To |
Press |
|
|
Adjust the volume of the TV |
+/– |
|
|
Switch to TV (Teletext off)* |
(TV) |
|
|
Switch to Teletext* |
(Teletext) |
|
|
Select the sound |
AUDIO MONITOR |
|
|
Use FASTEXT* |
FASTEXT buttons |
|
|
Call up the on-screen display |
DISPLAY |
|
|
Change the Teletext page* |
/ |
|
|
Switch to/from wide mode of a Sony wide TV (For |
WIDE |
other manufactures’ wide TVs, see “Controlling |
|
other TVs with the remote commander |
|
(SLV-SE810G only)” below.) |
|
|
|
Notes
•With normal use, the batteries should last about three to six months.
•If you do not use the remote commander for an extended period of time, remove the batteries to avoid possible damage from battery leakage.
•Do not use a new battery together with an old one.
•Do not use different types of batteries together.
•Some buttons may not work with certain Sony TVs.
* not available on SLV-SE610G, SE710G, and SE710I
Controlling other TVs with the remote commander (SLV-SE810G only)
The remote commander is preprogrammed to control non-Sony TVs. If your TV is listed in the following table, set the appropriate manufacturer’s code number.
1 Set / at the top of the remote commander to .
2 Hold down / , and enter your TV’s code number using the programme number buttons. Then release / .
Now you can use the following TV control buttons to control your TV:
/ , TV/VIDEO, programme number buttons, (ten’s digit), PROG +/–, +/–, (TV), (Teletext), FASTEXT buttons, WIDE*, MENU*, / / / *, and OK*.
* These buttons may not work with all TVs.
Started Getting
continued
Setting up the remote commander 13