AEG E51NB60ESS, E51LK60ESS, E51LB60ESS, E51NK60ESS Manual

0 (0)

1 Welcome & Congratulations

Congratulations on your purchase of a new grill! We at Electrolux Home Products are very proud of our product and we are completely committed to providing you with the best service possible.

Your satisfaction is our #1 priority.

Please read this Use & Care Manual very carefully. It contains valuable information on how to properly maintain your new grill.

We know you’ll enjoy your new grill and thank you for choosing our product. We hope you consider us for future purchases.

PLEASE READ AND SAVE THESE INSTRUCTIONS

This Use & Care Manual provides specific operating instructions for your model. Use your grill only as instructed in this manual. These instructions are not meant to cover every possible condition and situation that may occur. Common sense and caution must be practiced when installing, operating and maintaining any appliance.

Please record your model and serial numbers below for future reference. This information is found on the serial plate located on the back of the built-in grill or on the inside of the cart door for complete grill & cart model.

Questions? 1-800-320-0859 www.electroluxusa.com

Please record grill information for future reference and service work:

Model #: ________________________________________________________

Serial #: ________________________________________________________

Date of Purchase: ________________________________________________

Gas Type: ______________________________________________________

TABLE OF CONTENTS

Welcome/Product Registration ......................................................................

1

General Safety Instructions ..........................................................................

2

Grill Features & Components ......................................................................

3-4

Grill Assembly/Built-In Instructions ............................................................

5-8

Gas Requirements/Leak Testing ................................................................

9-11

Lighting the Grill ............................................................................................

12

Using the Grill (Rotisserie/Side Burner Usage)........................................

13-15

Care & Maintenance ......................................................................................

16

Troubleshooting Your Grill ........................................................................

17-18

Warranty ..........................................................................................................

19

Please retain this manual for future reference

 

© 2004 Electrolux Home Products, Inc All rights reserved

 

General Safety Instructions 2

IMPORTANT SAFETY INFORMATION

-Read this manual carefully before using your grill to reduce the risk of fire, burn hazard or other injury.

-Extreme care should be used because of the high temperatures produced by this appliance. CHILDREN SHOULD NOT BE LEFT

UNATTENDED IN AN AREA WHERE THE GRILL IS BEING OPERATED.

-This appliance must be kept clear from combustible materials, gasoline or other flammable vapors and liquids. Do not allow flammable materials to come in contact with grate, burner or hot surfaces.

-Use only outdoors and provide good ventilation to avoid carbon monoxide build-up which could result in injury or death.

-Do not repair or replace any part of this appliance unless it is specifically recommended in this manual. A qualified service technician should conduct all other service.

-Follow the installation and servicing instructions provided with this product. Have your grill installed by a qualified service technician.

-Locate the main gas supply valve so that you know how to shut the gas off to your grill.

-If you smell gas, make sure all gas connections are tight before operation. If you continue to smell gas call a qualified technician.

-When lighting a burner, always pay close attention to what you are doing and be certain you are pushing the igniter that lights the burner you intend on using.

-Always keep your face and body as far away as from the grill as possible when lighting to reduce the risk of burn.

-Extinguish all flames and do not smoke while engaging gas and igniting the grill.

FOR YOUR SAFETY

If you smell gas:

1. Shut off gas to the appliance.

2. Extinguish any open flames.

3. Open grill hood.

4. If odor continues, immediately call your gas supplier.

CALIFORNIA PROPOSITION 65 - WARNING: The burning of gas cooking fuels generates some by products which are on the list of substances which are known by the State of California to cause cancer or reproductive harm. California law requires businesses to warn customers of potential exposure to such substances. To minimize exposure to these substances, always operate this unit according to the use and care manual, provide good ventilation when cooking with gas.

This appliance is not intended to be installed in or on recreational vehicles or boats.

FOR OUTDOOR USE ONLY

TESTED IN ACCORDANCE WITH ANSI

Z21.58b-2002/CGA 1.6b-M02 STANDARD FOR

OUTDOOR COOKING GAS APPLIANCES. THIS GRILL IS FOR OUTDOOR USE ONLY.

