Instruction Manual
Thank you for purchasing the PlayStation® (PS one®) video game console.
You can enjoy playing PlayStation® format CDROM discs with both the PlayStation® logo and [PAL] designation, and audio CDs with this unit.
Before using the unit, please read this instruction manual and retain it for future reference.
SCPH-102 A
3-066-615-12(1)
Connector section
1/u (on/standby)/RESET button and 1/u indicator
Disc cover
§ (open) button
MEMORY CARD slots
Controller ports
L2 button, R2 button,
L1 button, R1 button
Directional buttons
¢ button, ® button,button, π button
START button
ANALOG mode button
SELECT button
© 2000 Sony Computer Entertainment Inc. All rights reserved.
Left analog stick, right analog stick, L3 button, R3 button
2 WARNING
To prevent fire or shock hazard, do not expose the unit to rain or moisture.
To prevent fire or shock hazard, do not place a container filled with liquids on top of the console.
To avoid electrical shock, do not open the cabinet. Refer servicing to qualified personnel only.
Caution
The use of optical instruments with this product will increase eye hazard.
Read before operating your PS one® console
A few people may experience epileptic seizures when viewing flashing lights or patterns in our daily environment. These persons may experience seizures while watching TV pictures or playing video games. Even players who have never had any seizures may nonetheless have an undetected epileptic condition.
Consult your doctor before playing video games if you have an epileptic condition or should you
experience any of the following symptoms during play: altered vision, muscle twitching, other involuntary movements, loss of awareness of your surroundings, mental confusion, and/or convulsions.
Use the supplied AC adaptor only. If you use other types, it may cause fire, electrical shocks or a malfunction.
This appliance is classified as a CLASS 1 LASER product. The CLASS 1 LASER PRODUCT MARKING is located on the bottom of the PS one® console.
Precautions
Your PS one® console is not disconnected from the AC power source (mains) as long as it is connected to the wall outlet, even if the unit itself has been turned off.
About the nameplate
The nameplate is located on the bottom of the PS one® console.
Notice
If this unit is affected by static electricity or burst-noise, it may not work correctly.
USING THE PS one® CONSOLE IN A MOVING VEHICLE COULD DISTRACT THE DRIVER. IT IS DANGEROUS AND MAY BE ILLEGAL TO USE A SCREEN WHICH IS NOT SECURELY MOUNTED OR IS WITHIN THE DRIVER’S VIEW OR WHERE THE DRIVER CAN SEE REFLECTIONS OF IT. DO NOT USE THE PS one® CONSOLE IN THE FRONT SEAT OF A MOVING VEHICLE.
If the PS one® console is used in a moving vehicle, the user should ask the driver’s permission and follow the driver’s instructions. Many games include loud or sudden noises that can be distracting, and it may be necessary to operate at a reduced volume, with the volume turned off or by using headphones. If used loose in a moving vehicle the PS one® console, like any loose object, could cause injury to the user, the driver and other passengers in accidents or as a result of sudden braking. It is unsafe to leave children unaccompanied in a car, whether playing with the PS one® console or not.
PLEASE KEEP THIS WARNING AVAILABLE FOR REFERENCE.
2WARNING
3Unpacking
4Precautions
5Connecting your PS one® console to a TV set
6Playing a game
8Using the Analog Controller (DUALSHOCK®)
10 Using the Memory Card
12 Playing an audio CD
15 Enjoying SoundScope
17 Troubleshooting
20GUARANTEE
21Specifications
|
Unpacking |
3 |
|
|
|
|
|
|
Check that you have the following items:
• PS one® console |
• Analog Controller |
|
(DUALSHOCK®) |
• AV Cable |
• AC Adaptor |
(integrated audio/video) |
|
On safety
•The laser beam emitted from the lens of your PS one® console is harmful to the eyes. Do not attempt to disassemble the casing. Servicing should be carried out by qualified personnel only.
•Should any solid objects or liquid fall into your PS one® console, unplug it immediately and have it checked by qualified personnel before any further use.
•Disconnect your PS one® console from the mains if you do not intend to use it for any length of time. When doing this, grasp the adaptor and pull it from the wall socket. Never pull the cord itself.
For your health
•Be sure to take a break of about 15 minutes during every hour of play.
•Do not play a game when you are very tired or short of sleep.
•Play in a well lit room, sitting as far from the screen as the cord will allow.
On operation
•Operate your PS one® console only on 220 - 240 V AC, 50/60 Hz.
•Do not cover your PS one® console during use as heat may build up internally.
•Avoid rough handling or knocks and do not put any heavy objects on your PS one® console. This could damage the console or the disc.
•Do not leave your PS one® console near heat sources, or in a place subject to direct sunlight (operating
temperature: 5˚C - 35˚C), excessive dust or sand, moisture, liquid, on an uneven surface, or in a car with its windows closed.
•If your PS one® console causes interference to radio or television receptions, turn it off or move it away from the radio or television.
•Do not touch the lens inside the disc cover. To protect the lens from dust, keep the disc cover closed except when inserting or removing a disc. If the lens is not clean, your PS one® console may not operate properly.
•The SCPH-1040 Link Cable cannot be used with this unit.
•The method for resetting the
PS one® console is different to that for the PlayStation® console
(SCPH-1002 A, SCPH-5502 A, SCPH-5552 A, SCPH-7002 A, SCPH-7502 A, SCPH-9002 A). For more information, see “Restarting a game” on page 7.
•Avoid prolonged physical contact with the PS one® console or AC adaptor. This may cause low temperature burns.
