2-Speed Hammer Drill
8419B-2
DOUBLE
INSULATION
SPECIFICATIONS
Model |
8419B-2 |
Capacities |
|
Wood................................................................................................................................... |
High: 18 mm (3/4”) |
|
Low: 30 mm (1-1/8”) |
Steel ................................................................................................................................... |
High: 6.5 mm (1/4”) |
|
Low: 13 mm (1/2”) |
Concrete............................................................................................................................ |
High: 14 mm (9/16”) |
|
Low: 19 mm (3/4”) |
No load speed (RPM) ....................................................................................................................... |
High: 2,300 |
|
Low: 900 |
Blows per minute ............................................................................................................................. |
High: 46,000 |
|
Low: 18,000 |
Overall length ........................................................................................................................... |
350 mm (13-3/4”) |
Net weight ....................................................................................................................................... |
3 kg (6,6 lbs) |
|
|
•Due to our continuing programme of research and development, the specifications herein are subject to change without notice.
•Note: Specifications may differ from country to country.
Power supply
The tool should be connected only to a power supply of the same voltage as indicated on the nameplate, and can only be operated on single-phase AC supply. They are double-insulated in accordance with European Standard and can, therefore, also be used from sockets without earth wire.
For European countries only
Noise and Vibration
The typical A-weighted noise levels are sound pressure level: 99 dB (A) sound power level: 112 dB (A)
– Wear ear protection. –
The typical weighted root mean square acceleration value is 8 m/s2.
EC-DECLARATION OF CONFORMITY
The undersigned, Yasuhiko Kanzaki, authorized by Makita Corporation, 3-11-8 Sumiyoshi-Cho, Anjo, Aichi, 446 Japan declares that this product
(Serial No. : series production) manufactured by Makita Corporation in Japan is in compliance with the following standards or standardized documents,
HD400, EN50144, EN55014, EN61000* in accordance with Council Directives, 73/23/EEC, 89/336/EEC and 98/37/EC.
*from 1st Jan. 2001
Symbols
The followings show the symbols used for the tool. Be sure that you understand their meaning before use.
Read instruction manual.
Wear safety glasses.
Only for EU countries
Do not dispose of electric equipment together with household waste material!
In observance of European Directive 2002/ 96/EC on waste electrical and electronic equipment and its implementation in accordance with national law, electric equipment that have reached the end of their life must be collected separately and returned to an environmentally compatible recycling facility.
Yasuhiko Kanzaki CE 94
Director
MAKITA INTERNATIONAL EUROPE LTD.
Michigan Drive, Tongwell, Milton Keynes,
Bucks MK15 8JD, ENGLAND
2
1 |
2 |
|
|
|
|
|
|
|
3 |
4 |
|
|
|
|
|
|
|
5 |
6 |
|
|
|
|
|
|
|
7 |
8 |
3