Sony RMT-V266 Service Manual

Controlling other TVs with the remote commander

The remote commander is preprogrammed to control non-Sony TVs. If your TV is listed in the following table, set the appropriate manufacturer’s code number.

1 Set / at the top of the remote commander to .

2 Hold down / , and enter your TV’s code number using the number buttons. Then release / .

Now you can use the / , VOL +/–, CH +/–, and TV/VIDEO buttons to control your TV. You can also use the buttons marked with a dot (•) to control a Sony TV. To control the VCR, reset / to .

Code numbers of controllable TVs

If more than one code number is listed, try entering them one at a time until you find the one that works with your TV.

TV brand	Code		TV brand	Code		TV brand	Code
	number			number			number
Sony	01		JVC	09		RCA	04, 10
Akai	04		KMC	03		Sampo	12
AOC	04		Magnavox	03, 08, 12		Sanyo	11
Centurion	12		Marantz	04, 13		Scott	12
Coronado	03		MGA/Mitsubishi	04, 12, 13, 17		Sears	07, 10, 11
Curtis-Mathes	12		NEC	04, 12		Sharp	03, 05, 18
Daytron	12		Panasonic	06, 19		Sylvania	08, 12
Emerson	03, 04, 14		Philco	03, 04		Teknika	03, 08, 14
Fisher	11		Philips	08		Toshiba	07
General Electric	06, 10		Pioneer	16		Wards	03, 04, 12
Gold Star	03, 04, 17		Portland	03		Yorx	12
Hitachi	02, 03		Quasar	06, 18		Zenith	15
J.C.Penney	04, 12		Radio Shack	05, 14

Notes

•If you enter a new code number, the code number previously entered will be erased.

•If the TV uses a different remote control system from the one programmed to work with the VCR, you cannot control your TV with the remote commander.

•When you replace the batteries of the remote commander, the code number may change. Set the appropriate code number every time you replace the batteries.

•When you press the AUDIO MONITOR button, your TV’s menu may appear on the TV screen. To exit the TV menu, press the MENU button on the TV remote commander or wait until the menu disappears automatically.

6 Setting up the remote commander