HMT5750
HMB50..
HMT57.., HMT50..
Table of Contents
Questions?
1-800-944-2904
www.boschappliances.com
We look forward to hearing from you!
This Bosch Appliance is made by
BSH Home Appliances Corporation
5551 McFadden Ave.
Huntington Beach, CA 92649
Safety . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .1
Important Safety Instructions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1
Installation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .2
Before you Begin . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2
Trim Kits . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2
Combination with Wall Ovens . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .2
Tools and Parts Needed . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3
Parts Included . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3
Power Requirements . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4
Cabinet Cutout Dimensions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .4
Outlet Area . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4
Installation Procedure . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5
Prepare the Appliance . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5
Prepare Cabinet Cutout . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6
Connect to Electricity and Install the Appliance . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8
Service . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .10
Before Calling Service . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 10
Data Plate . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 10
Safety
Important Safety
m
Instructions
It is the responsibility of the owner and the installer to
determine if additional requirements and/or standards
apply to specific installations.
ELECTRIC SAFETY
m
m
READ AND SAVE THESE
INSTRUCTIONS
WARNING:
When properly cared for, your new appliance
has been designed to be safe and reliable.
Read all instructions carefully before use.
These precautions will reduce the risk of
burns, electric shock, fire and injury to
persons. When using kitchen appliances,
basic safety precautions must be followed,
including those in the following pages.
WARNING:
Do not repair or replace any part of the
appliance unless specifically recommended
in the manuals. Improper installation, service
or maintenance can cause injury or property
damage. Refer to this manual for guidance.
All other servicing should be done by a
qualified technician.
Before you plug in an electrical cord, be sure all controls
are in the OFF position.
Do not plug the microwave into the wall until after the
installation is complete. This is to prevent accidentally
turning the microwave on during the installation.
For appliances equipped with a cord and plug, do not cut or
remove the ground prong. It must be plugged into a
matching grounding type receptacle to avoid electrical
shock. If there is any doubt as to whether the wall
receptacle is properly grounded, the customer should have
it checked by a qualified electrician.
If required by the National Electrical Code (or Canadian
Electrical Code), this appliance must be installed on a
separate branch circuit.
Installer - show the owner the location of the circuit breaker
or fuse. Mark it for easy reference.
Be sure your appliance is properly installed and grounded
by a qualified technician. Installation, electrical connections
and grounding must comply with all applicable codes.
APPLIANCE HANDLING SAFETY
Hidden surfaces may have sharp edges. Use caution when
reaching behind or under appliance.
SAFETY CODES AND STANDARDS
This appliance complies with one or more of the following
Standards:
UL 858, The Standard for the Safety of Household
Electric Ranges
UL 923, The Standard for the Safety of Microwave
Cooking Appliances
UL 507, The Standard for the Safety of Electric Fans
ANSI Z21.1, The American National Standard for
Household Cooking Gas Appliances
CAN/CSA-C22.2 No. 113-M1984 Fans and Ventilators
CAN/CSA-C22.2 No. 61-M89 Household Cooking
Ranges
RELATED EQUIPMENT SAFETY
Remove all tape and packaging before using the appliance.
Destroy the packaging after unpacking the appliance.
Never allow children to play with packaging material.
Never modify or alter the construction of the appliance. For
example, do not remove leveling legs, panels, wire covers
or anti-tip brackets/screws.
MICROWAVE SAFETY
PRECAUTIONS TO BE OBSERVED BEFORE AND
DURING SERVICING TO AVOID POSSIBLE EXPOSURE
TO EXCESSIVE MICROWAVE ENERGY
(a) Do not operate or allow the oven to be operated with the
door open.
(b) Make the following safety checks on all ovens to be
serviced before activating the magnetron or other
microwave source, and make repairs as necessary:
English 1
(1) interlock operation,
(2) proper door closing,
(3) seal and sealing surfaces (arcing, wear, and other
damage),
(4) damage to or loosening of hinges and latches,
(5) evidence of dropping or abuse.
(c) Before turning on microwave power for any service test
or inspection within the microwave generating
compartments, check the magnetron, wave guide or
transmission line, and cavity for proper alignment, integrity,
and connection.
(d) Any defective or misadjusted components in the
interlock, monitor, door seal, and microwave generation
and transmission systems shall be repaired, replaced, or
adjusted by procedures described in this manual before the
oven is released to the owner.
(e) A microwave leakage check to verify compliance with
the Federal Performance Standard should be performed on
each oven prior to release to the owner.
