SECTION 1. CHEMICIAL PRODUCT AND COMPANY NAME
Safety Data Sheet
Lithium-Ion Rechargeable Battery Pack
BL1830
Complies with the OSHA Hazard
Communication Standard :
29 CFR 1910 1200
Makita U.S.A., Inc. |
|
|
Prepared By : |
Stan Rodrigues |
14930-C Northam Street |
|
|
|
|
La Mirada, CA 90638 |
|
|
Date Revised: |
10/16/2014 |
EMERGENCY CONTACT INFORMATION |
|
|||
Telephone Number for Information: |
MAKITA: 1-510-657-9881 |
|
||
Emergency Response |
|
|
|
|
For Chemical Emergency
Spills, Leak, Fire, Exposure, or Accident
Call CHEMTREC Day or Night
Within USA and Canada 1-800-424-9300
SECTION 2. HAZARD IDENTIFICATION
Class Name: Not applicable for regulated class
Hazard: It may cause heat generation or electrolyte leakage if battery terminals contact with other metals. Electrolyte is flammable. In case of electrolyte leakage, move the battery from fire immediately.
Toxicity: Vapor generated from burning batteries, may make eyes, skin and throat irritate.
SECTION 3. COMPOSITION, INFORMATION OR INGREDIENTS
IMPORTANT NOTE:
The battery pack uses ten lithium ion rechargeable cell and control circuit on the PWB. The cells are connected in 2 parallel strings of 5 cells in series.
The battery pack should not be opened or burned since the following ingredients contained within the cell that could be harmful under some circumstance if exposed or misused.
The cell contains neither metallic lithium nor lithium alloy.
Cathode: |
Lithium Nickel Cobalt Manganese Oxides (active material) |
||
|
Polyvinylidene Fluoride |
(binder) |
|
|
Graphite |
(conductive material) |
|
Anode: |
Graphite |
(active material) |
|
|
Polyvinylidene Fluoride |
(binder) |
|
Electrolyte: |
Organic |
Solvent |
(non-aqueous liquid) |
|
Lithium |
Salt |
|
Component Proportion: Li:1.5%,Ni:5.6%,Co:2.2%,Mn:5.9%, C:I 0.5%, Cu:19.6, Fe:16.6%, Others: 38.1% |
|||
Others: |
Heavy metals such as Mercury, Cadmium, Lead, and Chromium are not used in the cell. |
||
Enclosure: |
Plastic |
(PC) |
|
UN number: |
UN3480 |
|
|
Watt-hour rating: 54Wh for battery pack
1
CONTINUED: SECTION 3. COMPOSITION, INFORMATION OR INGREDIENTS
Common chemical name I General name |
CAS N u m b e r |
Concentration I Concentration R ange |
Lithium Manganese Oxides (active material) |
12057-17-9 |
3~6% |
Lithium Nickel Cobalt Manganese Oxides (active material) |
182442-95-1 |
16~20% |
Polyvinylidene Fluoride (binder) |
24937-79-9 |
0.1~1% |
Carbon black(conductive material) |
1333-86-4 |
0.1~1% |
Graphite(active material) |
7782-42-5 |
10~14% |
Organic Solvent (non-aqueous liquid) |
- |
9~13% |
Others |
- |
40~60% |
SECTION 4. FIRST AID MEASURE
The product contains organic electrolyte. In case of electrolyte leakage form the battery, actions described below are required.
Eye Contact: |
Flush the eyes with plenty of clean water for at least 15 minutes immediately, without rubbing, and call a doctor. If |
|
appropriate procedures are not taken; this may cause an eye irritation. |
Skin Contact: |
Wash the contact areas off immediately with plenty of water and soap. If appropriate procedures are not taken, |
|
this may cause sores on the skin. |
Inhalation: |
Remove to fresh air immediately, and call a doctor. |
SECTION 5. FIRE FIGHTING MEASURES
•Use specified extinguishers (gas, foam, powder) and extinguishing system under the Fire Defense Law.
•Since corrosive gas may be produced at the time of fire extinguishing, use an air inhalator when danger is predicted.
•Use a large amount of water as a supportive measure in order to get cooling effect if needed. (Indoor/outdoor fire hydrant)
•Carry away flammable materials immediately in case of fire.
•Move batteries to a safer place immediately in case of fire.
SECTION 6. ACCIDENTAL RELEASE MEASURES
•Wipe off with dry cloth
•Keep away from fire
•Wear safety goggles, safety gloves as needed
SECTION 7. HANDLING AND STORAGE
Storage: Store within the recommended limit of -30°C to 45°C (-22°F to ll3°F), well-ventilated area. Do not expose to high temperature (60°C/140°F). Since short circuit can cause bum hazard or safety vent to open, do not store with metal jewelry, metal covered tables, or metal belt.
Handling: Do not disassemble, alter, or solder. Do not short + and - terminals with metal. Do not open the battery pack.
Charging: Charge within the limits of 0°C to 40°C (32°F to l04°F) temperature. Charge with specified charger designed for this battery pack
Discharging: Discharge within the limits of -20°C to 60°C (-4 °F to 140°F) temperature.
Disposal: Dispose in accordance with applicable federal, state and local regulations.
2
Loading...