Loading...
Vacuum Cleaner
user manual
Before operating this unit, please read the instructions carefully. |
English |
For indoor use only. |
|
imagine the possibilities
Thank you for purchasing a Samsung product.
To receive a more complete service, please register your product at
www.samsung.com/register
safety information
SAFETY INFORMATION
•Before operating the appliance, please read this manual thoroughly and
WARNING retain it for your reference.
•Because these following operating instructions cover various models,
WARNING the characteristics of your vacuum cleaner may differ slightly from those described in this manual.
CAUTION/WARNING SYMBOLS USED
Indicates that a danger of death or serious injury exists.
WARNING
Indicates that a risk of personal injury or material damage exists.
CAUTION
OTHER SYMBOLS USED
Represents something you must NOT do.
Represents something you must follow.
Indicates that you must disconnect the power plug from the socket.
2_ safety information
safety information
IMPORTANT SAFEGUARDS
1.Read all instructions carefully. Before switching on, make sure that the voltage of your electricity supply is the same as that indicated on the rating plate on the bottom of the cleaner.
2.WARNING: Do not use the vacuum cleaner when rug or floor is wet.
Do not use to suck up water.
3.Close supervision is necessary when any appliance is used by or near children. Do not allow the vacuum cleaner to be used as a toy. Do not allow the vacuum cleaner to run unattended at any time. Use the vacuum cleaner only for its intended use as described in these instructions.
4.Do not use the vacuum cleaner without a dust bin.
Empty the dust bin before it is full in order to maintain the best efficiency.
5.Slide to the Stop(or Min)position before inserting a plug into the electrical outlet.
6.Do not use the vacuum cleaner to pick up matches, live ashes or cigarette butts.
Keep the vacuum cleaner away from stoves and other heat sources. Heat can deform and discolour the plastic parts of the unit.
7.Avoid picking up hard, sharp objects with the vacuum cleaner as they may damage the cleaner parts. Do not stand on the hose assembly. Do not put weight on the hose.
Do not block the suction or the exhaust port.
8.Switch the vacuum cleaner off on the body of the machine before unplugging from the electrical outlet. Disconnect the plug from the electrical outlet before changing the dust bag or dust container. To avoid damage, please remove the plug by grasping the plug itself, not by pulling on the cord.
9.This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety.
10.Children should be supervised to ensure that they do not play with the appliance.
11.The plug must be removed from the socket outlet before cleaning or maintaining the appliance.
12.The use of an extension cord is not recommended.
13.If your vacuum cleaner is not operating correctly, switch off the power supply and consult an authorized service agent.
14.If the supply cord is damaged, it must be replaced by the manufacturer or its service agent or a similarly qualified person in order to avoid a hazard.
15.Don’t carry the vacuum cleaner by holding the hose. Use the handle on the vacuum cleaner set.
16.Unplug the cleaner when not in use. Turn off the power switch before unplugging.
safety information _3
contents
assembling the cleaner |
05 Assembling the Cleaner |
|
05 |
|
|
OpeRATING The CleANeR |
06 On/Off Switch |
|
06 |
06 |
Power cord |
07 |
Power control |
|
mAINTAIN TOOls ANd fIlTeR |
08 Using accessory |
|
08 |
09 |
Maintain floor tools |
10 |
Emptying the dust bin |
|
|
11 |
When to clean the dust pack |
|
12 |
Cleaning the dust pack |
|
13 |
Cleaning the motor protection filter |
|
13 |
Cleaning the outlet filter |
TROUbleshOOTING
14
4_ contents
assembling the cleaner
OPTION
OPTION
assem01 bling theanercl
•Please do not press the button of dust bin handle when carrying machine.
• For storage, park the floor nozzle.
assembling the cleaner _5
operating the cleaner
ON/OFF SWITch
1) BODY CONTROL TYPE |
2) ON/OFF TYPE |
|
|
|
|
|
|
|
• When removing the plug from the electrical outlet, grasp
CAUTION the plug, not the cord.
POWER cORD
6_ operating the cleaner
POWER-CONTROL
1)SLIDE CONTROL TYPE ONLY (OPTION)
•SLIDE TO THE STOP POSITION
Vacuum-cleaner switches off (stand by mode)
•SLIDE FORWARD TO MAX
Suction capacity increases smoothly up to maximum.
2)BODY-CONTROL TYPE / ON/OFF TYPE
- HOSE
To reduce suction for cleaning draperies, small rugs, and other light fabrics, pull the tap air until the hole is open.
- BODY (BODY-CONTROL TYPE ONLY)
MIN = For delicate surface e.g. net curtains. MAX = For hard floors and heavily soiled carpets.
operating02 theanercl
operating the cleaner _7
maintain tools and filter
USING AccESSORY
Pipe (Option)
•Adjust the length of the telescopic pipe by sliding the length control button located in the center of
the telescopic pipe back and forth.