GROUNDING INSTRUCTIONS
This appliance must be grounded. In the event of an
electrical short circuit, grounding reduces the risk of electric
shock by providing an escape wire for the electric current.
This appliance is equipped with a cord having a grounding
wire with a grounding plug. The plug must be plugged into
an outlet that is properly installed and grounded.
WARNING:
Improper use of the grounding can result in a risk of electric
shock.
Consult a qualified electrician or serviceman if the
grounding instructions are not completely understood, or if
doubt exists as to whether the appliance is properly
grounded, and:
• Do not use an extension cord. If the power supply cord
is too short, have a qualified electrician or serviceman
install an outlet near the appliance.
Installation
Before you Begin
Trim Kits
CAUTION:
m
• Trim kits are designed for use only with
the Bosch microwave oven models listed
in Table 1.
• For safety, do not alter or modify any part
of this kit or oven.
• Unit is heavy and requires at least two
people to lift or move.
Trim Kits
30” Cabinet HMT5050 HMB5050
HMT5060 HMB5060
HMT5020 HMB5020
27” Cabinet HMT5750 HMB5050
HMT5760 HMB5060
HMT5720 HMB5020
Table 1: Trim kits for microwave ovens
Microwave
Ovens
Combination with Wall Ovens
Your microwave oven can be installed into a cabinet or wall
by itself or above any of the following Bosch wall ovens:
HBN33, HBN34, HBN54, HBN75, HBL 33, HBL34, HBL54,
HBL85.
English 2
m
WARNING:
To reduce the risk of fire and electric shock,
install microwave at least 3/4” above
designated oven.
Tools and Parts Needed
Measuring tape
Phillips head screwdriver
Torx T-20 Screwdriver
Parts Included
AB
F
H
C
Drill with bits (1/16”)
Pliers
D
G
E
I
Parts Included
A Philips head screws (8)
B Torx head screws (4)
C Adhesive tape
D Faceplate Fixing Brackets (2)
E Torx head bolts (4)
J
Parts Included
F Base Supports (2)
G Air Ducts (2)
H Cabinet Fixing Brackets (2)
IFaceplate
J Baseplate
English 3
Power Requirements
min 21"
(533 mm)
25 7/16"
(646 mm)
min 36 1/16"
(916 mm)
19 7/8"
(504 mm)
27” Appliances
30” Appliances
27” Appliances 30” Appliances
Electrical specifications: 120V, 18A, 60Hz.
Cabinet Cutout Dimensions
The outlet must be properly grounded in accordance with
all applicable codes. It can be installed in the backwall
directly behind the oven.
28 7/16"
(722 mm)
19 7/8"
(504 mm)
min 36 1/16"
(916 mm)
min 21"
(533 mm)
Outlet Area
The outlet can be located anywhere within the shaded
area.
6 1/2"
5 1/2"
(140 mm)
(165 mm)
(140 mm)
4"
(102 mm)
5 1/2"
8"
(203 mm)
4"
(102 mm)
English 4
Installation Procedure
Prepare the Appliance
Using pliers, rotate as you pull out to remove the plastic
microwave feet. Prepare the appliance according to
Figures 1 to 6.
Figure 1
Figure 3
Figure 2
Figure 4
English 5
Prepare Cabinet Cutout
Figure 5
Figure 6
Prepare cabinet cutout according to Figures 7 to 9.
Figure 7
NOTE:
Fold up baseplate tabs to approximately 95 degrees.
English 6
Figure 8
a=b
dia. 1/16"
a
b
English 7
Figure 9
dia. 1/16"
NOTE:
A block of wood may need to be added behind the cabinet
front, flush with the cabinet opening, to secure the bracket.
Connect to Electricity and Install the
Appliance
NOTE:
Two people may be needed for this installation.
Insert plug into three-prong, grounded outlet according to
Figure 8. See “Power Requirements” on page 4 for
electrical specifications.
Figure 10
Slide the unit back so that the base supports fit over the
baseplate tabs and align with the slots in the rear of the
baseplate. Fit the appliance according to Figures 11 to 14.
Figure 11
English 8
Figure 12
Figure 13
Figure 14
NOTE:
Do NOT clean decorative trim with abrasive cleaners.
English 9
Service
Data Plate
Before Calling Service
Please be prepared with the information printed on the data
plate before calling service.
Data Plate
Keep your invoice or escrow papers for warranty validation
if service is needed.
English 10
Loading...