Mobile SATA
Spinpoint MP2
Capacity |
250GB |
200GB |
160GB |
120GB |
100GB |
80GB |
||
Model |
Non-FFS HM250JJ HM200JJ HM160JJ |
HM120HJ |
HM100HJ |
HM080HJ |
||||
FFS |
HM251JJ |
HM201JJ |
HM161JJ |
HM121HJ |
HM101HJ |
HM081HJ |
||
|
FEATURES
•Max. 125GB formatted capacity per disk
•SATA Native Command Queuing Feature
•TuMR/PMR head with FOD technology
•Serial ATA 3.0Gbps Interface Support
•Load/Unload Head Technology
DRIVE CONFIGURATION
Capacity1 80GB/100GB/120GB/160GB/200GB/250GB
Interface |
SATA 3.0Gbps |
Buffer DRAM Size2 |
16 MB |
Byte per Sector |
512 |
Rotational Speed |
7,200 RPM |
PERFORMANCE SPECIFICATIONS |
|
Average Seek time (typical) |
11ms |
Average Latency |
4.17 ms |
Data Transfer Rate |
|
Media to/from Buffer (Max.) |
1.1 Gbits/s |
Buffer to/from Host (Max.) |
300MB/s |
Drive Ready Time (typical)3 |
4 sec |
RELIABILITY SPECIFICATIONS |
|
Non-recoverable Read Error |
1 sector in 1014 bits |
Controlled Ramp Load/Unload |
600,000 |
ACOUSTICS |
|
Idle |
80,100,120GB : 2.4Bel |
160,200,250GB : 2.6Bel |
|
Performance Seek |
80,100,120GB : 2.6Bel |
160,200,250GB : 2.8Bel |
|
POWER REQUIREMENTS |
|
Voltage |
+5V±5% |
Spin-up Current (Max.) |
1000 mA |
Seek (avg.)4 |
2.65 W |
Read/Write (avg.) |
2.55 W |
Low Power Idle (avg.) |
0.8 W |
Standby (avg.l) |
0.25 W |
Sleep (avg.) |
0.20 W |
•ATA Security Mode Feature Set
•ATA S.M.A.R.T. Feature Set
•SilentSeek™
•NoiseGuard™
•Free Fall Sensor(optional)
ENVIRONMENTAL SPECIFICATIONS
Temperature |
|
Operating |
5 ~ 55 |
Non-operating |
-40 ~ 70 |
Humidity (non-condensing) |
|
Operating |
5 ~ 90 % |
Non-operating |
5 ~ 95 % |
Linear Shock (1/2 sine pulse) |
|
Operating(2ms) |
325 G |
Non-operating(1ms) |
900 G |
Vibration |
|
Operating(Random,10~500Hz) |
0.7Grms |
Altitude (relative to sea level) |
|
Operating |
-300 to 3000 m |
Non-operating |
-400 to 15000 m |
PHYSICAL DIMENSION |
|
Height (Max.) |
9.5 mm |
Width |
69.85 mm |
Length |
100 mm |
Weight (avg.) |
115 g |
* Note : Design and specifications are subject to change without prior notice. 1.1MB = 1,000,000 Bytes, 1GB = 1,000,000,000 Bytes
Accessible capacity may vary as some OS uses binary numbering system for reported capacity
2.A small portion of the 16MB buffer memory is reserved for firmware use.
3.Power-On to Drive Ready
4.30% duty cycle, random seek
. Unless otherwise specified, specifications are for 250GB configuration
2.5" HDD product specification Rev 0.2 Match with product Manual Rev 01