Honeywell Hcm540, Hcm560, Hcm550-19, Hcm550, Hcm535-20 Owner's Manual

POWER

MODE

I I

I

45%

NATURAL COOL MOISTURETM HUMIDIFIER

HCM-530, HCM-535, HCM-540,

HCM-550, HCM-560 Series

IMPORTANT SAFETY INSTRUCTIONS

READ AND SAVE THESE SAFETY INSTRUCTIONS BEFORE USING THIS HUMIDIFIER

When using electrical appliances, basic precautions should always be followed to reduce the risk of fire, electric shock, and injury to persons, including the following:

1.Always place this humidifier on a firm, flat and level surface. This humidifier may not work properly on an uneven surface.

2.Place this humidifier in an area where it is not accessible to children.

3.Do not place the humidifier near any heat sources such as stoves, radiators, and heaters.

4.Before using the humidifier, check the power cord for any signs of damage. If the cord is found to be damaged, DO NOT USE and return the humidifier to the manufacturer under the warranty agreement for repair.

5.This appliance has a polarized plug (one blade is wider than the other). To reduce the risk of shock, this plug is intended to fit only one way in a polarized outlet. If the plug does not fit fully in the outlet, reverse the plug. If it still does not fit, contact a quali-

fied electrician. DO NOT attempt to defeat this safety feature.

6.To disconnect the humidifier, first turn controls to the OFF position, then grip the plug and pull it from the wall outlet. Never pull by the cord.

7.A loose fit between the AC outlet (receptacle) and plug may cause overheating and a distortion of the plug. Contact a qualified electrician to replace loose or worn outlet.

8.The humidifier should always be unplugged and emptied when not in operation or while being serviced or cleaned.

9.Never tilt or attempt to move the humidifier while it is operating or filled with water. UNPLUG the humidifier before moving.

10.This humidifier requires regular cleaning. Refer to the CLEANING instructions provided. Never clean the humidifier in any manner other than as instructed in this manual.

11.Turn the humidifier OFF if you notice moisture on the inside of your windows. For proper humidity reading use a hygrometer, which is available in many hardware and department stores, or by ordering one from the manufacturer (see Care Products).

1

WHAT IS AGION ANTIMICROBIAL?		FILLING:

AgION* technology prevents surface growth and migration of mold, fungus and bacteria in the filter for its life - approximately one season. Keep in mind, depending on your water quality, mineral deposits can still clog or discolor the filter and affect its life and that of the humidifier.

* AgION is registered with the Environmental Protection Agency (EPA)

YOUR HUMIDIFIER:

Tank

Cap

45%

Motor

Housing

•Remove the Tank from the Motor Housing.

•Turn the Tank over and unscrew the Cap.

•Fill the Tank with cool water.

•Reinstall the Cap. Do not overtighten.

•Install the Tank back onto the Motor Housing.

OPERATION:

POWER

	High Power
Continuous Run	Medium Power
	Low Power
Power

Mode

%

Natural Cool

MoistureTM Filter

Base

SET-UP:

Note: We recommend that the humidifier be disinfected prior to first use. Please see WEEKLY CLEANING instructions.

•Select a firm, level and flat location. For proper air flow, locate the unit at least six inches (15 cm) from any wall. Place the humidifier on a water resistant surface, as water can damage furniture and some flooring.

•Remove the Natural Cool MoistureTM Filter from the Base before filling the unit. Soak the Filter in cool water and then place the wet Filter back

into the Base. DO NOT squeeze or wring-out the Filter.

Honeywell will not accept responsibility for property damage caused by water spillage.

•Press the Power button once to start the humidifier on High Power, Continuous Run.

•Press the Power button a second time to change to Medium Power, Continuous Run.

•Press the Power button a third time to change to Low Power, Continuous Run.

•Press the Power button a fourth time to turn the humidifier OFF.

2