tosetupyour.Extender UnfoldthisQuickStartGuideandfollowtheinstructionsinside
Let’sgetstarted-setupyourExtender
Router/Modem
reachareaswithweak.signals Ethernetcabling,usetheExtenderwirelesslytoincreaseyournetworkto .WirelessIfyourrouter/modemhasWi-Fiandyouprefernottouse
Cable
Router/ModemEthernet
.cable ConnectyourWirelessExtendertoyourrouter/modemusinganEthernet ifitdoes,useEthernetcablingtoachievethebestperforming.network Wired.(recommended)Ifyourrouter/modemdoesnothaveWi-Fioreven
HowwillyouuseyourExtender?
CAUTION
Environment:
•The Wireless Extender needs air flow to keep cool. Do not block or cover the ventilation holes of the Wireless Extender.
Leave a gap of at least 10cm above and around the Wireless Extender to allow for adequate ventilation.
•Do not operate your Wireless Extender in an unventilated cabinet or on top of another unit that emits heat, such as a TV or media player.
•Do not store the Wireless Extender in hot, damp, dusty, or unusually cold locations.
•The Wireless Extender is intended for indoor use and installation only.
Handling:
•Do not put anything on or over your Wireless Extender which might drip or spill on it.
•Never place an open flame, such as from a lit candle, near the Wireless Extender’s ventilation holes.
Storage:
•Store your Wireless Extender in a cool, dry place. Before installation and use, let the wireless extender reach room temperature.
Industry Canada Statement
This device complies with ISED’s licence-exempt RSSs. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Le présent appareil est conforme aux CNR d’ ISED applicables aux appareils radio exempts de licence. L’exploitation est autorisée aux deux conditions suivantes : (1) le dispositif ne doit pas produire de brouillage préjudiciable, et (2) ce dispositif doit accepter tout brouillage reçu, y compris un brouillage susceptible de provoquer un fonctionnement indésirable.
Caution :
(i) the device for operation in the band 5150-5250 MHz is only for indoor use to reduce the potential for harmful interference to co-channel mobile satellite systems;
(iv) where applicable, antenna type(s), antenna models(s), and worst-case tilt angle(s) necessary to remain compliant with the e.i.r.p. elevation mask requirement set forth in section 6.2.2.3 shall be clearly indicated.
Avertissement:
Le guide d’utilisation des dispositifs pour réseaux locaux doit inclure des instructions précises sur les restrictions susmentionnées, notamment:
(i) les dispositifs fonctionnant dans la bande 5150-5250 MHz sont réservés uniquement pour une utilisation à l’intérieur afin de réduire les risques de brouillage préjudiciable aux systèmes de satellites mobiles utilisant les mêmes canaux;
(iv) lorsqu’il y a lieu, les types d’antennes (s’il y en a plusieurs), les numéros de modèle de l’antenne et les pires angles d’inclinaison nécessaires pour rester conforme à l’exigence de la p.i.r.e. applicable au masque d’élévation, énoncée à la section 6.2.2.3, doivent être clairement indiqués
Radiation Exposure Statement:
This equipment complies with ISED radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with greater than 27cm between the radiator & your body.
Déclaration d’exposition aux radiations:
Cet équipement est conforme aux limites d’exposition aux rayonnements ISED établies pour un environnement non contrôlé. Cet équipement doit être installé et utilisé à plus de 27cm entre le radiateur et votre corps.
Federal Communication Commission Interference Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one of the following measures:
•Reorient or relocate the receiving antenna.
•Increase the separation between the equipment and receiver.
•Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
•Consult the dealer or an experienced radio/TV technician for help.
FCC Caution: Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate this equipment. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. Operations in the 5.15-5.25GHz band are restricted to indoor usage only. This device meets all the other requirements specified in Part 15E, Section 15.407 of the FCC Rules.
Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 25cm between the radiator & your body.
FOR COUNTRY CODE SELECTION USAGE (WLAN DEVICES)
The country code selection is for non-US model only and is not available to all US model. Per FCC regulation, all Wi-Fi products marketed in the US must be fixed to US operation channels only.
solidred |
Extendertoofarfromrouter/gateway |
|
|
solidyellow |
Extenderfarfromrouter/gateway |
Wireless |
|
solidgreen |
Extenderatgoodposition |
|
|
fastblinkinggreen;10seconds |
WPSpairingsuccessful |
|
|
fastblinkingred;10seconds |
WPSpairingunsuccessful |
WPS |
|
blinkingyellow |
WPSprocessongoing |
|
|
solidred |
Slownetworkspeed |
|
|
solidyellow |
Limitednetworkspeed |
Wired |
|
solidgreen |
Fastnetworkspeed |
|
|
slowblinkinggreen |
Up;notconnectedtonetwork |
Power |
|
fastblinkinggreen |
Startingup |
||
|
|||
LEDColor |
|
State |
|
|
|
|
|
|
.troubleshooting |
||
mayberelatedtosetuporWPSoperations,orusefulforCustomerSupport |
|||
ThisisnotafulltableofallsystemLED.descriptionsOtherLEDsettings |
|||
HowtoreadyourwirelessExtenderLEDs |
|||
Port |
Socket |
Button |
LED |
Ethernet |
Power |
WPS |
Status |
|
|
Switch |
|
|
|
On/Off |
|
PartsoftheWirelessExtender
VAP4641 Wireless Extender
Quick Start
Guide
610349-002-B 03/2019
Loading...