Installation Manual
Benchmark SERIES
HMVP053U
Table of Contents |
|
Safety Definitions .......................................................... |
2 |
IMPORTANT SAFETY INSTRUCTIONS ........................ |
3 |
Appliance Handling Safety ................................................. |
3 |
Safety Codes and Standards ............................................. |
3 |
Electric Safety ....................................................................... |
3 |
Microwave Safety ................................................................. |
3 |
Related Equipment Safety .................................................. |
4 |
State of California Proposition 65 Warnings ................... |
4 |
Checklist for Installation ............................................... |
5 |
Before you begin ........................................................... |
5 |
Removing Packaging .......................................................... |
5 |
Tools and parts needed ...................................................... |
5 |
Parts included ....................................................................... |
6 |
Location requirements ......................................................... |
6 |
Power Requirements ........................................................... |
7 |
Electrical Installation ..................................................... |
7 |
Install Appliance ............................................................ |
8 |
Removing the mounting plate ........................................... |
8 |
Finding the wall studs ......................................................... |
8 |
Possible wall stud configurations ..................................... |
8 |
Attaching the mounting plate to the wall ......................... |
9 |
Adapting microwave blower .............................................. |
9 |
Preparing cabinet .............................................................. |
11 |
Mounting the microwave oven ....................................... |
11 |
Hood exhaust ..................................................................... |
12 |
Testing Operation ....................................................... |
14 |
Bosch® Support ........................................................... |
14 |
Before Calling Service ..................................................... |
14 |
Data Plate ........................................................................... |
14 |
Service ................................................................................ |
14 |
Parts and Accessories ..................................................... |
14 |
4XHVWLRQV"
ZZZ ERVFK KRPH FRP
0DLQ 6WUHHW 6XLWH ,UYLQH &$
:H ORRN IRUZDUG WR KHDULQJ IURP \RX
Safety Definitions
This indicates that death or serious injuries may occur as a result of non-observance of this warning.
This indicates that minor or moderate injuries may occur as a result of non-observance of this warning.
Note: This alerts you to important information and/or tips.
2
INSTALLER: LEAVE THESE INSTRUCTIONS WITH THE APPLIANCE AFTER INSTALLATION IS COMPLETE.
IMPORTANT: SAVE THESE INSTRUCTIONS FOR THE LOCAL ELECTRICAL INSPECTOR'S USE.
If the information in this manual is not followed exactly, fire or shock may result causing property damage or personal injury.
Do not repair, replace or remove any part of the appliance unless specifically recommended in the manuals. Improper installation, service or maintenance can cause injury or property damage. Refer to this manual for guidance. All other servicing should be done by an authorized servicer.
CAN/CSA C22.2 No. 61 - Household Cooking Ranges
UL 858 - Household Electric Ranges
CAN/CSA C22.2 No. 150 - Microwave Ovens
UL 923 - Microwave Cooking Appliances
UL 507 - Electric Fans
CAN/CSA C22.2 No. 113 - Fans and Ventilators
CSA C22.2 No. 64 - Household Cooking and LiquidHeating Appliances
UL 1026 - Electric Household Cooking and Food Serving Appliances
Before you plug in an electrical cord or turn on power supply, make sure all controls are in the OFF position.
For appliances equipped with a cord and plug, do not cut or remove the ground prong. It must be plugged into a matching grounding type receptacle to avoid electrical shock. If there is any doubt as to whether the wall receptacle is properly grounded, the customer should have it checked by a qualified electrician.
Do not operate or allow the oven to be operated with the door open.
Make the following safety checks on all ovens to be serviced before activating the magnetron or other microwave source, and make repairs as necessary:
Before turning on microwave power for any service test or inspection within the microwave generating compartments, check the magnetron, wave guide or transmission line, and cavity for proper alignment, integrity, and connection.
Any damaged or misadjusted components in the interlock, monitor, door seal, and microwave generation and transmission systems shall be repaired, replaced, or adjusted by procedures described in this manual before the oven is released to the owner.
A microwave leakage check to verify compliance with the Federal Performance Standard should be performed on each oven prior to release to the owner.
3
9 IMPORTANT SAFETY INSTRUCTIONS
READ AND SAVE THESE INSTRUCTIONS
Improper grounding can result in a risk of electric shock. Consult a qualified electrician if the grounding instructions are not completely understood, or if doubt exists as to whether the appliance is properly grounded. Do not use an extension cord. If the power supply cord is too short, have a qualified electrician install an outlet near the appliance.
To reduce the risk of fire, use only metal ductwork.
For general ventilating use only. Do not use to exhaust hazardous or explosive materials and vapors.
Do not operate gas cooktop burners without pots in place. The open flame may overheat the microwave oven above.
State of California Proposition 65
Warnings:
This product can expose you to chemicals including vinyl chloride, which is known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to
www.P65Warnings.ca.gov.
4
1.Before installing the appliance, be sure to verify the cabinet dimensions are correct for your appliance and that the required electrical connections are present. Make sure the electrical cord provided on the appliance is able to reach to the point of connection.
