Sony PCV-RS726G, PCV-RS724G, PCV-RS710G, PCV-RS630G, PCV-RS620G Replacement Instructions

PCV-RS Series Hard Disk Drive

Replacement Instructions

IMPORTANT!

PLEASE READ BEFORE YOU START

These easy instructions are intended to guide you through the replacement process.

9To avoid electric shock please make sure product is turned off and disconnected from the power source. Remove jewelry before you begin work to avoid scratching the surface of your desktop computer.*

9Place your desktop computer on a clean, stable and covered surface to avoid damage to the computer's case.*

9Follow the ESD (Electrostatic Discharge) damage prevention instructions:

o Hold parts by the edges, away from exposed circuitry when possible. o Do not walk around excessively as this promotes static build-up.

9The appearance of the electronic components shown in the illustrations may be different from the components shipped. This slight difference does not affect the accuracy of these instructions.

*Sony is not responsible for any loss of data associated with your computer or any damage caused by incorrect handling of the computer under these procedures. The terms of your Sony Limited Warranty continue to apply.

2

2

Remove 3

screws

1

1

Step 1. Place your PC on a solid surface.

CAUTION! Disconnect the power cord. Failure to do so can result in unit damage or personal injury.

Using the enclosed magnetic screwdriver, remove the marked screws (3) and set them aside.

Step 2. To remove the cover, hold both sides of the computer as shown and slide it towards you. Grab bottom edges of the cover and carefully spread them out and then lift up the cover.

Step 3. Rotate the PC so the inside is facing to you. Identify the location of the Hard Drive’s connections.

P/N T99860136

Rev. C

1/2