RADIO WITH ALARM
РАДИОПРИЁМНИК С БУДИЛЬНИКОМ
TF-1589B
Instruction manual
Руководство по эксплуатации
Instruction manual
Dear customer!
Thank you for purchasing our product. For safety, it is strongly recommended to read this manual carefully before connecting, operating and/or adjusting the product and keep the manual for reference in future.
Description
Light
MODE
Indicators
Buttons
MODE
Battery |
|
Touch |
compartment |
|
buttons |
|
|
USB (5V) |
|
FM antenna |
adapter |
|
socket and |
|
|
|
|
|
|
AUX input |
2
Instruction manual
Important safeguards
•The instruction manual contains important operating and maintenance instructions. For your safety, it is necessary to refer to the manual. Keep the manual for future use.
•Do not hit or drop the unit
•Do not expose the unit to vibration, direct sunlight, too high or low temperatures or humidity.
•Do not disassemble the unit yourselves Refer servicing to qualified service personnel
All the illustrations in this manual are schematic images, which may differ from actual objects.
Power supply
Battery operation
• Insert 3 ААA batteries (not included) to the terminals inside the battery
compartment according to the polarity marks (+ and -). Your set will have a limited operation from the battery supply, but there is now the advantage that, in case of a mains current failure or power outage, your clock will continue to work. The clock display will not light up, the clock time and alarm setting will be held in the clock memory by the battery back-up system.
This enables you to move the set from place to place without re-setting the clock every time. The battery back-up system is only meant to be used for short-term power failures. For longer durations the batteries may become exhausted or there may be some deviation in accuracy.
• When the batteries are exhausted, they should be removed from the set to prevent leakage. If you do not wish to take advantage of the battery back-up system, your set will work normally without batteries. However, if disconnected from the mains, the clock figures will flash when the mains are reconnected and you must re-set the clock.
DС operation
•The appliance is for household use only.
•Before the first connecting of the appliance
check that the voltage indicated on the rating label corresponds to the mains voltage in your location.
• Plug the supplied AC/DC power
adaptor into the DC adaptor input on the back of the unit. Connect the power cord to the AC household main outlet. Make sure the voltage is compatible.
• Always remember to disconnect
the power cord from the main supply before disconnecting it from the unit.
General operations
Placement
• Place the device close to you, approximately 40-50 cm from your head, for example, on a bedside table.
Setting time
•You have to set the clock time when you plug in the appliance for the first time and when there has been a power failure.
•When the time starts to blink touch
to adjust it. Touch to confirm. Setting will be canceled if no button is pressed in 10 seconds.
• Change current time by pressing and holding for 3 seconds until the time starts to blink. Touch to adjust it. Touch to confirm. Setting will be canceled if no button is pressed in 10 seconds.
•Choose between a 12-hour and 24-hour modes by pressing . When the 12-hour format is selected, AM or PM will be displayed.
•Pressto adjust the brightness of
time display: Low - High - Off.
• When powered by batteries, time display will automatically disappear in 15 seconds. Press any button to resume the time display.
3
Instruction Manual
Setting the alarm
•Touch to switch the alarm on or off. The alarm symbolappears on the display when you switch on the alarm, and disappears when you switch it off.
•Touch and hold to set the alarm, the time indication will start to blink and you can adjust the alarm time by
pressing. Touch to confirm the alarm time. Setting will be canceled if no button is pressed within 5 seconds.
•Press , then pressto choose between 1 and 7 as a wake-up sound (1-6 are pre-set nature sounds, 7 is FM radio). If you choose from 1 to 6 as the alarm sound, a sample of that sound will play for 5 seconds, if you choose 7, your last listened FM radio station will be set
as the alarm signal. Press to confirm. Setting will be canceled if no button is pressed within 5 seconds.
•You can choose the wake-up sound
volume level between 00 and 15 (the
default is 10) by pressing up to 15, then back from 15 to 00.
Sunrise simulation wake-up light
• Powered by adaptor.
30 minutes before the alarm time, the sunrise simulation white light will be on from 1% to 100% intensity at alarm time to prepare our body for waking up and getting alert.
