Liebherr CTesf 3306, CTPesf 3223 User Manual

4 (1)
Liebherr CTesf 3306, CTPesf 3223 User Manual

Gebrauchsanweisung

Kühl-Gefrierkombination

Operating instructions

combined refrigerator-freezer

Gebruiksaanwijzing

koel-vriescombinatie

Mode d’emploi

combinés réfrigérateur-congélateur

Istruzione d’uso

combinazione frigo-congelatore

Instrucciones de manejo

combinación de frigorífico-congelador

Manual de utilização

Combinado frigorífico-congelador

Kullaným Kýlavuzu

Soðutucu-Dondurucu-Kombinasyonu

Οδηγίες Χρήσης

Ψυγειοκαταψύκτης

Liebherr Hausgeräte Marica EOOD* 4202 Radinovo* Bezirk Plovdiv* Bulgarien**www.liebherr.com

D

GB

NL

F

I

E

P

TR

GR

7081 869-03

CTP/CTPesf 29../32.. 0609

Disposal notes

The packaging is made of recyclable materials.

-Corrugated board/board

-EPS moulded parts

-Polythene sheets

-Polypropylene straps

Keep packaging materials away from children - polythene sheets and bags can cause suffocation!

Please return the packaging to an official collection point.

Your old appliance: This contains some reusable materials and should be disposed of properly - not simply with unsorted household refuse.

Discarded appliances should be disabled: Remove the plug, cut through the connection cable and render the catch unusable so that children cannot become trapped inside.

Ensure that the refrigerant circuit is not damaged

when the appliance that is no longer needed is taken away for disposal.

Details of the refrigerant can be found on the type plate.

Appliances which are no longer needed must be disposed of in a professional and appropriate way, in accordance with the current local regulations and laws.

Contents

Page

Setting up, Connecting to the mains,

 

Notes on energy saving, Switching the appliance on and off

Setting the temperature,Changing shelf arrangement,

 

Interior light.................................................................................

9

Cooling, Freezing......................................................................

10

Notes on freezing and storage, Defrosting, cleaning................

11

Malfunctions, Shutting your appliance down

 

Installing appliance in a row of kitchen units.............................

12

Changing over door hinges.......................................................

13

Climate rating

The appliance is set to operatewithin specific ambient temperature limits according to its climate rating. These temperature limits should not be exceeded. The correct climate rating for your appliance is indicated on the type plate.

Climate rating

Ambient temperatures

SN

+ 10° to + 32 °C

N

+ 16° to + 32 °C

ST

+ 16° to + 38 °C

T

+ 16° to + 43 °C

Description of appliance and equipment

Safety instructions and warnings

To prevent injury or damage to the unit, the appliance should be unpacked and set up by two people.

In the event that the appliance is damaged, contact the supplier immediately before connecting to the mains.

To guarantee safe operation, ensure that the appliance is set up and connected as described in these operating instructions.

Disconnect the appliance from the mains if any fault occurs. Pull out the plug, switch off or remove the fuse.

When disconnecting the appliance, pull on the plug, not on the cable.

Any repairs and work on the appliance should only be carried out by the customer service department, as unauthorised work could prove highly dangerous for the user. The same applies to changing the mains power cable.

Do not allow naked flames or ignition sources to enter the appliance. When transporting and cleaning the appliance ensure that the refrigerant circuit is not damaged. In the event of damage, make sure that there are no ignition sources nearby and keep the room well ventilated.

Do not stand on the plinth, drawers or doors or use them to support anything else.

Do not let children play with the appliance, e.g. do not allow them to sit in the drawers or swing on the door. This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities or lack of experience and knowledge unless they have been given initial supervision or instruction concerning use of the appliance by a person responsible for their safety. Children should be supervised to ensure that they do not play with the appliance.

Avoid prolonged skin contact with cold surfaces or chilled/ frozen food. This could cause pain, numbness and frostbite. Protect against long-term contact with the skin, e.g. wear gloves.

Do not eat ice cream, particularly ice lollies or ice cubes, immediately after taking them from the freezer compartment as there is a risk of “burning” because of the very cold temperatures.

Do not consume food which has been stored for too long, as it could cause food poisoning.

The device is designed exclusively for the cooling foodstuffs. The applicable statutory regulations are to be observed in the event that the device is to be used for commercial cooling of foodstuffs. The device is not suitable for the storage and cooling of drugs, blood plasma, laboratory preparations or similar medicine-related materials and products as detailed in the Medical Devices Directive 2007/47/ EC. Improper use of the device can cause the stored products stored in it to be damaged or the items can be spoiled. In addition, the device is not suitable for operation in explosion-prone areas.

Do not store explosives or sprays using combustible propellants such as butane, propane, pentane etc. in the appliance. Electrical components might cause leaking gas to ignite. You can identify such sprays by the printed contents or a flame symbol.

