Hometronic ball valve
HAV 20, 25, 32
Mounting and operation
Application
Application
The motor-driven Hometronic ball valve HAV opens or closes drinking water conduits by means of a ball valve. It is controlled by the Hometronic Manager and allows e.g. watering during the owner's absence while at the same time protecting from damage caused by water.
The ball valve is available in the nominal diameters DN 20, DN 25 and DN 32. It is available ready to be mounted with drive and connecting cable.
The ball valve has a very low noise level. It can be operated without a tool in case of a power failure. The valve state (open/closed) is indicated mechanically.
Mounting
Mounting
Danger to life through electric shock!
Live contacts are exposed while the module is being Danger! connected electrically. Touching a live contact can cause
critical injuries.
►All work may only be carried out by authorized specialized personnel.
►De-energize the corresponding fuse during all work on the module.
It is advisable to install a cleaning filter in order to prolong the service life of the valve and to protect the seals against mechanical damage. Observe the relevant regulations, e.g. DIN 1988.
Selecting the mounting site
Depending on the mounting site selected, the ball valve can be used to control the water supply of an entire house or of an individual apartment.
1. Existing plumbing on site (e.g. shutoff valve)
2.Cleaning filter (may already
exist)
3. Ball valve