When the alarm time comes, the wake-
up sound will play for 2 minutes. |
|
During this time you can touch |
to |
enter the snooze mode, the wake-up |
|
sound will play again after 5 minutes and last for 2 minutes. Touch or press any button except to stop the sound and wake-up light. During the wake-up light period, you can switch off the wake-up light by touching and holding .
• Powered by batteries.
There is no light function.
At the alarm time, the wake-up sound will play for 2 minutes, you can touch to enter the snooze mode, the wake up sound will play again after 5 minutes and last for 2 minutes, and can be stopped by touching any button except .
• If the radio is playing when the alarm time comes, the default alarm
sound will play and the radio will stop. The radio will resume after the alarm sound is stopped.
Setting the sunset and sleep time
• Touch to switch the sunset simulation on or off. The sunset symbol appears on the display when switched on.
• Touch and hold to set the sunset time, the time indication starts to blink and you
can adjust the time by touching . Touch to confirm the sunset time. The setting will be canceled if no button is pressed in 5 seconds.
Sunset simulation sleep light
30 minutes before sunset time, the sunset simulation white light will be on at 100% intensity in any mode, and then it will gradually decrease intensity until completely turning off at sunset time. During the sunset period you can switch off the light by holding .
Radio
•Touch MODE to change modes between FM radio, Bluetooth and AUX.
•In FM radio mode touch and hold MODE to automatically scan and save available radio
stations. Touch to switch between stations.
•Adjust the volume from 00 to 15 by
pressing .
• To get a good radio signal, fully
unwind the antenna and move it around until you get the best reception.
Light
• Touch |
once to switch on white |
|
light and use it as a bedside lamp. You can |
|
|
adjust the light intensity by touching |
, |
|
there are 10 levels in total. |
|
•Touch again to enter into an automatic color changing mode and use it as
a mood light. Touch to select color from green, red, blue, purple, orange or indigo.
•Touch for a third time to switch
the light off.
4
Instruction manual
AUX
You can connect the audio output of an external device to this unit, to listen to the sound of that device through the speakers of this unit.
• To connect an external audio device, please use a standard audio cable with 3.5- mm-to-3.5 mm plugs (not included) to connect the headphone out or audio line-out of the external device to the AUX input socket.
• Select the AUX mode using the MODE button.
• Turn on the external device. You cannot control playback with the buttons of this unit except adjusting the volume.
Bluetooth wireless playback
• This unit can wirelessly playback audio from any device with Bluetooth A2DP function.
•The wireless range is approximately within 10 meters.
•Wireless audio streaming requires pairing of a Bluetooth device (e.g. smartphone).
Specifications
HOW TO PAIR YOUR DEVICE TO THIS UNIT:
•Make sure the Bluetooth function is switched on in your device (e.g. smartphone, tablet).
•Switch on the unit and press
MODE to select the Bluetooth mode.
•Once the Bluetooth pairing indicator begins flashing, you will find the unit listed in the Bluetooth connections list of your device (as TF-1589B).
•If asked for a passcode, enter “0000”
•The initial setup is required only once per device. To pair another device repeat the above steps.
Maintenance and care
Switch off the unit, unplug from the power supply. The outside of the appliance can be cleaned with a slightly damp cloth.
Accessories
Alarm clock |
1 pc |
AC/DC adaptor |
1 pc |
USB cable |
1 pc |
Instruction manual |
1 pc |
AC/DC adaptor |
Input: ~ 100-240 V; 50/60 Hz |
|
|
Output: 5 V, 1.5 A |
|
|
|
|
Nominal power consumption |
6.5 |
W |
Clock |
4.5 |
V (3 x 1.5V AAA batteries) |
Display |
0.55" (1.4 cm) LED |
|
|
|
|
Radio frequency |
FM: 87.5 - 108 MHz |
|
|
|
|
Unit dimensions |
170 x 110 x 170 mm |
|
Net weight |
~ 0.365 kg |
|
|
|
|
Specifications and functions are subject to change without notice. It is connected with continual improvement of the device.
MANUFACTURED AND DISTRIBUTED BY TECHNO ELECTRIC LIMITED, Legal address: 801 Luk Yu Building, 24 - 26 Stanley Street, Central, China
TELEFUNKEN and the TELEFUNKEN logo are trademarks of TELEFUNKEN Licenses
GmbH and are used under a trademark license.
5