C5150/C5200/C5400/C5400n
2nd Paper Tray
Installation Instructions
Oki 42158511 Second Paper Tray
Install the Tray
1.Unpack the tray and remove the shipping materials.
2.Turn off the printer and unplug the power cord.
3.Remove the interface cable.
4.Note the location of the pins (1), connector (2) and tray opening (3).
5.Lower the printer onto the auxiliary tray, aligning the printer with the tray and lowering the holes/plug in the bottom of the printer onto the pins/connector on the tray.
6.Reattach the interface cable.
7.Plug in the power cord and turn on the printer.
8.Print out the Menu Map.
|
ON LINE |
BACK |
ENTER |
MENU |
CANCEL |
a.Press + one or more times until
INFORMATION MENU appears on the display.
b.Press ENTER twice.
The MenuMap prints.
9.Look for TRAY2 in the information at the top of the first page of the MenuMap and under the MEDIA MENU listing. If it isn’t there, check to be sure that the connection between the printer and Tray 2 is secure, then reprint and recheck the MenuMap.
10.Check the MEDIA MENU settings shown on the MenuMap and make any needed changes for
•TRAY2 PAPERSIZE
•TRAY2 MEDIATYPE
•TRAY2 MEDIAWEIGHT
to match the print media you will normally use in Tray 2. (If you need help with this, see “How to Make Changes in the Menus” in your on-line User’s Guide, or refer to “Changing Default Media Weight Settings” in your Handy Reference Guide.)
Load Paper
1. Pull out the tray.
2. Fan the paper
3.Position the paper guides in the tray.
4.Load paper (up to 530 sheets, 20-lb. US Bond), keeping the stack below the full line (1).
5. Push the tray back into the printer.
(continued on back)
© 2004 Oki Data Americas, Inc. |
58368501 |