Sections: Location requirements, Electrical installation
Section: Removing Packaging
Section: Removing Packaging
Section: Install Appliance - Removing the mounting plate
Section: Install Appliance - Finding the wall studs
Section: Install Appliance - Attaching the mounting plate to the wall
Section: Install Appliance - Adapting the microwave blower
Section: Install Appliance - Preparing cabinet
Section: Install Appliance - Mounting the microwave oven
Section: Install Appliance - Mounting the microwave oven
Section: Install Appliance - Hood exhaust
Section: Testing operation
Before you begin
Philips head screwdriver
Pencil
Ruler or tape measure and straight edge
Drill
Drill bits: 3/16”, 1/2”, 5/8”
Gloves
Saw (saber, hole or keyhole)
Stud finder or hammer
Safety goggles
Level
Duct and masking tape
Carpenter square
Tin snips (to cut damper)
Scissors (to cut cabinet template)
Filler blocks or scrap wood pieces (for recessed bottom cabinet installations)
5
Parts included |
|
|
Location requirements |
|
|
|
Installation dimensions |
|
|
|
*URXQGHG 9 RXWOHW ORFDWHG |
|
|
|
LQVLGH WKH FDELQHW DERYH WKH RYHQ |
|
|
|
ULJKW VLGH VKRZQ DV H[DPSOH |
$ |
% |
& |
' |
)
(
*
ATop mounting bolts:
Self-aligning machine screws ]" - 28x3]"
BToggle bolts - 3/16"x3"
CWall mounting hardware: Toggle wings
DWood screws ]"x2"
ENylon grommet (for metal cabinets)
FExhaust adaptor
GMounting plate (attached to the back of the microwave oven)
Top cabinet template
Rear wall template
Aluminum grease filters
Charcoal filter (factory fitted in the microwave oven)
PLQ PP
PD[ PP
PLQ ê
PP
PLQ PP
FDELQHW
RSHQLQJ
ZLGWK
PLQ PP
PLQ
PP
)RU RSWLPDO SHUIRUPDQFH DQG
UHOLDELOLW\ WKH PDQXIDFWXUHU UHFRPPHQGV ² FOHDUDQFH DOWKRXJK WKH PLQLPXP DOORZDEOH FOHDUDQFH LV QRWHG
6
ê
PP |
ê |
PP
ʎ¼ʚ |
ʎ¼ʚ |
|
PP |
||
PP |
||
|
Note: Take into account that the front and rear measurements of the appliance are not identical.
The outlet must be properly grounded in accordance with all applicable codes.
It can be installed anywhere inside the cabinet above the appliance, within reach of the power cord (approx. 24 in).
Model |
Connection |
Circuit |
|
|
Requirements |
|
|
|
HMVP053U |
NEMA 5-15 |
120 V, 15 Amps |
|
|
60 Hz |
|
|
|
a three prong grounded outlet
120 V, 60 Hz, AC only
15 Amp electrical supply with a fuse or a circuit breaker
This product must be connected to a supply circuit of the proper voltage and frequency. Wire size must conform to the requirements of the National Electric Code or the prevailing local code for this rating. The power supply cord and plug should be brought to a separate 20-amp branch circuit single grounded outlet. The outlet box should be located in the area behind the appliance (see section Cabinet Dimensions). The outlet box and supply circuit should be installed by a qualified electrician and conform to the National Electrical Code or the prevailing local code.
The voltage used must be the same as specified on this microwave oven. Using a higher voltage is dangerous and may result in a fire or oven damage. Using a lower voltage will cause slow cooking. The manufacturer is not responsible for any damages resulting from the use of the oven with any voltage other than specified.
7
Note: To avoid possible damage to the work surface or to the bottom of the appliance, cover the work surface.
The mounting plate will be used as the rear wall template and for mounting.
Note: To avoid damage to the microwave oven, do not grip or use the door or door handle while the microwave oven is being handled.
Note: The microwave must be connected to at least one wall stud. If no wall studs exist within the cabinet opening, do not install the microwave oven.
-a stud finder or
-a hammer (tapping lightly across the mounting surface to find a solid sound).
Note: Care must be taken when drilling holes. Electrical wires may be concealed behind the wall covering and contact with them could result in electrical shock.
8
Wear gloves to avoid cutting fingers on sharp edges.
Note: Make sure the cabinet bottom is level.
3/16” (5 mm) holes for wood screws (stud)
5/8” (16 mm) holes for toggle bolts (no stud)
Note: If neither A nor B is in a stud, find a stud somewhere in the area of the mounting plate and drill a 3/16” (5 mm) hole.
It is important to use at least one wood screw mounted firmly in a stud to support the weight of the microwave.
If exhaust adaptor is positioned outside consider recommended dimensions, otherwise greaseladen air will discharge into house structure.
This microwave is shipped assembled for Room Venting Installation. The blower unit is already in place and must not to be adapted.
9
Do not pull or stretch the blower unit wiring. Make sure the wires are not pinched, and that they are properly secured.
Do not pull or stretch the blower unit wiring. Make sure the wires are not pinched, and that they are properly secured.
10