BEFORE USING THE REFRIGERATOR
1
Declaration of conformity
l
This appliance is designed to store food and IS
manufactured in conformity with EEC directrve
No. 89/109
l
This appliance has been desrgned, built, and
marketed in compliance with:
-the safety targets of the Low Voltage EEC
Directive 73123;
- the protection requirements of the “EMC”
EEC Directive 89/336 amended by EEC
Drrectrve 93/68.
l
Thus appliance is free of CFC’s (refrigerant
crrcurt contains RI 34a). For more details, please
refer to the rating plate on the appliance.
Levelling
If necessary, it
IS
possible to level the appliance by
turning the two levelling screws right behind the
front grille on the refrigerator bottom, one on the
right and the other on the left, proceeding as
follows:
l
remove the front grille;
l
turn one screw or both, clockwrse to raise the
appliance,
l
turn one screw or both, antrclockwise to lower
the appliance;
l
check If the desired levellrng has been reached;
l
put the front grille back Into place.
Removal of the front grille
To remove the grille:
l
open both doors (refrigerator and freezer);
l
pull out the grille frontally to release it from the
metal retainers.
At this point it
IS
possible to reach the defrost
pan for perrodrc cleaning, proceeding as
follows.
l
remove the defrost pan;
l
wash the defrost pan wrth warm water and
sodium btcarbonate;
l
rinse and dry,
l
put the defrost pan back Into place with the
notched corner to the rear;
. make sure that the defrost drain tube IS
pointing Into the pan;
l
put the front grille back into place.