LS1203 Hands Free Stand
Assembly Instructions
|
|
Assemble the Stand |
|
Auto-scan |
|
1. Unscrew the wingnut from the bottom |
|
One piece |
of the flexible neck. |
||
bar code |
|||
scanner “cup” with |
2. Fit the bottom of the neck piece into |
||
(under |
|||
cup) |
flexible neck. |
the opening on the top of the stand |
|
|
|||
|
|
base. When positioned correctly, the |
|
|
|
flat areas of the neck piece fit into |
|
|
|
place in the stand base opening. |
|
|
|
3. Tighten the wingnut underneath the |
|
|
|
base to secure the cup and neck piece |
|
Flat |
|
to the base. |
|
areas |
|
4. Bend the neck to the desired position |
|
|
|
for scanning. |
|
Stand |
|
Set Auto-scan Mode |
|
|
To enable hands free scanning, scan the |
||
base |
|
||
|
Auto-scan Mode bar code on the back of |
||
|
|
||
|
|
the cup to set the scanner to auto-scan |
|
|
|
mode. |
|
Wingnut |
Mount Stand (Optional) |
||
Two screw-mount holes |
Attach the base of the scanner stand to a flat surface |
||
using two screws or double-sided tape. |
|||
|
Note: Screws and double-sided tape are not provided. |
||
|
Screw Mount |
||
|
1. Position the assembled base on a flat surface. |
||
|
2. Screw one #10 wood screw into each screw-mount |
||
|
hole until the base of the stand is secure. |
||
|
Tape Mount |
|
|
|
1. Peel the paper liner off one side of each piece of |
||
|
tape and place the sticky surface over each of the |
||
|
three rectangular tape holders. |
||
Rectangular tape |
2. Peel the paper liner off the exposed sides of each |
||
holders (3 places) |
piece of tape and press the stand on a flat surface |
||
dimensions = 1” x 2”) |
until it is secure. |
||
|
72-97328-02 Revision A - February 2015
Zebra Technologies Corporation, Lincolnshire, IL U.S.A. http://www.zebra.com