Do not use electrical appliances inside the appliance.

The operating instructions apply to several models. Differences may therefore occur.

Operating

Controls

Freezer compartment storage shelf

Butter stop

Adjustable door racks

Adjustable bottle and can

holder

Adjustable shelves Interior light

Defrost drain

Door rack for large bottles

Rating plate

Vegetable bins

Adjustable feet

Dimensions

CTP 29.. A = 1550 mm CTP 32.. A = 1690 mm

Setting up

Avoid positioning the appliance in direct sunlight or near cookers, radiators and similar sources of heat.

The floor on which the appliance stands should be horizontal and level. To compensate for any unevenness, adjust the height of the feet with the open-ended wrench supplied.

Always position the appliance directly up against the wall.

The ventilation grilles should not be obstructed. Always ensure that there is good ventilation and that the outward flowing air is able to escape.

Condensation may form on the outside of the refrigerator/ freezer during periods of high humidity.

Constant ventilation of the installation site is recommend.

Do not place heat-emitting appliances, e.g. microwave oven, toaster, etc., on top of the appliance.

In order to avoid the risk of fire, do not place any burning candles, lamps or other objects with open flames on the refrigerator/freezer.

Standard EN 378 specifies that the room in which you install your appliance must have a volume of 1 m3 per 8g of R 600a refrigerant used in the appliance, so as to avoid the formation of inflammable gas/air mixtures in the room where

the appliance is located in the event of a leak in the refrigerant circuit. The quantity of refrigerant used in your appliance is indicated on the type plate on the inside of the appliance.

Fire hazard due to dampness!

If live parts or the mains lead become damp this may cause short circuits.

-The appliance is designed for use in enclosed areas. Do not operate the appliance outdoors or in areas where it is exposed to splash water or damp conditions.

CAUTION! Risk of injury and danger of damage as a result of incorrect transport!

-Transport the appliance in a packed condition.

-Transport the appliance upright.

-Do not transport the appliance without assistance.

Connecting to the mains

Power supply (AC) and voltage at the operating point must comply with the details on the rating plate. The type plate is located in the refrigerator compartment on the left-hand side. The socket must be fused with a 10 A fuse or higher, it must be away from the rear of the appliance and must be easily accessible.

Do not connect the appliance to the supply with other equipment using a distribution outlet - risk of overheating.

Connect the appliance with a properly earthed fused plug and socket only.

Notes on energy saving

Avoid opening the door unnecessarily for long periods of time.

Allow hot food to cool to room temperature before storing it in the appliance.

If an ice layer forms, defrost the appliance. This will improve the cold transfer and reduce energy consumption.

Switching the appliance on and off

You are recommended to clean the appliance before switching it on for the first time (see “Cleaning”).

Switching on, Fig. A1:

Insert plug. Using a coin, turn the temperature controller 1 to a setting between “0” and “max” . The temperature display 3 shows the set interior temperature.

To switch the appliance off:

Pull out the mains plug or set the temperature control to “0”.

Changing shelf

arrangement

The shelves, Fig. A3, can be adjusted according to the height of frozen food;

to do this, lift the shelf fowards, pull out half way and move down (or up).

Always insert trays with stop bar/raised edge at the back upwards, otherwise food may freeze onto the rear wall.

Remover door racks, Fig. A2

Lift the racks vertically upwards, remove from the front and reinsert at another height in the reverse order.

By pushing the bottle holder, Fig.

A2, you can secure bottles against tipping over when opening and closing

the door.The holder can be removed for cleaning: - fig. A2: The holder slides and

releases left or right along the door stops.

Fig. A4. If you need space for large bottles and containers, then simply

push half of glass shelf 1 back. For cleaning the holder 2 can be used to remove the half glass shelves.

Interior light

Light-bulb specifications: 25 W (never use a bulb rated at more than 25 W). The voltage should agree with the details on the type plate. Socket: E 14.

Replacing the bulb:

Pull out the mains plug or remove/unscrew the fuse.

Push the sides 1 of the lamp cover together according to Fig. F1, unlatch and detach 2.

Replace the light bulb according to Fig. F2. When inserting the new bulb, make sure the seal is correctly positioned in the socket.

Attach the cover at the rear again and lock into place on

sides.

Setting the temperature

Turn the temperature control 1 to set the desired temperature. The display of the set temperature in display 3 changes in ac­ cordance with the temperature setting 3.

When storing pre-frozen food in the freezer compartment, we recommend a temperature setting of between 5 °C and 3 °C, in order to achieve temperatures of -18°C or lower inside the compartment.

Note:The temperature shown on the display is not the current

temperature inside the appliance but the set temperature.

Loading...
+ 4 hidden pages