Honeywell Hcm2000c, Hcm1010, Hcm3000, Hcm3040, Hcm2050 Owner's Manual

...

0 (0)

OWNER’S MANUAL

4 GALLON OUTPUT PER DAY COOL MOISTURE HUMIDIFIER

Model HCM-2051 Series

* Output dependent on room temperature and humidity.

IMPORTANT SAFETY

INSTRUCTIONS

READ AND SAVE THESE SAFETY INSTRUCTIONS BEFORE USING THIS HUMIDIFIER

When using electrical appliances, basic precautions should always be followed to reduce the risk of fire, electric shock, and injury to persons, including the following:

1.Always place this humidifier on a firm, flat and level surface. This humidifier may not work properly on an uneven surface.

2.Place this humidifier in an area where it is not accessible to children.

3.Do not place the humidifier near any heat sources such as stoves, radiators, and heaters.

4.Before using the humidifier, check the power cord for any signs of damage. If the cord is found to be damaged, DO NOT USE and return the humidifier to the manufacturer under the warranty agreement for repair.

5.This appliance has a polarized plug (one blade is wider than the other). To reduce the risk of shock, this plug is intended to fit only one way in a polarized outlet. If the plug does not fit fully in the outlet, reverse the plug. If it still does not fit, contact a qualified electrician. DO NOT attempt to defeat this safety feature.

6.To disconnect the humidifier, first turn controls to the OFF position, then grip the plug and pull it from the wall outlet. Never pull by the cord.

7.A loose fit between the AC outlet (receptacle) and plug may cause overheating and a distortion of the plug. Contact a qualified electrician to replace loose or worn outlet.

8.The humidifier should always be unplugged and emptied when not in operation or while being serviced or cleaned.

9.Never tilt or attempt to move the humidifier while it is operating or filled with water. UNPLUG the humidifier before moving.

10.This humidifier requires regular cleaning. Refer to the CLEANING instructions provided. Never clean the humidifier in any manner other than as instructed in this manual.

11.Turn the humidifier OFF if the relative humidity exceeds 60%, or if you notice moisture on the inside of your windows. For proper humidity reading use a hygrometer.

INTRODUCTION

Thank you for purchasing a Honeywell Natural Cool Moisture® Humidifier. If you would like more information on our full line of products please visit our website at: www.honeywell.com/yourhome.

H O W D O E S I T W O R K ?

NATURAL COOL MOISTURE® SYSTEM

Dry air is pulled through the Natural Cool Moisture® system and a quiet fan blows out invisible, moisture-balanced air. Unwanted minerals and bacteria from the water are trapped inside the Natural Cool Moisture® filter. When the unit is running you will not see or feel a “mist”. You will know your humidifier is putting moisture into the air as you watch the water level in your tank decrease throughout the day.

W H AT I S A g I O N ™ A N T I M I C R O B I A L ?

Your Honeywell Natural Cool Moisture® filter has been designed using new AgION™ technology which prevents surface growth and migration of mold, fungus, algae and bacteria in the filter for its life - approximately one season. Keep in mind, depending on your water quality, mineral deposits can still clog or discolor the filter, affect its life and that of the humidifier.

M O D E L - H C M - 2 0 5 1

Your humidifier is made up of these parts:

Water Tank

Motor Housing

	Natural Cool	Fill Cap
	Moisture® Filter	Fill Cap
	Moisture® Filter
		Base

SET UP

NOTE: We recommend that the humidifier be disinfected prior to first use. Please see CLEANING instructions.

•Select a firm, level, flat location - at least six inches from any wall for proper air flow (Fig. 1). Place the humidifier on a water-resistant surface, as water can damage furniture and some flooring.

The manufacturer will not accept responsibility for property damage caused by water spillage

FILLING

•Remove the water tank by grasping handle and pulling straight up (Fig. 1). Set aside.

•Lift up on the motor housing to remove and set aside (Fig. 2). Remove the Natural Cool Moisture® filter from the base before filling the unit with water. Soak filter in a sink full of cool water to help reduce mineral build up and place back in the humidifier while wet. DO NOT SQUEEZE OR WRING OUT THE NATURAL COOL MOISTURE® FILTER. To help extend the life of your filter repeat this step each time you fill your humidifier.

•Turn the Water Tank upside down so that the Fill Cap is facing up; unscrew the Fill Cap by turning it counter-clockwise and set aside.

•Fill the Water Tank with COOL tap water (Fig. 3). Distilled water is not necessary as the water is filtered by the Natural Cool Moisture® filter. DO NOT USE HOT WATER. Doing so may damage the humidifier.

•Replace the fill cap by turning it clockwise . DO NOT OVER TIGHTEN. Turn the Water Tank right-side up.

NOTE: WHEN CARRYING THE FILLED WATER TANK PLEASE USE THE HANDLE AND PLACE YOUR OTHER HAND UNDER THE TANK FOR ADDITIONAL SUPPORT.

Fig. 1

WALL

Fig. 2

Fig. 3

+ 8 hidden pages