Check your local building codes for the proper method of installation. In the absence of local codes, this unit should be installed in accordance with the National Fuel Gas Code No. Z223.1-2002 and the National Electrical Code ANSI/NFPA

No. 70-1990

FOR YOUR SAFETY

DO NOT store or use gasoline or other flammable vapors and liquids in the vicinity of this or any other appliance.

An LP cylinder not connected for use shall not be stored in the vicinity of this or any other appliance.

WARNING

DO NOT try lighting this appliance without reading the “LIGHTING INSTRUCTIONS” section of this manual.

3

Grill Features: E51

 

1

 

7

2

 

8

 

 

 

 

9

3

 

13

 

 

16

 

14

4

 

 

 

 

10

5

 

15

6

 

11

 

12

 

 

1.Roll top grill hood

2.Grilling/cooking surface

3.Side shelf

4.Control knob: back infrared burner

5.Control knobs: main burners

6.Warming drawer

7.Hood handle

8.Warming shelf

9.Infrared back burner

10.Electronic igniter: bottom infrared and side burner

11.Cart with doors and drawers

12.Drip pans

13.Side burner

14.Control knob:side burner

15.Control knob: bottom infrared burner

16.Electronic igniter: main burners and back infrared

NOTE: Cart, side burner and side shelf are not included with the head only units.

5 Grill Assembly

IMPORTANT: Remove all protective plastic film from stainless steel parts prior to assembly/use. This film is installed at the factory to prevent damage that could occur during shipment and handling.

SIDE SHELF ATTACHMENT

1.Loosen the bolts on the side of the grill and attach the shelf by allowing the bolt heads to fall through the large opening in the bottom of the keyhole slots. Then slide the shelves downward until the bolts are resting against the top of the key hole slots. Tighten all of the shelf bolts. (See Fig. 1-2)

2.Attach the four (4) wires coming out from the left side of the grill to the igniter terminals. (See Fig. 3)

Note: It does not matter which wire goes to which terminal on the electronic igniter

INTERIOR PARTS INSTALLATION

1.Install the bottom flavor grids in the lower cutouts and around the igniters. (See Fig. 4)

2.Insert the top row of flavor grids with the 90 degree angled heat shield (bottom side of flavor grid) facing the rear of the unit into cutouts with triangle ridges facing up. (See Fig. 5-6)

Note: The right side of one flavor grid is extended. This goes on the far right main burner, next to the bottom infrared burner.

3.Install cooking grates on the ledges provided on the grill to create your cooking surface. (See. Fig. 7)

4.Place warming shelf on support brackets by setting it flat across brackets allowing the two holes to line up with the holes on each bracket. (See

Faces the back of the grill

Fig. 6

Bottom flavor grids in between burners

Fig. 1

Fig. 2

Fig. 3

Fig. 4

Cooking Grates

Fig. 7

Fig. 5

 

Warming Shelf

AEG E51NB60ESS, E51LK60ESS, E51LB60ESS, E51NK60ESS Manual

Side Burner Assembly 6

Fig. 7)

SIDE BURNER PARTS ASSEMBLY

1.Loosen the bolts on the side of the grill and attach the side burner by allowing the bolt heads to fall through the large opening in the bottom of the keyhole slots. Then slide the side burner downward until the bolts are resting against the top of the key hole slots. Tighten all of the shelf bolts. (See Fig. 8-9)

2.Install burner and cap. (See Fig. 10-11)

3.Install grate over burner. (See Fig. 12)

4.Attach the wire coming out of the grill and the side burner wire to the igniter terminals . (See Fig. 13-14)

Note: It does not matter which wire goes to which terminal on the electronic igniter

Front of side burner.

Fig. 13

Fig. 14

Fig. 8

Fig. 9

Fig. 10

Fig. 11

Fig. 12

Loading...
+ 13 hidden pages