Kenwood CX-DAB1 User Manual

0 (0)

CX-DAB1

DAB antenna unit

INSTALLATION MANUAL

Antenne DAB

MANUEL D’INSTALLATION

Bluetooth-Antennengerät

INSTALLATION-HANDBUCH

DAB-antenne

INSTALLATIEHANDLEIDING

Unità antenna DAB

MANUALE PER L’INSTALLAZIONE

Unidad de antena DAB

MANUAL DE INSTALACIÓN

Unidade de antena DAB

MANUAL DE INSTALAÇAO

© 2012 JVC KENWOOD Corporation

B64-4972-00/00 (W)

Kenwood CX-DAB1 User Manual

CAUTION

Disconnect the battery’s negative terminal and make all electrical connections before installing the unit.

Mounting and wiring this product requires skills and experience. For safety’s sake, leave this work to professionals. If you experience problems during installation, consult your Kenwood dealer.

This film antenna is exclusively for use inside the vehicle.

Do not install at the following locations:

Where it may block driver’s view

Where it may obstruct operation of safety devices such as air bags

On movable glass surface such as rear hatch

Signal strength will decrease at the following locations:

On IR reflecting glass or where covered with mirror type glass film

Where it overlaps with genuine radio antenna (pattern)

Where it overlaps with window heating wires

At side of vehicle (e.g. door, front quarter window)

On rear window

When glass that blocks radio signals (e.g. IR reflecting glass, thermal insulation glass) is used

Reception may decrease due to noise when windshield wiper, air conditioner, or motor is turned on.

Reception may decrease depending on the direction of the broadcast station with respect to the vehicle (antenna).

Be sure to check the installation location of film antenna A before installing. Film antenna cannot be re-pasted.

Thoroughly wipe oil and dirt from the pasting surface with the included cleaner D.

Do not bend or damage the film antenna A.

Warm the pasting surface by turning on the heater for example, before applying.

2 | English

It may not be possible to install on some type of vehicle.

Check the cable routing of the film antenna A and amplifier B before pasting.

Part list

A..........................

DAB antenna film (×1)

B.............. DAB antenna amplifier (×1)

C...................................

Cord clamper (×3)

D.................................................

Cleaner (×1)

Specifications

Frequency Range: 170 240MHz, 1452 1492MHz

Impedance: 50Ω Operating voltage: 9 16V

Current Consumption: 70mA (Max) Connector Type: SMB

Cable Length: 3.5m

Specifications subject to change without notice.

Loading...
+ 3 hidden pages