Olson Technology OTEA-CO-B Instruction Manual

OTEA-CO-Bxx-x1x

OLSON TECHNOLOGY LASER LITE

1550nm OPTICAL AMPLIFIER

INSTRUCTION MANUAL

025-000519 REV x1 3/30/05

Phone:

E-Mail: [e-mail]

[phone]
[phone]

Fax:

[phone]

www.olsontech.com

TABLE OF CONTENTS

SAFETY WARNINGS Page 3

SPECIFICATIONS Page 4

INTRODUCTION Page 5

INSTALLATION Page 6

TROUBLE SHOOTING Page 8

025-000519 REV x1

Page 2 of 8

SAFETY WARNINGS

LASER RADIATION

The OTEA-CO-Bxx-x1x optical amplifier emits invisible laser radiation
that can cause permanent eye damage. AVOID DIRECT EXPO-
SURE TO BEAM. Operate the transmitter only with the proper optical

fiber installed in the optical connector. The “Pump” switch on the front of
the OTEA should be turned to the off position whenever the optical connector cover is opened and there is no
installed fiber (as when the fiber connector is being installed or removed from the transmitter connector).

NEVER USE ANY OPTICAL INSTRUMENT TO VIEW THE OUTPUT OF THE LASER
TRANSMITTER. “OPTICAL INSTRUMENT” INCLUDES MAGNIFYING GLASSES, OPTI­CAL FIBER SCOPES, ETC.

NEVER LOOK INTO THE OUTPUT OF THE LASER TRANSMITTER

NEVER LOOK INTO THE OUTPUT OF A FIBER CONNECTED TO A LASER TRANSMIT-

TER.

NEVER LOOK INTO OR USE ANY OPTICAL INSTRUMENT TO VIEW THE DISTANT
END OF A FIBER THAT MAY BE CONNECTED DIRECTLY OR VIA AN OPTICAL SPLIT,
TO A TRANSMITTER THAT MAY BE OPERATING. THIS SPECIFICALLY APPLIES TO
FIBERS THAT ARE TO BE CONNECTED TO OPTICAL RECEIVERS OR OTHER DEVICES
AT ANY DISTANCE FROM THE LASER TRANSMITTER.

SHOCK HAZARD

The OTEA-CO-Bxx-x1x is designed for indoor use only. Direct exposure to moisture must be avoided.

025-000519 REV x1

Page 3 of 8