Garmin nuvi 2370LT, North America and Europe, nuvi 2360LT, South Africa, nuvi 2360LT, NA, AVIS, w/o carry case, nuvi 2360LT GLONASS, Russia, nuvi 2360LT Manual

nüvi® 2300 series

quick start manual

for use with these nüvi models: 2300, 2310, 2340, 2350, 2360, 2370

nüvi 2300 Series Quick Start Manual

	Getting Started	Power Cables
		On most models, the device comes
	‹ WARNING
		with two power cables. Each
	See the Important Safety and Product
		connector fits in only the matching
	Information guide in the product	port.
	box for product warnings and other
	important information.	• The vehicle power cable
		connects the mount to vehicle
	When using your device for the first
		power. The vehicle power cable
	time, complete the following tasks.
		has a right-angle connector.
	1. Mount the device (page 3).
		• The micro-USB cable connects
	2. Connect the device to vehicle	the device to a computer.A“B”
	power (page 4).	is inscribed on the head of the
	3. Register the device (page 5).	micro-USB cable.
	4. Check for updates.
	• Software updates (page 5).
	• Free map update (page 6).
	5. Download the full owner’s manual
	(page 6).

2

Mounting Your Device

Notice

Before mounting the device, see the Important Safety and Product Information guide for information about laws pertaining to windshield mounting.

1.Remove the clear plastic from the suction cup.

2.Clean and dry your windshield and the suction cup with a lintfree cloth.

3.Press the suction cup to the windshield.

4.While pressing, flip the lever back toward the windshield.

5.Snap the mount onto the suction cup arm .

6.Fit the bottom of your device into the mount.

7.Tilt your device back until it snaps into place.

nüvi 2300 Series Quick Start Manual

3

nüvi 2300 Series Quick Start Manual

	Connecting the Device to		3. If you are using a traffic receiver
	Vehicle Power		in Europe, connect the external
			antenna to the traffic receiver and
		‹ WARNING	secure it to the windshield using
	This product contains a lithium-ion		the suction cups.
	battery. To prevent the possibility of		After the device has been connected
	personal injury or product damage		to vehicle power, the following
	caused by battery exposure to extreme		occurs.
	heat, remove the device from the		• The device turns on.
	vehicle when exiting or store it out of
	direct sunlight.		• The device acquires satellite
	Charge your device before using it on		signals. When at least one of
			the	bars is green, your
	battery power.
			device has acquired satellite
	1. Plug the vehicle power cable		signals.
	into the vehicle power cable port		NOTE: The device may need
	on the mount.		a clear view of the sky to
			acquire satellite signals.
			• The device charges as you
			drive. in the status bar
			indicates the status of the
	2. Plug the other end of the vehicle		internal battery.
	power cable into a power outlet in
	your vehicle.

4