Quick Installation Guide
300Mbps Wireless N Wall-Plate Access Point
EAP115-Wall
Hardware Overview
Front Panel
LED
LED/Wi-Fi Button
LAN Port
RESET
LED/Wi-Fi Button
When the EAP is working in Standalone Mode and enabled with Wi-Fi
Control, press the button to turn on/off both of the Wi-Fi and LED. In other cases, press the button to turn on/off the LED only.
LAN Port
A wired device can be connected to the LAN port via an Ethernet cable and access the network.
RESET
With the EAP powered on, press and hold the button for about 5 seconds until the LED flashes. The EAP will restore to factory default settings.
LED Indicator
On: Working normally/Initializing.
Off: Working abnormally/Power off/LED is turned off.
Flashing:
Initialization: The LED flashes twice after initialization is complete.
Upgrade: The LED flashes once per second while upgrading.
Reset: The LED flashes five times in quick session during the reset. The
EAP will then reboot.
Rear Panel
UPLINK+PoE Port
Connected to a PSE (Power Sourcing Equipment), such as a PoE switch, for both data transmission and Power.
1 Network Topology
Internet
Router
PoE Switch
PC |
EAP |
EAP |
|
EAP |
|||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Clients
The EAP115-Wall can only be powered by a PSE device, such as a PoE switch.
Connect the PoE switch to the UPLINK+PoE port with an Ethernet cable.
A DHCP server (typically a router) with DHCP function enabled is required to assign IP addresses to the EAPs and clients in your local network.
2 Pre-Installation Checklist
Before installation, be sure that you have the following items:
1. A pre-installed wall junction box |
4. A Phillips screwdriver |
2. An RJ45 plug |
5. A PoE switch |
3. A triangular screwdriver |
|
3 Installation Steps
EAP115-Wall can be mounted into either an 86mm wall junction box or a standard EU wall junction box. The junction box should be pre-installed with a running-in-wall Ethernet cable connected to a PoE switch.
86mm wall junction box |
Standard EU wall junction box |
1.Detach the faceplate of the junction box with a Phillips screwdriver (demonstrated with an 86mm wall junction box).