beyond the edge of the cooking utensil. This instruction is based on safety considerations.

2.Do not forget that the unit becomes hot when in use. Common sense is important. Just because the flame is out, does not mean parts cannot still be hot.

3.This appliance shall not be used for space heating.

This instruction is based on safety considerations.

4.Be sure to disconnect the electrical supply before disassembly of the appliance.

5.Keep the appliance area clear and free from combustible materials, gasoline and other flammable vapours and liquids.

6.This appliance must be installed in a position with the proper level of ventilation. Do not obstruct the flow of combustion and ventilation air.

7.Cabinets installed above the gas cooktop must have a minimum clearance of 650 mm (24”).

8.The gas pressure regulator supplied with the appliance must be installed in line with the gas pipe. (N.G. only)

9.For pressure testing in excess of 3.5 kPa (1/2 psig) the appliance and its individual shutoff valve must be disconnected from the gas suply piping system.

10.Important. When using a very large pot, leave a gap of at least 50 mm (2”) to avoid damaging any parts in bench top wood, plastic or other non-heat resistant materials. Never leave oil or hot fat unattended.

4

11.The surfaces on heating and cooking appliances get hot when in use. Be careful. Keep children away from the

appliance.

12.Only use your appliance for the preparation of food and never for room-heating purposes.

13.This appliance leaves the factory set for the gas supply indicated on the data plate. Call the Service Centre

if it needs to be altered.

14.Do not tamper inside the appliance. If necessary, call your local Service Centre.

15.Overheated fat or oil can easily catch fire. Never leave the

appliance unattended when cooking food with fat or oil, e.g.

chips.

16.Never pour water on burning fat or oil. DANGER OF BURNS! Cover the receptacle to smother the flames and turn the hob off.

17.In the event of a fault, cut the gas and electricity supplies to the appliance. Call our Service Centre to repair the fault.

18.Do not use unstable or uneven-based receptacles on cooking plates or burners. They may accidentally tip over.

19.If a gas supply knob/valve jams, do not force it. Call your official Service Centre immediately for them to repair or replace it.

20.The illustrations used in this booklet are only intended as a guide.

21.If your hob is supplied with a glass cover, do not subject it to excessive force. If the glass should become detached from the hob, call the Service Centre immediately for them to repair or repplace it.

22.While using your gas should avoid draughts and spillages of cold liquids. As these may cause the glass to break.

23.Grids become very hot during use. When operating the appliance control knobs, take care not to make contact with the grids.

24.Do not use this appliance neither in marine craft nor in caravans.

This appliance is not intented for the use by young children or infirm persons without supervision. Young children should

be supervised to ensure they do not play with this appliance.

Make sure you keep these instructions for use and assembly in a safe place, so that you can hand them on with the

appliance if it ever changes owner.

Note: To avoid jeopardising the electrical safety of the appliance, it is forbidden to use high-pressure or steam jet cleaning devices.

	SHOULD THE RELEVANT CONDITIONS NOT BE
	PROPERLY SATISFIED, THE INSTALLER, AND NOT
5	THE MANUFACTURER, SHALL HELD LIABLE.

Installation

Statutory requirements

Preparing to install

This installation must conform with the following:

•Manufacturer’s Installation instructions

•Local Gas Fitting Regulations

•Municipal Building Codes,

•AGA Installation Code for Gas Burning Appliances.

(AS 5601 - 2004 - Gas Installations).

•S.A.A. Wiring Code

•Local Electrical Regulations

•Any other statutory regulations

Refer to the AGA Installation Code for piping size details.

These built-in hobs are intended to be inserted in a benchtop cutout.

Only an officially authorised technician should connect

the appliance.

Before you begin, turn off the gas and electricity supply.

Installation dimensions are shown in Fig.1-1a.

Natural gas

130

Pressure test point

520

Universal LPG		Natural gas	Universal LPG
	30
				95
80	30		80	30
		130
Pressure			Pressure
test point
			test point
		Pressure
		test point

590

512

702

00 1 min

560	+
	-
	1

1

43

Gas inlet connection

min 30 / max 60

min 50

+1
490	-
		min	600

43

50 1 min

560	+
	-
	1

1a

Gas inlet connection

min 30 / max 60

min	50
+1
490	-
		min	600

Before connecting the unit, check whether the local connection conditions (type of gas) are compatible with the unit’s setting. Observe any special conditions imposed by local suppliers (utilities). The specifications of this cooktop are stated on the data label located on the bottom of the cooktop base.

A duplicate data label is supplied for adhesion to an accessible location near the hotplate if the data label on the base of the hotplate cannot be accessed when the hotplate is installed.

6