Installation and Assembly:
ADVANCED PROJECTOR CEILING MOUNT WITH PRECISION GEAR
Model: ELPMBPRG, ELPMBPRG-B
ENG Compatible with: ELPMBC01 ELPMBP01 ELPMBP02 ELPMBP03
Max UL Load Capacity:
50 lb (22.7 kg)
Manufactured by Peerless Industries, Inc.
2300 White Oak Circle • Aurora, Il 60502 • (800) 865-2112 • Fax: (800) 359-6500 • www.peerless-av.com
ISSUED: 04-01-08 SHEET #: 055-9254-19 02-28-14
NOTE: Read entire instruction sheet before you start installation and assembly.
WARNING
•Do not begin to install your Peerless product until you have read and understood the instructions and warnings contained in this Installation Sheet. If you have any questions regarding any of the instructions or warnings, call Peerless customer care at 1-800-865-2112.
•This product should only be installed by someone of good mechanical aptitude, has experience with basic building construction, and fully understands these instructions.
•Make sure that the supporting surface will safely support the combined load of the equipment and all attached hardware and components.
•Never exceed the Maximum UL Load Capacity.
•Always use an assistant or mechanical lifting equipment to safely lift and position equipment.
•Tighten screws firmly, but do not overtighten. Overtightening can damage the items, greatly reducing their holding power. See suggested torque values where applicable within these instructions.
•This product is intended for indoor use only. Use of this product outdoors could lead to product failure and personal injury.
Tools Needed for Assembly
•stud finder ("edge to edge" stud finder is recommended)
•phillips screwdriver
•drill
•5/16" bit for concrete surface
•5/32" bit for wood joist
•3/8" (10 mm) socket wrench
Table of Contents |
|
Parts List................................................................................................................................................................................. |
3 |
Installation to Extension Column............................................................................................................................................. |
4 |
Installation To Wood Joist Ceilings.......................................................................................................................................... |
5 |
Installation to Concrete Ceilings.............................................................................................................................................. |
6 |
Installing Plates to Projector ................................................................................................................................................... |
7 |
Installing Connection Block to Projector Mount Assembly...................................................................................................... |
9 |
Cable Management.............................................................................................................................................................. |
10 |
Projector Alignment............................................................................................................................................................... |
11 |
Accessories and Warranty Information................................................................................................................................ |
12 |
2 of 11 |
ISSUED: 04-01-08 SHEET #: 055-9254-19 02-28-14 |
Visit the Peerless Web Site at www.peerless-av.com |
For Technical Support Contact Peerless Mounts at 1-800-865-2112 |
Before you start check the parts list to ensure all of the parts shown are included.
|
|
|
|
|
Parts List |
|
ELPMBPRG |
ELPMBPRG-B |
|
|
Description |
Qty |
Part # |
Part # |
A |
projector mount assembly |
1 |
580-2300 |
580-1300 |
B |
adapter plate |
1 |
056-2065 |
056-1065 |
C |
dedicated adapter plate |
1 |
055-2871 |
055-1871 |
D |
M4 x 20 mm socket pin serrated washer head screw |
4 |
510-2163 |
510-1061 |
E |
#10-32 x 3/8" socket pin serrated washer head screw |
2 |
520-2151 |
520-1151 |
F |
3/8" spacer |
4 |
590-2150 |
590-1150 |
G |
M4 x 6 mm socket pin serrated washer head screw |
6 |
510-2059 |
510-1059 |
H |
concrete anchor |
2 |
590-0320 |
590-0320 |
I |
10-32 x 1/4" socket pin screw with lock |
1 |
520-2196 |
520-1196 |
J |
4 mm security allen wrench |
1 |
560-9646 |
560-9646 |
K |
washer |
2 |
540-2078 |
540-1078 |
L |
#14 x 2.5" wood screw |
2 |
5S1-015-C04 |
5S1-015-C03 |
M |
2 mm security allen wrench |
1 |
560-1097 |
560-1097 |
N |
#10 flat washer |
4 |
540-9442 |
540-9400 |
NOTE: Actual parts may appear slightly different than illustrated.
A B C
D E F G H I
L
J K M N
3 of 11 |
ISSUED: 04-01-08 SHEET #: 055-9254-19 02-28-14 |
Visit the Peerless Web Site at www.peerless-av.com |
For Technical Support Contact Peerless Mounts at 1-800-865-2112 |
Installation to Extension Column
1 |
NOTE: Refer to accompanying instructions for ELPMBP01, ELPMBP02, ELPMBP03 or CMJ and ACC Series |
Ceiling Mounts (sold separately) for installing these models to ceiling. |
Screw projector mount assembly (A) onto extension column as shown in figure 1.1.
Use 4 mm allen wrench (J) to tighten swivel stop screw.
NOTE: Swivel stop screw is used to jam against threads of extension column or flush mount tube to prevent any excess movement of projector mount assembly (A) as shown in detail 1. Do not overtighten screw; overtightening screw will damage threads making it difficult to separate products.
Skip to step 2.
Not Shown: UL Listed ELPMBP01, ELPMBP02, ELPMBP03 or UL
Listed CMJ and ACC Series Ceiling Mounts (Sold Separately).
SWIVEL STOP
EXTENSION COLUMN SCREW
(UL Listed ELPMBC01 or UL Listed
EXT and ADJ Series)
(Sold Separately)
A
A
fig. 1.1 |
DETAIL 1 |
|
4 of 11 |
ISSUED: 04-01-08 SHEET #: 055-9254-19 02-28-14 |
Visit the Peerless Web Site at www.peerless-av.com |
For Technical Support Contact Peerless Mounts at 1-800-865-2112 |