• To check for blockages, separate the telescopic pipe and adjust to shorten. This allows for easier removal of waste clogging the tube.
Accessory (Option)
•Dusting brush for furniture. shelves, books, etc.
•Crevice tool for radiators, crevices, corners, between
cushions.
8_ maintain tools and filter
MAINTAIN FlOOR TOOlS
2-Step Brush (Option)
• Adjust the inlet lever according to the floor surface. • Remove waste matter |
|
|
completely if the inlet is |
|
blocked. |
Carpet Cleaning |
Floor Cleaning |
Pet Brush (Option)
For improved pick-up of pet hair and fibre on carpets.
Frequent vacuuming of hair or pet fur may cause a falling-off of the rotation due to matters tangled around the drum. In this case, clean the drum with care.
maintain03 too andls fi
ter
Blanket brush (Option)
Clogs on turbine keep brush from turning, thus need to be unclogged as follows. For picking up pet hair and fibre on upholstery and bed linen. 
Remove waste matter completely when inlet is blocked.
Turn the lock button to ‘UNLOCK’, and remove waste matter.
To reassemble, align the cover to the front of the main body and close. After closing the cover, ensure that the lock button is turned to the ‘LOCK’ position.
Turbine 
Brush
Use for bedclothes only. Be cautious not to damage brush during WARNING unclogging.
maintain tools and filter _9
maintain tools and filter
EMPTYING ThE DUST bIN
1 |
2 |
3 |
Once dust reaches the |
|
|
dust full mark, or sution is |
Take the dust bin out by |
|
noticeably reduced during |
|
|
cleaning, empty the dust bin. |
pressing the button. |
Separate the dust bin cover. |
4 |
5 |
6 |
|
Before use, push the dust |
|
bin into the main body of the |
|
vacuum cleaner until you hear |
Throw away dust into the bin. Close the dust bin cover. |
the “click” sound. |
- Empty into a plastic bag (recommended for asthma/allergy sufferers)
You may rinse the dust bin with cold water.
10_ maintain tools and filter
maintain tools and filter
WhEN TO clEAN ThE DUST PAcK
-If suction is noticeably reduced during cleaning, please check the dust pack as indicated below.
Turn the vacuum power to 'MAX'.
HANDLE CONTROL
If suction is noticeably reduced with the inlet floating 10cm above flat floor, clean it.
maintain03 too andls fi
ter
When suction is noticeably reduced continuously,
please cleaning the Dust Pack as shown in the following illustration.
maintain tools and filter _11
clEANING ThE DUST PAcK
1. Remove the dust bin and dust pack as shown.
2. Remove the sponge and filter from the dust pack.
3. Wash the sponge and the filter of the dust pack with water.
4.Let the sponge and filter dry in the shade for more than 12 hours.
5. Put the sponge and filter into the dust pack.
6. Put the assembled dust pack into the main body.
Make sure the filter is completely dry before putting it back into the vacuum cleaner. Allow 12 hours for it to dry.
12_ maintain tools and filter
maintain tools and filter
clEANING ThE MOTOR PROTEcTION FIlTER
Take out both the dust bin and the dust pack.
Remove the motor protection filter from the vacuum cleaner.
Shake and tap the dust from it and put back in machine.
clEANING ThE OUTlET FIlTER
OPTION - MICRO FILTER
maintain03 too andls fi
ter
Press the fixed frame part at the back of the main body to remove.
Remove and replace the blocked outlet filter.
Replacement filters are available at your local Samsung distributor.
OPTION |
maintain tools and filter _13
troubleshooting
PROBLEM |
SOLUTION |
|
Motor dows not start. |
• Check cable, pulg and socket. |
|
• Leave to cool. |
||
|
||
|
|
|
Suction force is gradually |
• Check for blockage and remove. |
|
decreasing. |
||
|
||
|
|
|
Cord does not rewind fully. |
• Pull the cord out 2-3m and push down the |
|
cord rewind button. |
||
|
||
|
|
|
Vacuum cleaner dows not pick up |
• Check hose and replace if required. |
|
dirt. |
||
|
||
|
|
|
|
• Please check filter and, if required, clean as |
|
Low or decreasing suction |
illustrated in the instructions. if filters are out |
|
|
of condition change them to new ones. |
|
|
|
|
Body overheating |
• Please check filters, If required clean as |
|
illustrated in the instruction. |
||
|
||
|
|
|
Static electicity discharge |
• Please decrease power suction. |
|
|
|
This Vacuum cleaner is approved the following.
EMC Directive : 2004/108/EEC
Low Voltage Directive : 2006/95/EC
14_ troubleshooting
memo
Loading...