Pro 550
Owner’s Manual
March 2014 |
190-01725-00_0B |
Printed in Taiwan |
All rights reserved. Under the copyright laws, this manual may not be copied, in whole or in part, without the written consent of Garmin. Garmin reserves the right to change or improve its products and to make changes in the content of this manual without obligation to notify any person or organization of such changes or improvements. Go to www.garmin.com for current updates and supplemental information concerning the use of this product.
Garmin® and the Garmin logo are trademarks of Garmin Ltd. or its subsidiaries, registered in the USA and other countries. BarkLimiter™ and Bark Odometer™ are trademarks of Garmin Ltd. or its subsidiaries. These trademarks may not be used without the express permission of Garmin.
CAN ICES-3(B)/NMB-3(B)
Getting Started
WARNING
See the Important Safety and Product Information guide in the product box for product warnings and other important information.
Setting Up the Pro 550 System
Before you can use the Pro 550 system, you must set up the devices.
1Attach the dog collar device to the collar strap (Attaching the Dog Collar Device to the Collar Strap).
2Charge the handheld device (Charging the Handheld Device).
3 Charge the dog collar device (Charging the Collar).
4 Turn on the devices (Turning On the Dog Collar Device).
5If necessary, pair the dog collar device with the handheld device (Pairing a Dog Collar Device with the Handheld Device).
Device Overviews
Pro 550 Handheld Device
À |
Intensity level and training mode dial |
Á |
Battery level |
|
|
 |
Tone key |
|
|
à |
Dog collar device toggle switch |
Ä |
Mode toggle switch |
|
|
Å |
Training keys |
|
|
Pro 550 Dog Device
Power key
À
Status LED
Á
Lights
Â
Contact points
Ã
Charging clip contacts
Ä
Attaching the Dog Collar Device to the Collar Strap
1 With the buckle facing outward, insert the end of the collar
À
strap through the slot on the collar device.
Á
2 |
Pull most of the collar strap through the two slots  on the |
|
dog device. |
3 |
Insert the end of the collar strap through the slot à on the |
|
opposite side of the device. |
4 |
Pull the strap until it is tight across the front of the device. |
Charging the Handheld Device
You should fully charge the battery before you use the device for the first time or whenever the battery is low (Checking the Battery Level). It is normal for the battery to discharge in approximately 7 to 10 weeks when the device is not in use. Charging a fully depleted battery takes about 2 hours.
NOTE: The device will not charge when it is outside the temperature range of 32° to 104°F (0° to 40°C).
1 Lift the weather cap .
À
2 Plug the small end of the power cable into the mini-USB port on the device.
Á
3Plug the other end of the power cable into an appropriate power source.
The status LED is solid red when the device is charging.
4After the status LED turns solid green, unplug the power cable from the device.
Charging the Collar
NOTICE
To prevent corrosion, thoroughly dry the contacts on the collar and the surrounding area before connecting the charging clip.
You should fully charge the battery before you use the device for the first time or whenever the battery is low (Checking the
Getting Started |
1 |
Loading...