Models 973LM and 973LM-Gate Security ® 3-Button Remote Control
OWNER’S MANUAL
The 900 Series remote control works only with door openers and light controls having an orange “Learn” button.
Programming instructions are described and illustrated below. The additional push buttons can also activate other garage door openers and/or light controls. (Instructions for programming light products are included with those accessories.)
Instructions are Described and Illustrated Below
OR |
1 |
2 |
3 |
WARNING
To prevent possible SERIOUS INJURY or DEATH from a moving gate or garage door:
•ALWAYS keep remote controls out of reach of children. NEVER permit children to operate, or play with remote control transmitters.
•Activate gate or door ONLY when it can be seen clearly, is properly adjusted, and there are no obstructions to door travel.
•ALWAYS keep gate or garage door in sight until completely closed. NEVER permit anyone to cross path of moving gate or door.
Open/Close/Stop Operation
|
|
Your Security ® remote control can be programmed to operate |
|
1 |
2 |
one door using all 3 buttons: the large button will only open the |
|
|
|
door, the middle button will close the door, and the third button |
|
|
|
will stop the door’s movement. You may set up this feature as |
|
|
|
follows: |
|
|
|
1. With the door closed, press and hold the |
|
|
|
large remote push button. |
|
1. Press and release the “learn” button on |
|
2. Press and hold the Lock button on the |
Open |
|
door control. |
Close |
|
the motor unit. The learn indicator light |
|
Stop |
|
|
3. Press and hold the door control push bar. |
||
will glow steadily for 30 seconds. |
|
|
|
|
|
When the opener lights flash, release all buttons. Test by pressing |
|
2. Within 30 seconds, press and hold the |
|
the large (Open) button on the remote. The door should open. |
|
button on the hand-held remote. |
|
Press it again while the door is open and nothing should happen. |
|
|
|
Press the middle (Close) button while the door is moving and it |
|
3. Release the button when the motor unit light |
|
should close. Press the third (Stop) button and the door should |
|
|
stop immediately. |
|
|
blinks. It has learned the code. If light bulbs |
|
|
|
|
|
|
|
are not installed, two clicks will be heard. |
|
The Remote Control Batteries |
|
To Erase All Codes From Motor Unit Memory
WARNING
To deactivate any unwanted remote, first erase all codes:
Press and hold the “learn” button on motor unit |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
To prevent possible SERIOUS INJURY or DEATH: |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
• NEVER allow small children near batteries. |
|
||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
||
until the learn indicator light goes out |
|
|
|
|
|
|
|
|
|
|
|
|
• If battery is swallowed, immediately notify doctor. |
|
|||
|
|
|
|
|
|
|
|
|
|
|
|
|
|||||
(approximately 6 seconds). All previous codes |
|
|
|
|
|
|
|
|
|
||||||||
are now erased. Reprogram each remote or |
|
|
|
|
|
|
|
The lithium batteries should produce |
|
||||||||
keyless entry you wish to use. |
|
|
|
|
|
|
|
|
|||||||||
|
|
|
|
|
|
|
power for up to 5 years. To replace, |
|
|||||||||
To Control the Opener Lights |
|
|
|
|
|
|
|
Battery |
|||||||||
|
|
|
|
|
|
|
pry open case with visor clip or |
||||||||||
|
|
|
|
|
|
|
positive |
||||||||||
With Security ® remote controls, a remote push button can be |
screwdriver, as shown. Insert |
side up (+) |
|||||||||||||||
batteries positive side up (+). |
|
||||||||||||||||
programmed to operate the opener lights without opening |
|
|
|
|
|
|
|
Dispose of old batteries properly. |
|
||||||||
the door. |
|
|
|
|
|
|
|
|
|||||||||
|
|
|
|
|
|
|
|
|
|||||||||
1. With the door closed, press and hold the remote button that |
|
|
|||||||||||||||
you want to control the light. |
|
|
|
|
|
|
|
|
|
||||||||
|
|
|
|
|
|
|
NOTICE: To comply with FCC and or Industry Canada (IC) rules, adjustment or modifications of this |
||||||||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
||
2. Press and hold the Light button on the door control. |
|
|
|
|
|
|
|
receiver and/or transmitter are prohibited, except for changing the code setting or replacing the |
|||||||||
3. Press and hold the Lock button on the door control. |
|
|
|
|
|
|
|
battery. THERE ARE NO OTHER USER SERVICEABLE PARTS. |
|
||||||||
|
|
|
|
|
|
|
Tested to Comply with FCC Standards FOR HOME OR OFFICE USE. Operation is subject to the |
||||||||||
4. After the opener lights flash, release all buttons. |
|
|
|
|
|
|
|
following two conditions: (1) this device may not cause harmful interference, and (2) this device must |
|||||||||
|
|
|
|
|
|
|
accept any interference received, including interference that may cause undesired operation. |
||||||||||
Test by pressing the remote push button. The opener lights |
|
|
|||||||||||||||
|
|
||||||||||||||||
should turn on or off but the door should not move. |
|
|
|
|
|
|
|
Replacement Parts |
|
||||||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
FOR SERVICE DIAL OUR TOLL FREE NUMBER: |
|
|
|
|
|
|
|
3V2032 Lithium battery: . . . . . . . . . . . . . . . . . . . . . . . . . .10A20 |
|||||||||
|
|
|
|
|
|
|
Visor clip: . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .29B137 |
||||||||||
US: 1-800-528-2817 |
|
|
|
|
|
|
|
||||||||||
|
|
|
|
|
|
|
Owner’s manual - Spanish: . . . . . . . . . . . . . . . . . .114A2210SP |
||||||||||
CANADA: 1-800-654-4736 |
|
|
|
|
|
|
|
||||||||||
© 2006, Chamberlain Group Inc. |
|
||||||||||||||||
114A2210G |
All Rights Reserved |
|