About the discs
•You can use two kinds of discs with your PS one® console : CD-ROM discs with both PlayStation® logo and [PAL] designation, and audio CD discs.
•Some discs sold in foreign countries cannot be used with this unit.
On handling discs
•Do not leave the discs near heat sources or in direct sunlight or excessive moisture.
•Store the discs in their cases when they’re not in use.
•When handling the discs, do not touch the surface. Hold them by the edge.
•Do not stick paper or tape on the discs.
•Do not write on the discs with a marker, etc.
On condensation
If your PS one® console is brought directly from a cold to a warm location, or is placed in a very damp room, moisture may condense on the lens inside. Should this occur, your PS one® console may not operate properly. In this case, remove the disc for several hours until the moisture evaporates. If your PS one® console still does not operate properly, call the appropriate PlayStation® customer service helpline which can be found:
–on the customer registration card;
–within every PlayStation® format software manual.
Do not connect your PS one® console to a projection TV
Do not connect your PS one® console to a projection TV. Permanent damage may result unless it has an LCD screen.
Never analyse, examine or remodel your PS one® console
Use your PS one® console according to this instruction manual. Sony Computer Entertainment Inc. expressly prohibits the analysis or remodelling of the PS one® console, and also prohibits the analysis, use of its circuit configurations without express written permission of Sony Computer Entertainment Inc.
Connecting your PS one® console to a TV set |
|
5 |
|
|
|
IMPORTANT INFORMATION
For the customers in Australia and New Zealand
A small number of television sets or monitors may display a bouncing or other incorrect screen effect when connected to the PS one® console. Any applicable warranties offered by Sony Computer Entertainment Europe may be limited or disclaimed in such particular cases. Should you experience any difficulties with your PS one® console, please contact the appropriate PlayStation® customer service helpline which can be found:
– on the customer registration card;
– within every PlayStation® format software manual.
Connecting to a TV with audio/video inputs
Connect your PS one® console to the TV using the supplied AV cable (integrated audio/video), making sure you match the colours on the plugs and terminals.
If your TV is monaural, do not connect the red plug. If you want to hear both left and right sounds from a monaural TV, use a commercially available dual-phono to single-phono (stereo to monaural) type audio cable.
After connecting
Set your TV to the appropriate video input mode. (Refer to the instruction manual of your TV.)
6 |
|
Playing a game |
||
|
|
|
|
|
|
|
|
|
|
When you close the disc cover, push here firmly until it clicks.
1 |
2 |
3 |
1 Press § (open) button.
The disc cover opens.
2Insert a disc in the disc holder with the label side up.
3Close the disc cover.
When you close the disc cover, close it firmly until it clicks.
4 Press 1/u (on/standby)/RESET button.
The 1/u (on/standby) indicator lights up.
After the start-up screen, screen 1 appears and the game begins.
Set the supplied Analog Controller (DUALSHOCK®) to the appropriate mode for the software (see page 8).
Tips
•When you end a game, press § button, remove a disc and press 1/u/RESET button to turn off the PS one® console.
•If you turn on your PS one® console without first inserting a disc, screen 2 appears. It gives you access to the audio CD control screen and the Memory Cards activity screen, described later on in this instruction manual. If you insert a CD-ROM disc of the PlayStation® format while screen 2 is on, the game will start automatically.
•If the screen 3 appears, the inserted disc might be of a different format. Check if it has both the PlayStation® logo and [PAL] designation on it. A damaged or dirty disc would also produce this screen.
See ”Troubleshooting“ on page 17.
Notes
•When inserting a disc, push the disc gently but firmly until it sits snugly on the central spindle.
MWARNING
Before removing a disc, press the § button and make sure that the disc completely stops. Never touch the disc while it is spinning. Otherwise, you may hurt yourself or damage the disc or your PS one® console.
7
ARestarting a game |
CScreens that appear after |
1/u/RESET button |
start-up screen |
|
|
|
When you turn on your PS one® console, one of the following screens will |
|
appear: |
1 A CD-ROM with both PlayStation® logo and [PAL] designation is
inserted.
Press 1/u (on/standby)/RESET button twice.
Be careful not to accidentally press 1/u/RESET button twice while playing the game, or the game will end.
BRemoving a disc
2 No disc is inserted.
When you close the disc cover, push here firmly until it clicks.
§ button
Press § (open) button.
While pressing the central spindle gently, pick up the disc holding it by the edge.
When you close the disc cover, close it firmly until it clicks.
3 A disc that cannot be played with the PS one® console is inserted.
8 |
|
Using the Analog Controller (DUALSHOCK®) |
||
|
|
|
|
|
|
|
|
|
|
AMode switching and mode indicator
ANALOG mode button
Mode indicator
This Analog Controller (DUALSHOCK®) can be switched between two modes by pressing the ANALOG mode button.
Each time the ANALOG mode button is pressed, the mode changes as follows:
|
Digital mode (indicator: off) |
|
µ |
|
Analog mode (indicator: red) |
Note |
|
After checking the “ |
” icons on the software, switch to the |
appropriate mode for use.
Note however, that some software makes this adjustment automatically. In such cases, the ANALOG mode button is overridden by the software. For details, refer to the software manual.
BDigital mode (indicator: off)
You can use this Analog Controller (DUALSHOCK®) in the same manner as the SCPH-1080 E Controller.
START button
R2 button
SELECT button
R1 button
L2 button
¢button
L1 button
® button
Directional
buttons
button
ANALOG mode button
π button
Mode indicator: off